全文获取类型
收费全文 | 11445篇 |
免费 | 1401篇 |
国内免费 | 1271篇 |
专业分类
化学 | 3823篇 |
晶体学 | 118篇 |
力学 | 1247篇 |
综合类 | 166篇 |
数学 | 2936篇 |
物理学 | 5827篇 |
出版年
2024年 | 20篇 |
2023年 | 113篇 |
2022年 | 163篇 |
2021年 | 245篇 |
2020年 | 231篇 |
2019年 | 276篇 |
2018年 | 249篇 |
2017年 | 375篇 |
2016年 | 436篇 |
2015年 | 376篇 |
2014年 | 598篇 |
2013年 | 868篇 |
2012年 | 608篇 |
2011年 | 745篇 |
2010年 | 634篇 |
2009年 | 724篇 |
2008年 | 744篇 |
2007年 | 770篇 |
2006年 | 626篇 |
2005年 | 634篇 |
2004年 | 559篇 |
2003年 | 481篇 |
2002年 | 469篇 |
2001年 | 345篇 |
2000年 | 337篇 |
1999年 | 292篇 |
1998年 | 268篇 |
1997年 | 240篇 |
1996年 | 185篇 |
1995年 | 161篇 |
1994年 | 160篇 |
1993年 | 136篇 |
1992年 | 106篇 |
1991年 | 99篇 |
1990年 | 84篇 |
1989年 | 79篇 |
1988年 | 61篇 |
1987年 | 49篇 |
1986年 | 46篇 |
1985年 | 70篇 |
1984年 | 48篇 |
1983年 | 22篇 |
1982年 | 68篇 |
1981年 | 66篇 |
1980年 | 53篇 |
1979年 | 33篇 |
1978年 | 30篇 |
1977年 | 29篇 |
1976年 | 41篇 |
1973年 | 18篇 |
排序方式: 共有10000条查询结果,搜索用时 31 毫秒
11.
聚山梨酯80又名吐温80,为一种亲水型非离子表面活性剂,是食品、保健品和药品中常用的辅料,作为增溶剂和澄清剂广泛用于中药注射剂。近年来,不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视,有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用,有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点,可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定,也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异,难以采用统一的转换公式或对照品准确定量。此外,中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题,以生脉注射液为例,提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间,在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%1 cm)为104.23,相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后,精密量取供试品溶液1.0 mL,精密加入硫氰酸钴溶液10 mL,二氯甲烷20 mL,涡旋振荡3 min。将混合液移至分液漏斗中,静置30 min,取下层二氯甲烷液,将前1 mL弃去,接收约15 mL,在320 nm处测定吸光度,再根据Lambert-Beer定律,利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰,精密度和重复性相对标准偏差均低于3%,平均回收率为98.42%。为进一步验证方法的准确性,分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液,并与实际投料量比较。配对t检验结果表明,当置信度为95%时,两种方法无显著性差异,吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长,显著降低了基质干扰,克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品,亦不用制备标准曲线,可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便,为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。 相似文献
12.
阐明了引入溶剂渗透因子的必要性,较详细地介绍了两种渗透因子及它们间的关系。 相似文献
13.
Pulse radiolysis with kinetic spectroscopic detection was applied to study the kinetics of the first steps of radiation induced polymerization of cyclohexyl acrylate and cyclohexyl methacrylate in cyclohexane solvent. The reactions were initiated by cyclohexyl radicals produced in the radiolysis of the solvent. The transient absorption spectra of the -carboxyalkyl type radicals produced in addition reaction show maxima around 300 nm. This shifts to longer wavelength with time after the pulse. This phenomenon was explained by the oligomerization reaction. From the kinetic curves average rate coefficients of termination for the oligomer radicals (2kt) were determined as a function of time elapsed after the electron pulse. The values obtained were compared with those calculated for other (acrylate and methacrylate type) monomers. 相似文献
14.
电路过渡过程所列方程是微分方程,本文中采用的是方框图模型分析法,即将微分方程的复杂示解分解成最基本的加(减)、乘(除)、积分(微分)、增益等运算,采用VB设计用户界面产进行计算,并给出了一算例。 相似文献
15.
D. J. Plazek C. A. Bero S. Neumeister G. Floudas G. Fytas K. L. Ngai 《Colloid and polymer science》1994,272(11):1430-1438
By making creep and recoverable creep measurements of a nearly monodisperse low molecular weight poly(methyl phenyl siloxane) sample, we have found on decreasing temperature towardsT
g that there is continuously a change in the viscoelastic spectrum concomitant with a decrease of the steadystate recoverable compliance. This behavior is exactly the same as previously observed in low molecular weight poly(styrene), proving that this spectacular anomaly in the viscoelasticity of low molecular weight polymers is general and deserves an explanation. Photon correlation spectroscopic measurements performed on the same sample have extended the observation of the viscoelastic response to shorter times and the result corroborates the trend of variation established by the creep data.Dedicated to Prof.Dr. E. W. Fischer on his 65th Birthday. Prof.Dr. Fischer is known for his valuable contribution to fosterine, international collaboration of research in polymer science. This work is an example of his contribution because it would not be possible without him bringing us together. One of us (KLN) would like to take this opportunity to thank Prof. Dr. Fischer for his unwaiving support of the 1st (Crete) and the 2nd (Alicante) International Discussion Meeting on Relaxations in Complex Systems 相似文献
16.
本文利用统计计量学方法对山西省农民家庭消费水平和消费结构的变化及原因进行了实证分析。建立了山西省农民人均消费的消费函数和山西省农民总消费支出与食品、衣着、住房、日用品、燃料及文化生活服务支出的关系模型,并通过模型分析解释了农民的消费结构,也为决策者提供一些有效的参考资料。 相似文献
17.
18.
根据生产任务选择加工设备进行制造资源重组是实现可重构制造系统的关键问题之一,由于设备的选择涉及到多种因素,既有定量指标,又有定性指标,传统的依靠人工经验的方法显得力不从心。本文首先结合实际情况,提出了一套设备选择评价体系,通过对模糊判断矩阵采用最小对数二乘法确定各评价因素的权重系数,针对定性指标和定量指标采用不同的方法确定其性能指标值,通过模糊积分对评判指标进行综合评判,最后进行了实例研究。所提出的方法有效地简化了决策过程,为可重构制造系统设备选择提供了一套行之有效的方法。 相似文献
19.
一类机器人系统的最优控制 总被引:1,自引:1,他引:0
王辉 《数学的实践与认识》2002,32(3):455-459
本文通过把结构阻尼系数当作控制变量来讨论一类弹性机器人系统的最优控制问题 ,并利用Banach空间几何性质证明了最优控制元的存在唯一性 相似文献
20.
浅析二阶齐次线性变系数微分方程的一个可积类型 总被引:1,自引:0,他引:1
姬志飞 《应用数学与计算数学学报》2006,20(1):125-128
本文讨论了二阶齐次线性变系数微分方程的特殊形式,给出了这种微分方程的一个可积类型. 相似文献