二维位置灵敏探测器输出图像畸变的修正

高分辨(e,2e)谱仪采用二维位置灵敏探测器同时对能量和角度进行多道测量.二维位置灵敏探测器由级联使用的微通道板和电阻阳极板组成,由于电阻阳极板的边缘效应和制造工艺的缺陷,测量得到的位置图像与实际图像总会有一定的形变,存在一定的非线性.本文针对高分辨(e,2e)谱仪二维位置灵敏探测器输出图像的“桶形”畸变及位置非线性,采用一种简易的冷刻法(用脉冲信号来模拟真实电子束团),检验了二维位置灵敏探测器的Gear型电阻阳极板的线性好坏,并用分割成小三角形的方法找出测量得到的畸变图像与原始真实图像的映射关系,再用此关系对其它测量得到的畸变图像进行修正,并对修正的结果进行了评估.通过修正,由“桶形”畸变所造成的图像扭曲得到明显改善.修正后的x方向非线性由修正前的2.1%变为0.59%.这种检验和修正方法对其它领域类似探测器输出图像的修正也有一定的指导意义.     

980 nm激发下Er3+/Yb3+共掺杂ZrO2-Al2O3粉末的上转换发光特性

通过固相反应法制备了Er3+/Yb3+共掺杂ZrO2-Al2O3粉末的样品,并对样品在980nm激光激发下的上转换发光特性进行了研究.从发射光谱可以发现,在可见光范围内有3个强的发光带,一个位于654nm附近的红光带和两个分别位于545nm、525nm附近的绿光带,分别对应于Er3+离子的以下辐射跃迁:4F9/2→4I15/2、4S3/2→4I15/2、2H11/2→4I15/2.其中又以Er3+离子的4F9/2→4I15/2跃迁产生的红色荧光辐射最强.对其上转换发光机制进行了分析,发现这三个发光过程都是双光子过程.对样品粉末进行了XRD检测,发现ZrO2主要以立方相为主,并且计算得到了这种立方结构的晶格常数.Al2O3固溶于ZrO2中,Al3+嵌入ZrO2后产生氧空位,导致ZrO2晶体的对称性降低,这种结构变化更有利于提高上转换效率,即上转换发光强度增强.     

恒流应力下E2PROM隧道氧化层的退化特性研究

在电容测量的基础上研究了薄隧道氧化层在恒定Fowler-Nordheim(F-N)隧穿电流下的退化情况. 这种退化是恒流应力和时间的函数，对恒流应力大小的依赖性更加强烈，隧道氧化层在F-N电流下的退化是注入电荷密度(Q_inj)的函数. 在较低Q_inj下氧化层中发生正电荷俘获，在较高Q_inj下发生负电荷俘获，导致栅压变化的反复. 关键词： 2PROM')" href="#">E²PROM 隧道氧化层 退化 恒流应力     

The effects of doubly excited states on ionization balance

The effects of highly doubly excited states on ionization balance are investigated. In the calculation, A Collisional-Radiative model in Detailed-Configuration-Accounting (DCA) is applied to population calculations for NLTE plasmas. Configuration-averaged rate coefficients that needed in the rate equations are obtained based on the first order perturbation theory. The Hatree-Fock-Slater self-consistent-field method is used to calculate the electron wave functions. The mean ionization stage of high-Z plasma Lu is presented. The comparison shows that the mean ionization stage increases more than 3 stages when doubly excited states 5l6l' and 5l5l' are not included in the population calculations.     

B_2分子X~3Σ_g~-和A~3Σ_u~-态的势能函数

使用SAC/SAC-CI方法,利用D95(d),6-311g**以及cc-PVTZ等基组,对B2分子的基态(X3Σg-)和第一激发态(A3Σu-)的平衡结构和谐振频率进行了优化计算.通过对3个基组的计算结果的比较,得出了D95(d)基组为3个基组中的最优基组的结论;使用D95(d)基组,利用SAC的GSUM(Group Sum of Operators)方法对基态(X3Σg-),SAC-CI的GSUM方法对激发态(A3Σu-)进行单点能扫描计算,用正规方程组拟合Murrell-Sorbie函数,得到了相应电子态的完整势能函数;从得到的势能函数计算了与基态(X3Σg-)和第一激发态(A3Σu-)相对应的光谱常数(Be,αe,ωe和ωeχe),结果与实验数据吻合.     

Al-pillared clays supported rare earths and palladium catalysts for deep oxidation of low concentration of benzene

Al-pillared clays supported rare earths (RE/Al-PILC) are prepared and used as supports of palladium catalysts for deep oxidation of low concentrations of benzene (130-160 ppm). The supports and catalysts are characterized by X-ray powder diffraction (XRD), FT-IR, BET, transmission electron microscopy (TEM) and temperature-programmed reduction (H₂-TPR). The results show that Al-pillaring results in a strong increase in the basal spacing (d_0 0 1) from about 1.2 to 1.8 nm, and an increase in the BET surface area from 63.6 (±3.2) to 238.8 (±11.9) m²/g. Activity tests of deep oxidation of low concentration benzene show catalysts supported on Al-PILC and RE/Al-PILC are obviously more active than that on raw clay. Pd/6% Ce/Al-PILC, in particular, can catalyze the complete oxidation of low concentration benzene at a temperature as low as about 290 °C.     

New ligands for the Fe(III)‐mediated reverse atom transfer radical polymerization of methyl methacrylate

A series of (di)picolinic acids and their derivates are investigated as novel complexing tridentate or bidentate ligands in the iron‐mediated reverse atom transfer radical polymerization of methyl methacrylate in N,N‐dimethylformamide at 100 °C with 2,2′‐azobisisobutyrontrile as an initiator. The polymerization rates and polydispersity indices (1.32–1.8) of the resulting polymers are dependent on the structures of the ligands employed. Different iron complexes may be involved in iron‐mediated reverse atom transfer radical polymerization, depending on the type of acid used. ¹H NMR spectroscopy has been used to study the structure of the resulting polymers. Chain‐extension reactions have been performed to further confirm the living nature of this catalytic system. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2912–2921, 2006     

Surface structures formed by individual adsorption and coadsorption of Mn and Bi on Cu(0 0 1), studied by LEED

We have studied the individual adsorption of Mn and Bi, and their coadsorption on Cu(0 0 1) by low-energy electron diffraction (LEED). For Mn, we have determined the c(2 × 2) structure formed at 300 K, whose structure had been determined by several methods. We reconfirmed by a tensor LEED analysis that it is a substitutional structure and that a previously reported large corrugation (0.30 Å) between substitutional Mn and remaining surface Cu atoms coincides perfectly with the present value. In the individual adsorption of Bi, we have found a c(4 × 2) structure, which is formed by cooling below ∼250 K a surface prepared by Bi deposition of ∼0.25 ML coverage at 300 K where streaky half-order LEED spots appear. The c(4 × 2) structure has been determined by the tensor LEED analysis at 130 K and it is a substitutional structure. In the coadsorption, we found a c(6 × 4) structure, which has been determined by the tensor LEED analysis. It is very similar to the previously determined structure of the c(6 × 4) formed by coadsorption of Mg and Bi, and embedded MnBi₄ clusters are arranged in the top Cu layer instead of MgBi₄. Large lateral displacements of Bi atoms in the c(6 × 4)-(Mn + Bi) suggest that the Mn atoms undergo the size-enhancement caused by their large magnetic moment.     

Germanium growth on Br-terminated Si(1 0 0)

The consequences of Ge deposition on Br-terminated Si(1 0 0) were studied with scanning tunneling microscopy at ambient temperature after annealing at 650 K. One monolayer of Br was sufficient to prevent the formation of Ge huts beyond the critical thickness of 3 ML. This is possible because Br acts as a surfactant whose presence lowered the diffusivity of Ge adatoms. Hindered mobility was manifest at low coverage through the formation of short Ge chains. Further deposition resulted in the extension and connection of the Ge chains and gave rise to the buildup of incomplete layers. The deposition of 7 ML of Ge resulted in a rough surface characterized by irregularly shaped clusters. A short 800 K anneal desorbed the Br and allowed Ge atoms to reorganize into the more energetically favorable “hut” structures produced by conventional Ge overlayer growth on Si(1 0 0).     

The AB2-XA1 electronic transition of NO2: A rovibronic survey covering 14 300-18 000 cm

More than 250 rotationally resolved vibrational bands of the A²B₂-X²A₁ electronic transition of ¹⁵NO₂ have been observed in the 14 300-18 000 cm⁻¹ range. The bands have been recorded in a recently constructed setup designed for high resolution spectroscopy of jet cooled molecules by combining time gated fluorescence spectroscopy and molecular beam techniques. The majority of the observed bands has been rotationally assigned and can be identified as transitions starting from the vibrational ground state or from vibrationally excited (hot band) states. An exceptionally strong band is located at 14 851 cm⁻¹ and studied in more detail as a typical benchmark transition to monitor ¹⁵NO₂ in atmospheric remote sensing experiments. Standard rotational fit routines provide band origins, rotational and spin rotation constants. A subset of 177 vibronic levels of ²B₂ vibronic symmetry has been analyzed in the energy range between 14 300 and 17 250 cm⁻¹, in terms of integrated density and using Next Neighbor Distribution. It is found that the overall statistical properties and polyad structure of ¹⁵NO₂ are comparable to those of ¹⁴NO₂ but that the internal structures of the polyads are completely different. This is a direct consequence of the X²A₁-A²B₂ vibronic mixing.