Detecting pore size distribution of activated carbon by low-field nuclear magnetic resonance

In this study, the transverse relaxation time (T₂) of activated carbon (AC) in different relative environment humidity was detected firstly by low-field nuclear magnetic resonance (LFNMR). The pore size (diameter) of AC distributions was calculated by the relationship between T₂ and surface relaxation rate (ρ), where ρ was obtained by the detection of nine porous materials with known pore size. The results showed that the pore size distributions of AC calculated by ρ < 0.19 nm/ms were in good agreement with that obtained by nitrogen adsorption method and proved that LFNMR as a new detection method was feasible for characterizing AC pore size distribution.     

Synthesis of nano-polycrystalline diamond from glassy carbon at pressures up to 25 GPa

ABSTRACT

Nano-polycrystalline diamond (NPD) with various grain sizes has been synthesized from glassy carbon at pressures 15–25?GPa and temperatures 1700–2300°C using multianvil apparatus. The minimum temperature for the synthesis of pure NPD, below which a small amount of compressed graphite was formed, significantly increased with pressure from ～1700°C at 15?GPa to ～1900°C at 25?GPa. The NPD having grain sizes less than ～50?nm was synthesized at temperatures below ～2000°C at 15?GPa and ～2300°C at 25?GPa, above which significant grain growth was observed. The grain size of NPD decreases with increasing pressure and decreasing temperature, and the pure NPD with grain sizes less than 10?nm is obtained in a limited temperature range around 1800–2000°C, depending on pressure. The pure NPD from glassy carbon is highly transparent and exhibits a granular nano-texture, whose grain size is tunable by selecting adequate pressure and temperature conditions.     

Theoretical study of (e,2e) triple differential cross sections of pyrimidine and tetrahydrofurfuryl alcohol molecules using multi-center distorted-wave method

We report theoretical studies of electron impact triple differential cross sections of two bio-molecules,pyrimidine and tetrahydrofurfuryl alcohol,in the coplanar asymmetric kinematic conditions with the impact energy of 250 eV and ejected electron energy of 20 eV at three scattering angles of-5°,-10°,and-15°.Present multi-center distorted-wave method well describes the experimental data,which was obtained by performing(e,2e)experiment.The calculations show that the secondary electron produced by the primary impact electron is strongly influenced by the molecular ionic multi-center potential,which must be considered when the low energy electron interacts with DNA analogues.     

An M/G/1 Retrial Queueing System with Two-Phase Service and Preemptive Resume

An M/G/1 retrial queueing system with additional phase of service and possible preemptive resume service discipline is considered. For an arbitrarily distributed retrial time distribution, the necessary and sufficient condition for the system stability is obtained, assuming that only the customer at the head of the orbit has priority access to the server. The steady-state distributions of the server state and the number of customers in the orbit are obtained along with other performance measures. The effects of various parameters on the system performance are analysed numerically. A general decomposition law for this retrial queueing system is established.     

Quantum states in fabricating poly-Si films

The quantum states are presented in these processions of fabricating poly-Si films. Amorphous silicon films prepared by PECVD has been crystallized by conventional furnace annealing (FA) and rapid thermal annealing (RTA), respectively. It is found that the thin films grain size present quantum states with the increasing of the gas flow ratios of SiH₄, H₂ mixture, substrate temperatures, frequency power, annealing temperature and time.     

二维位置灵敏探测器输出图像畸变的修正

高分辨(e,2e)谱仪采用二维位置灵敏探测器同时对能量和角度进行多道测量.二维位置灵敏探测器由级联使用的微通道板和电阻阳极板组成,由于电阻阳极板的边缘效应和制造工艺的缺陷,测量得到的位置图像与实际图像总会有一定的形变,存在一定的非线性.本文针对高分辨(e,2e)谱仪二维位置灵敏探测器输出图像的“桶形”畸变及位置非线性,采用一种简易的冷刻法(用脉冲信号来模拟真实电子束团),检验了二维位置灵敏探测器的Gear型电阻阳极板的线性好坏,并用分割成小三角形的方法找出测量得到的畸变图像与原始真实图像的映射关系,再用此关系对其它测量得到的畸变图像进行修正,并对修正的结果进行了评估.通过修正,由“桶形”畸变所造成的图像扭曲得到明显改善.修正后的x方向非线性由修正前的2.1%变为0.59%.这种检验和修正方法对其它领域类似探测器输出图像的修正也有一定的指导意义.     

Collisional excitation of Na-Rydberg atoms

The scattering of heavy ion with a multilevel Rydberg atom in the presence of an electromagnetic field is studied. The interaction of Rydberg atom and the e.m field is explored using non-perturbative quasi-energy technique. Although the results are presented for selected excitations but in actual calculations we have included many levels of the atom. The effect of various parameters are shown on collisional excitation process. As an illustration detailed calculations are performed for the inelastic proton-Na Rydberg atom collision accompanied by the transfer of photons and the effects of dressing due to the field are considered. The emphasis of the present work is on collision induced transitions especially the case that involves change of orbital as well as principal quantum number. Received 26 December 2001 / Received in final form 8 April 2002 Published online 19 July 2002     

飞秒孤子传输演化的数值研究

利用分步傅里叶法数值模拟了飞秒孤子在光纤中的传输演化过程。对光纤中单个孤子的传输及二阶孤子的自陡峭效应和自频移效应进行了分析,指出在一定的参数取值范围内,自频移效应对二阶fs孤子传输的影响要比自陡峭效应大,占主导地位,且对自陡峭效应有一定的抑制作用。     

The influence of pulse duration on the stress levels in ablation of ceramics: A finite element study

We present a finite element model to investigate the dynamic thermal and mechanical response of ceramic materials to pulsed infrared radiation. The model was applied to the specific problem of determining the influence of the pulse duration on the stress levels reached in human dental enamel irradiated by a CO₂ laser at 10.6 μm with pulse durations between 0.1 and 100 μs and sub-ablative fluence. Our results indicate that short pulses with durations much larger than the characteristic acoustic relaxation time of the material can still cause high stress transients at the irradiated site, and indicate that pulse durations of the order of 10 μs may be more adequate both for enamel surface modification and for ablation than pulse durations up to 1 μs. The model presented here can easily be modified to investigate the dynamic response of ceramic materials to mid-infrared radiation and help determine optimal pulse durations for specific procedures.