在无机盐和阴离子表面活性剂存在下2-(5-溴-2-噻唑偶氮)-5-二乙氨基苯甲酸与镍显色反应的研究

本文合成了新显色剂2-(5-溴-2-噻唑偶氮)-5-二乙氨基苯甲酸(简称5-Br-TAEB),利用光度法测定了试剂的三级质子化常数,研究了它与镍显色反应的最佳条件,同时对表面活性剂及无机盐的作用机理进行了初步探讨。实验结果表明,在NaCl和NaDS存在下,pH=5.0～8.0范围内,5-Br-TAEB与镍形成稳定的蓝色络合物,络合比为Ni~(2+):5-Br-TAEB=1:2,摩尔吸光系数ε_(642)=1.23×10~5 SL·mol~(-1)·cm~(-1)。镍浓度在0～10μg/25ml范围内服从比尔定律,方法用于铝合金中镍的测定,结果满意。     

Enrichment of surfactant from its aqueous solution using ultrasonic atomization

Dilute aqueous solutions of dodecyl-benzenesulfonic acid sodium salt (DBS-Na) and polyoxyethylenenonylphenyl ethers (PONPEs) were ultrasonically atomized. The surfactants were concentrated in collected mist droplets. The enrichment ratio increased with decreasing surfactant concentration. Depending on the surfactant’s molecular weight and affinity to water, different enrichment ratio was observed in the range of low feed concentrations. For anionic surfactant, DBS-Na, the enrichment ratio was significantly improved by KCl addition and a peak appeared on the plot of the ratio against KCl concentration. Addition of NaCl or CaCl₂ · 2H₂O to the surfactant solution also enhanced the enrichment ratio; however, the effect was relatively small. Such behaviors of the ratio were interpreted as enhanced interfacial adsorption of the surfactant and a lack of supply of surfactant monomers from liquid bulk because of slow breaking of surfactant micelles. Time required for collecting an amount of mist was also observed. Among the three salt systems, the time for KCl system was twice as long as others. This fact suggested that the formation of smaller droplets in KCl system.     

ON THE MECHANISM OF “HYDROPHOBIC” INTERACTIONS

It is shown that the interfacial attraction between low-energy bodies immersed in aqueous media, known as “hydrophobic” interaction, can be quantitatively accounted for by, mainly, the hydrogen-bonding energy of cohesion of water, plus, to a very minor extent, a van der Waals-Lifshitz attraction between the Immersed law-energy bodies.     

Surface activity and thermodynamic of micellization and adsorption for isooctylphenol ethoxylates, phosphate esters and their mixtures with N-diethoxylated perfluorooctanamide

Three nonionic surfactants; p-isooctylphenol ethoxylates p-[i-OPE10], p-[i-OPE15], and p-[i-OPE20], were phosphorylated to produce three anionic phosphate ester surfactants. In addition, N-diethoxylated perfluorooctanamide (N-DEFOA) was also prepared. The surface and thermodynamic properties of the three types of surfactants and mixtures of the fluorocarbon surfactant (FC) with the hydrocarbon surfactants (HC) have been investigated. Surface tension as a function of concentration of the surfactant in aqueous solution was measured at 30, 40, 50 and 60°C, using the spinning drop technique. From these measurements the critical micelle concentration (CMC), the surface tension at the CMC (γ_CMC), the maximum surface excess concentration (Γ_max), the minimum area per molecule at the aqueous solution/air interface (A_min), and the effectiveness of surface tension reduction (π_CMC), were calculated. The thermodynamic parameters of micellization (ΔG_mic, ΔH_mic, ΔS_mic) and of adsorption (ΔG_ad, ΔH_ad, ΔS_ad) for these surfactants and their mixtures were also calculated. Structural effects on micellization, adsorption and effectiveness of surface tension reduction are discussed in terms of these parameters. The results show that the FC surfactant and its mixtures with HC surfactants enhance the efficiency in surface tension reduction and adsorption in the mixed monolayer at the aqueous solution/air interface, and also, reduce γ_CMC and the tendency towards micellization.     

Wettability of model fountain solutions: The influence on topo-chemical and -physical properties of offset paper

The surface chemical and physical character of offset paper was studied before and after application of model fountain solutions based on isopropyl alcohol and an alcohol-free surfactant solution. The paper surface features were characterised with atomic force microscopy and the surface energies were determined by contact angle measurements. Changes in the surface chemical properties induced by the fountain solutions were investigated with X-ray photoelectron spectroscopy and time-of-flight secondary ion mass spectroscopy. Coated papers wetted with the surfactant solution revealed a slight increase in the root mean square roughness, but the isopropyl alcohol solution led to no observable changes. The change in sub-micro roughness is ascribed not only to substrate swelling or migration of coating constituents but also to the presence of surfactant on the surface. A change in the surface energy and particularly the polar contribution was observed after application of the surfactant solution. The X-ray photoelectron spectroscopy showed an increase in the oxygen-to-carbon ratio, which confirms the presence of surfactant on the surface. Time-of-flight secondary ion mass spectroscopy showed that the isopropyl alcohol solution did not change the elemental composition of the surface whereas the surfactant solution clearly did so. The distribution of surfactant on the surface was confirmed by mapping the characteristic fragments of the molecule.     

Co-adsorption of surfactants and propyl gallate on the hydrophilic oxide surfaces

Propyl gallate (PG) adsolubilisation in the cationic, anionic and nonionic surfactant micelles formed in the bulk solution and at the silica/solution interface has been investigated. It was found that in the absence of surfactant, propyl gallate does not adsorb on the silica surface from aqueous solution. However, in the presence of hexyltrimethylammonium bromide (CTAB), its uptake by silica significantly increases. Alumina is quite an effective adsorbent for SDS and propyl gallate and does not adsorb nonionic TX-100. The addition of PG promotes adsorption of SDS and TX-100.     

Surfactant effect on the conductivity behavior of CsH2PO4: Characterization by electrochemical impedance spectroscopy

Cesium dihydrogen phosphate (CDP) nanoparticles were synthesized using the surfactants cetyltrimethyl ammonium bromide (CTAB), polyoxyethylene-polyoxypropylene (F-68) and (F-68:CTAB) with molar ratio 0.06. The samples conductivity such as CDP_CTAB, CDP_F-68 and CDP_{(F-68:CTAB)0.06} was studied by impedance spectroscopy in the frequency range 0.01 Hz to 1 MHz. The Nyquist plots were drawn at different temperatures of 210, 230 and 260 °C, which are defined below transition, phase transition and above transition, respectively. The measured conductivities obey the Arrhenius relation. The influence of surfactants on conductivity are more significant at higher temperature due to grain boundary. The conductivity of CDP_CTAB increased slightly with increasing temperature to 260 °C, whereas the conductivity of other samples decreased with increasing temperature over 230 °C. The results indicated that the conductivities increase in the order of CDP_CTAB>CDP_{(F-68:CTAB)0.06}>CDP_F-68. These are in accordance to the ion exchange capacities of the samples that the surfactant shows a direct influence on the samples proton mobility. It is found that the conductivity of CsH₂PO₄ is influenced by surfactant type.     

Binding of a surfactant counterion to low-charge-density poly(acrylic acid) and poly(methacrylic acid)

The binding of a cationic surfactant, dodecylpyridinium (C12Py) chloride, with a low-charge-density poly (methacrylic acid) (PMA) was investigated in buffer solutions under the condition of constant pH. The binding isotherms with PMA consisted of two and three steps at a pH lower and higher than 3.2, respectively. Bindings in the first step were independent of pH and this step was considered to correspond to the solubilization of the hydrocarbon chains of C12Py into the nonpolar region of the compact form of PMA. This is the indication of the compact form from the binding isotherm. At pH higher than 3.2, the second step was discriminated and it depended on the pH. In the third step, a sharp rise in the degree of binding (β) was observed accompanying the solubilization of the precipitates of the PMA–C12Py complex. The binding with poly(acrylic acid) (PAA) and PMA in conventional unbuffered NaCl solutions was also examined and the pH profile of the solution during the binding process was determined. In the case of unbuffered NaCl solutions, the binding with PAA took place cooperatively at the critical association concentration (cac). The binding isotherm consisted of two steps and the pH decreased with the increase in β. The binding isotherm of PMA, on the other hand, consisted of three steps: the pH decreased slightly in the first step and considerably in the second step with the increase in β but it increased with β in the third step, exhibiting a pH minimum around 3.2. The binding in the first step coincided with that obtained in the buffered solutions. Linear relationships between β and the pH were found for both polymers. In the case of PMA, no cac was observed in both buffered and unbuffered NaCl solutions. Received: 24 January 2001 Accepted: 23 May 2001     

Enantioselective epoxidations of alkenes catalyzed by (salen)Mn(III) in aqueous surfactant systems

An aqueous reaction medium, based on a surfactant solution of diethyltetradecylamine N-oxide (AOE-14), was developed for the enantioselective epoxidation of 1,2-dihydronaphthalene and of various cis-β-alkyl styrenes with increasing hydrophobicity, using bleach as oxidant and the Jacobsen chiral (salen)Mn(III) as catalyst. AOE-14 is able to both solubilize all reactants in water and bind the metal of the salen complex acting as coligand. Its use leads to good yields (>75%) and to ee values ranging from 75% up to 91% even in the case of cis-β-alkyl styrenes where lower cis/trans epoxide ratios are observed. The ratio of surfactant/substrate used is 1:1 or 4:1, much lower than those generally used in the literature.     

Flow patterns and heat transfer in vertical upward air–water flow with surfactant

Flow patterns, the pressure drag reduction and the heat transfer in a vertical upward air–water flow with the surfactant having negligible environmental impact were studied experimentally in a tube of 2.5 cm in diameter. Visual observations showed that gas bubbles in the air–water solution with surfactant are smaller in size but much larger in number than in pure air–water mixture, at the all flow regimes. The transition lines in the flow regime map for the solution of air–water mixture with surfactant of the 300 ppm concentration are mainly consistent with the experimental data obtained in clear air–water mixture. An additive of surfactant to two-phase flow reduces the total pressure drop and decrease heat transfer, especially in the churn flow regime.