含氮类金刚石薄膜的紫外辐照研究

 用射频等离子体方法在玻璃基底上制备的类金刚石（DLC）薄膜，采用离子注入法掺氮，并对掺氮DLC薄膜紫外（UV）辐照前后的性能变化进行了研究。研究结果表明：随氮离子注入剂量及UV辐照时间的增加，位于2 930cm^-1附近的SP ³C-H吸收峰明显变小，而位于1 580cm^-1附近的SP2C-H吸收峰则明显增强，薄膜的电阻率明显呈下降趋势；随UV辐照时间的增加，位于1 078cm^-1附近的Si-O-Si键数量及位于786cm^-1附近的Si-C键数量明显增加。即氮离子注入和UV辐照明显改变了DLC薄膜的结构与特性。     

Optimization of Mass Transfer Processes in the Zone of the Air Electrode of a Fuel Cell with a Solid Polymer Electrolyte

A two-dimensional mathematical model for the transport of reactants in a fuel cell with a solid polymer electrolyte is developed. The model is used for analyzing spatial distributions of the concentration of reactants and current density over the cell. The effect of the catalytic-layer activity, reactant speed, bipolar-plate geometry, thickness and porosity of current collector and/or gas-diffusion sublayer, and the reaction mixture composition on the fuel cell efficiency is estimated theoretically and experimentally.     

Microwave-accelerated conjugate addition of aldehydes to α,β-unsaturated ketones

Aldehydes undergo smooth conjugate addition to α,β-unsaturated ketones in the presence of 5-(2-hydroxyethyl)-1,3-thiazolium halides and DBU adsorbed onto the surface of basic alumina under microwave irradiation and solvent-free conditions to afford 1,4-diketones in enhanced yields and reduced reaction times compared to conventional methods.     

两相同部件温贮备可修的人机系统解的性质分析

本文首先用强连续算子半群理论证明了两相同部件温贮备可修的人机系统动态非负解的存在唯一性 ,然后证明了 0是系统主算子的本征值 ,并得到 0本征值对应的本征向量是正的 ,从而系统存在稳态正解 .     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

Distribution results for lattices in SL(2,ℚ p )

In this paper we study the ergodic properties of the linear action of lattices Γ of SL(2,ℚ_p) on ℚ_p × ℚ_p and distribution results for orbits of Γ. Following Serre, one can define a “geodesic flow” for an associated tree (actually associated to GL(2,ℚ_p)). The approach we use is based on an extension of this approach to “frame flows” which are a natural compact group extension of the geodesic flow.     

Determination of residual monomers in acrylate dispersions by gas chromatography

The content of residual monomers is one of the most important characteristics of polymer dispersions. As a result of the similar physicochemical parameters of ethyl acrylate and methyl methacrylate, it is very difficult to determine the residual monomers in acrylate dispersions obtained by emulsion polymerization of both monomers. Gas chromatography with capillary columns, however, permits separation of these monomers and their quantitative determination in acrylate dispersions.     

Luminescence properties of anodic aluminum oxide films with organic luminophores embedded into pores

Luminescence properties of porous anodic aluminum oxide films formed in a 0.6 M solution of citric acid and luminescence of paraterphenyl, perylene, coumarin 7, and rhodamine 6G dyes adsorbed by the films are investigated. The nature of emitting centers in anodic aluminum oxide is revealed. Intense photoluminescence of all tested dyes embedded into pores of anodic aluminum oxide has been found. A redshift of fluorescence spectra of dyes adsorbed by the matrix and emergence of an additional longwave band have been detected. Data obtained can be used in developing new thin-film luminescent coatings for future applications in optoelectronics and molecular electronics. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No 4, pp. 483–488, July–August, 1997.     

Observable signals of gauge-mediated supersymmetry breaking

The observable consequences of gauge-mediated supersymmetry breaking (GMSB) are reviewed here. Implications of scenarios both with a neutralino and a slepton as the next lightest supersymmetric particle (NLSP) are surveyed in relation to hadronic ande ⁺ e ^- colliders. We also discuss the phenomenological consequences of the NLSP decaying slowly, giving rise to delayed events in the detectors.The importance of distinguishing signals of GMSB models from those of the commonly discussed supergravity-type theories is emphasized.