Linear free energy relationship of the energy of the CTTS transition of Halide ions with the solvatochromic parameter α

A linear free energy relationship was found betweenv _max, the energy of the absorption maximum of chloride, bromide, or iodide ion in various solvents, and the solvatochromic parameter which is a measure of the hydrogen bond donor ability of the solvent. The relationships are: for chloride,v _max=6.99+50.16 kK; for bromide,v _max=5.52+45.20 kK; for iodide,v _max=5.02+40.33 kK. The correlation ofv _max for iodide ion with gave a larger correlation coefficient and smaller standard deviation than a correlation with the E _T (30) parameter of Dimroth. From the values ofv _max for iodide ion and the solvated electron in liquid ammonia at 25°C, these correlations indicate a preliminary value of 0.00 for the parameter of liquid ammonia. This had not been reported before and is lower than expected from a general knowledge of the physical and chemical properties of liquid ammonia but is consistent with a more detailed consideration and recent gas phase measurements of hydrogen bond donor strength.     

Thermal Degradation of Polychloroprene Rubber Under Isothermal and Non-Isothermal Conditions

The results of a kinetic investigation of the non-isothermal degradation and the isothermal degradation of the residual deformation under constant deflection for polychloroprene rubber are presented. A relationship was derived between the degree of non-isothermal conversion and the value of the investigated mechanical property. This revised version was published online in July 2006 with corrections to the Cover Date.     

聚合温度对聚甲基丙烯酸三丁基锡酯等规度的影响(Ⅰ)

本文测定了0—130℃温度范围内,由~(60)Co-γ射线和两种活性不同的引发剂引发聚合的聚甲基丙烯酸三丁基锡酯的等规度。利用~(13)C-NMR测定聚合物分子链的等规度,如预料的那样,以间同立构为主,并随着聚合温度的升高间同立构等规度降低。作者认为影响聚合物等规度的因素主要是取代基的极性效应。计算出的控制等规度的活化能参数与聚甲基丙烯酸甲酯和聚甲基丙烯酸三甲基锡酯的属同一数量级,可相互比较。     

A study of the thermal decarboxylation of three perfluoropolyether salts

The thermal decarboxylation of three dicarboxylic perfluoropolyether potassium salts of relatively short chain length has been investigated and the products and kinetics of the main reactions have been defined. From the rate constants and Arrhenius parameters data, the second decarboxylation appears to be quantitatively rather close to the first.     

Pressure and volume dependence of thelo-to phonons in InAs

The pressure dependence of thelo-to phonons in InAs has been investigated by Raman scattering using the diamond anvil cell. Indium arsenide transforms, presumably to the rock-salt structure at 70±1 kbar. The mode Grüneisen parameters for thelo-to phonons are γ _lo =0.99±0.03, γ _to =1.2±0.03 respectively. The effective charge,e* _T , for InAs decreases slightly with pressure and this trend is in accordance with the behaviour of other III–V zinc blende structured semiconductors: The structural phase transition is discussed in the light of theoretical calculations for phase stability of III–V compounds, as well as recent high pressure x-ray diffraction studies.     

Surface properties of Reactive Yellow 2 immobilised pHEMA and HEMA/chitosan membranes: characterisation of their selectivity to different proteins

Poly(hydroxyethyl methacrylate), pHEMA, and a composite pHEMA/chitosan networks were synthesized in the membrane form via UV initiated photo-polymerisation in the presence of an initiator ,′-azoisobutyronitrile. Reactive Yellow 2 (RY-2) was covalently immobilised as a dye–ligand onto both membranes. The polarity and surface energy of the investigated membranes were determined by contact angle measurement. The incorporation of chitosan in the pHEMA networks produced more hydrophilic surface, as indicated by contact angle analysis. The binding characteristics of lysozyme, γ-globulins, human serum albumin (HSA) and bovine serum albumin (BSA) to pHEMA-RY-2 and pHEMA/chitosan-RY-2 affinity membranes have been investigated from aqueous solution and their dye–ligand free forms were used as control systems. When chitosan was incorporated in the pHEMA network as a cationic polymer led to higher adsorption capacity for the lysozyme. Selective adsorption behaviour was also observed in the case of pHEMA/chitosan-RY-2 membrane for the lysozyme. The non-specific adsorptions of the lysozyme on the pHEMA and pHEMA/chitosan membranes were about 1.9 and 7.2 mg/ml, respectively. These were negligible for all others investigated proteins. The lysozyme adsorption data was analysed using the first-order and the second-order models. The first-order equation in both affinity membrane systems is the most appropriate equation to predict the adsorption capacities of the adsorbents. The adsorption isotherms well fitted the combined Langmuir–Freundlich model. A theoretical analysis has been conducted to estimate the thermodynamic contributions (changes in enthalpy, entropy and Gibbs free energy) for the adsorption of lysozyme to both dye–ligand immobilised membranes. The adsorption capacities of both dye–ligand immobilised membranes increased with increasing the temperature while decreased with increasing the NaCl concentration. Both affinity membranes are stable when subjected to sanitization with sodium hydroxide after repeated separation–elution cycles.     

Thermodynamics of phenylated polyphenylene between 0 and 340 K

In an adiabatic vacuum calorimeter, the temperature dependence of the heat capacity C _p of phenylated polyphenylene and initial comonomer 1,4-bis(2,4,5-triphenylcyclopentadienone-3-yl)benzene was studied between 6 and 340 K with an uncertainty of about 0.2%. In a calorimeter with a static bomb and an isothermal shield their energies of combustion DUcomb were measured. From the experimental data, the thermodynamic functions C _p ⁰ (T), H ⁰(T)-H ⁰(0), S ⁰(T)-S⁰(0), G ⁰(T)-H ⁰(0) were calculated from 0 to 340 K, and standard enthalpies of combustion ΔH _comb ⁰ and thermodynamic parameters of formation-enthalpies ΔH _f ⁰, entropies ΔH _f ⁰, Gibbs functions ΔG _f ⁰ - of the substances studied were estimated at T=298.15 K at standard pressure. The results were used to calculate the thermodynamic characteristics (ΔH _f ⁰ ,ΔS _f ⁰, ΔG _f ⁰) of phenylated polyphenylene synthesis in the range from 0 to 340 K. This revised version was published online in July 2006 with corrections to the Cover Date.     

Stability of anthocyanins extracted from grape skins

Summary The extractability and stability of anthocyanins from the skins ofVitis vinifera were determined at different pH values. Anthocyanins were extracted using acetone, partitioned with chloroform and pre-purified by solid-phase extraction (SPE). They were analysed by RP-HPLC, and the kinetic parameters of decomposition were calculated. The total monomeric anthocyanin content was determined by spectrophotometry. Anthocianins were well separated by RP-HPLC. The efficiency of extraction depended strongly on the pH of the extracting agent and on the character of the pigment to be extracted. The amount of anthocyanins decreased with increasing duration of storage, more so at elevated temperatures. Presented at Balaton Symposium '01 on High-Performance Separation Methods Siófok, Hungary, September 2–4, 2001.     

Complex formation constants and thermodynamic parameters for La(III) and Y(III)L-serine complexes

Summary The stoichiometric stability constants for La(III) and Y(III)L-serine complexes were determined by potentiometric methods at different ionic strengths adjusted with NaClO₄ and at different temperatures. The overall changes in free energy (G ^o), enthalpy (H ^o), and entropy (S ^o) during the protonation ofL-serine and that accompanying the complex formation with the metal ions have been evaluated.

---

Komplexbildungskonstanten und thermodynamische Parameter für La(III)- und Y(III)-L-Serin-Komplexe

Zusammenfassung Die stöchiometrischen Komplexbildungskonstanten für La(III)- und Y(III)-L-Serin-Komplexe wurden mittels potentiometrischer Methoden bei verschiedenen Ionenstärken (mit NaClO₄ adjustiert) und bei verschiedenen Temperaturen bestimmt. Die Änderungen in der freien Energie (G ^o), Enthalpie (H ^o) und Entropie (S ^o) während der Protonierung und der Komplexbildung mit den Metallionen wurden ermittelt.

     

Complex lanthanide chromate(VI)-phosphates K2R(CrO4)(PO4) (R = Dy-Lu, Y)

The conditions of formation of complex lanthanide chromate(VI)-phosphates K₂R(CrO₄)(PO₄) were found and these compounds were synthesized by solid-state synthesis with variation of the starting compounds, the temperature of synthesis (500–800 °C), and the annealing time (6–200 h). These salts are typical of late lanthanides, R = Dy-Lu, Y. Using lutetium derivatives as examples, it was shown that no similar compounds with lithium or sodium are formed. All the complex chromate(VI)-phosphates obtained decompose under static conditions at temperatures above 550 °C. They are isostructural and crystallize in the monoclinic system. The unit cell parameters for thulium, ytterbium, and lutetium compounds were calculated. It is shown by IR spectroscopy that PO₄ tetrahedra in the crystal lattice of potassium lanthanide chromate(VI)-phosphates are substantially distorted, whereas the CrO₄ tetrahedra retain the regular tetrahedron symmetry (T _d ). Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 622–626, April, 2006.