羧基化单壁碳纳米管涂层同时测定纯净水中的烷基酚和双酚A

用溶胶-凝胶方法制备了羧基化碳纳米管溶胶凝胶固相微萃取涂层,采用顶空固相微萃取-气相色谱法测定纯净水中的烷基酚和双酚A.优化了萃取涂层的萃取时间、萃取温度、盐浓度以及解析时间等实验参数.结果表明,在萃取温度为90℃和盐浓度为0.36 g/mL的条件下萃取30 min,250℃下解析3 min,涂层的萃取效果最好.与商用...     

Molecular design for high-spin molecules in view of vibronic couplings

A high-spin ground state is possible if a molecule has degenerate or pseudo-degenerate frontier orbitals. Since strong vibronic couplings, or electron-vibration interactions give rise to reduce the degeneracy or pseudo degeneracy, a lower-spin state is the ground state in such a molecule. Therefore small vibronic couplings are desirable for designing molecules with a high-spin ground state. Vibronic coupling constants of derivatives of m-phenylene diamine are evaluated. The calculated results are analyzed based on vibronic coupling density which enables us to control the vibronic coupling constants. Based on the vibronic coupling density analysis, we succeed in recovering the high-spin ground state from the closed-shell singlet ground state of a methoxy derivative of m-phenylene diamine by introducing an appropriate substituent.     

The solubility of CO2 and N2O in olive oil

The solubility of CO₂ and N₂O in olive oil has been measured at temperatures of about 298, 310, and 323 K with a gravimetric microbalance under pressures up to 2 MPa. The molecular weight of olive oil has been analyzed and found to be about 882 g mol⁻¹ as a mixed oil compound. The observed solubility data have been correlated with a cubic equation of state (EOS) model. N₂O has a larger solubility than CO₂ in olive oil based on either the mole or mass fraction. The present results clarify some ambiguities from the previous N₂O solubility data in the literature.     

Gas hydrate equilibria for CO2-N2 and CO2-CH4 gas mixtures—Experimental studies and thermodynamic modelling

In this paper, a set of experimental data on the phase equilibrium of gas hydrates in the presence of binary gas mixtures comprising CO₂ is presented. The procedure established allows for the determination of both the composition of the gas phase as well as the hydrate phase without the need to sample the hydrate. The experimental results obtained in these measurements have been described by means of the classical model of van der Waals and Platteeuw. The values of internal parameters of the reference state and the Kihara parameters have been re-discussed and their interdependency is pointed. Finally the new set of parameters is validated against experimental data from other sources available in the literature, or invalidated against other sources. Finally, we conclude on the difference of experimental data between laboratories. The differences are not on the classical (pressure, temperature, gas composition) data which appear equivalent between laboratories. The difference stands on the measurement composition of the hydrate phase.     

采用新型分子表面印迹技术构建手性空穴实现对手性药物对映体的分子识别与高效拆分

通过偶联剂γ-氨丙基三甲氧基硅烷（AMPS）的媒介,通过表面引发接枝,将功能单体甲基丙烯酸（MAA）接枝聚合在微米级硅胶微粒表面,制得功能接枝微粒PMAA/SiO2;采用本课题组建立的新型分子表面印迹技术,以四咪唑（TM）为模型手性药物,用其左旋对映体L-TM为模板分子,乙二醇二缩水甘油醚（EGDE）为交联剂,对接枝在...     

Development of a new microextraction method based on a dynamic single drop in a narrow-bore tube: application in extraction and preconcentration of some organic pollutants in well water and grape juice samples

A novel sample preparation technique, the microextraction method based on a dynamic single drop in a narrow-bore tube, coupled with gas chromatography-flame ionization detection (GC-FID) is presented in this paper. The most important features of this method are simplicity and high enrichment factors. In this method, a microdrop of an extraction solvent assisted by an air bubble was repeatedly passed through a narrow-bore closed end tube containing aqueous sample. It has been successfully used for the analysis of some pesticides as model analytes in aqueous samples. Parameters affecting the method's performance such as selection of extraction solvent type and volume, number of extractions, volume of aqueous sample (tube length), and salt effect were studied and optimized. Under the optimal conditions, the enrichment factors (EFs) for triazole pesticides were in the range of 141-214 and the limits of detection (LODs) were between 2 and 112 μg L⁻¹. The relative standard deviations (C = 1000 μg L⁻¹, n = 6) were obtained in the range of 2.9-4.5%. The recoveries obtained for the spiked well water and grape juice samples were between 71 and 106%. Low cost, relatively short sample preparation time and less solvent consumption are other advantages of the proposed method.     

Determination of some phthalate acid esters in artificial saliva by gas chromatography-mass spectrometry after activated carbon enrichment

The determination of six phthalate acid esters was achieved in artificial saliva using gas chromatography-mass spectrometry following activated carbon enrichment of samples. Central composite experimental design was applied to optimize method parameters, such as pH, adsorption time and amount of activated carbon. The best compromise of analytical conditions for the simultaneous determination of analytes from spiked artificial saliva were found to be: pH (3), adsorption time (30 min), activated carbon amount (1.8 g L⁻¹) and elution solvent (chloroform). These conditions were applied to study the migration of phthalate acid esters from different children's toys into saliva. A horizontal agitation method was applied to extract the analytes from plastic toys into saliva for 2 h at 37 °C. The detection limits of the method were in the range of 1.3-5.1 μg L⁻¹, while the relative standard deviation (%) values for the analysis of 100 μg L⁻¹ of the analytes were below 3.0% (n = 5). Di-2-ethylhexyl phthalate was the main analyte found in these samples.     

A novel small molecule fluorescent sensor for Zn2+ based on pyridine-pyridone scaffold

The development of a water-soluble and small molecular weight fluorescent probe, 3-(4-methoxyphenyl)-4-(methylsulfanyl)-6-(pyridin-2-yl)pyridin-2(1H)-one (3), for detecting Zn²⁺ based on pyridine-pyridone skeleton is reported. We observed a clear chelation enhanced fluorescence effect of 3 in the presence of Zn²⁺. Other fluorescent properties of 3 are discussed.     

Multiresidue determination of 160 pesticides in wines employing mixed-mode dispersive-solid phase extraction and gas chromatography-tandem mass spectrometry

A new multiresidue method for the efficient screening, identification and quantification of over 160 pesticides belonging to different chemical classes in red, rose and white wines have been developed. The analysis was based on gas chromatographic-tandem quadrupole mass spectrometric determination (GC-QqQ-MS/MS). An optimization strategy involved the selection of buffering conditions and sorbents for dispersive-solid phase extraction (dispersive-SPE) in order to achieve acceptably high recoveries and reduce co-extractives in the final extracts. As a result, the optimized procedure allowed us to obtain consistent recoveries of the target pesticides including problematic ones such as captan, chlorothalonil, dichlofluanid, folpet and tolylfluanid. The attained recoveries were typically between 80 and 110% (89% on average) with RSD values typically lower than 10% (8% on average) at three spiking levels of 0.01, 0.05 and 0.2 mg kg⁻¹. Linearity was studied in the range between 0.005 and 0.2 mg kg⁻¹ using pesticide standards prepared both in pure solvent and in the presence of matrix, showing coefficients of determination (R²) higher than 0.99 for all the pesticides except for desmedipham, thiabendazole and thiamethoxam in pure solvent. The study of the ratio of the slopes obtained in solvent and in matrix provided information about the matrix effects, which was <10%, 10-20% and >20% for 33, 36 and 31% of the studied pesticides, respectively. To improve accuracy, matrix matched standards were always used for calculation of the quantification results. The expanded uncertainties were estimated by using a “top-down” approach as being 17% on average (coverage factor k = 2, confidence level 95%). Finally, the method was used with success to detect and quantify pesticide residues in commercial wines.     

Comparative study of the adsorption performance of an active multi-sorbent bed tube (Carbotrap, Carbopack X, Carboxen 569) and a Radiello(®) diffusive sampler for the analysis of VOCs

A simple comparison is made to evaluate the relative performance of active and passive sampling methods for the analysis of volatile organic compounds (VOCs) in ambient air. The active sampling is done through a multi-sorbent bed tube (Carbotrap, Carbopack X, Carboxen 569) created in our laboratory and the passive sampling through the Radiello^® diffusive sampler specified for thermal desorption (filled with Carbograph 4). Daily duplicate samples of multi-sorbent bed tubes were taken during a period of 14 days. During the same period of time, quadruplicate samples of Radiello^® tubes were taken during 3 days, 4 days, 7 days and 14 days. The sampling was carried out indoors during the months of February and March 2010 and outdoors during the month of July 2010 in La Canonja (Tarragona, Spain). The analysis was performed by automatic thermal desorption (ATD) coupled with capillary gas chromatography (GC)/mass spectrometry detector (MSD). The analytical performance of the two sampling approaches was evaluated by describing several quality assurance parameters. The results show that the analytical performances of the methodologies studied are quite similar. They display low limits of detection, good precision, accuracy and desorption efficiency, and low levels of breakthrough for multi-sorbent bed tubes. However, the two monitoring methods produced varying air-borne concentration data for most of the studied compounds, and the Radiello^® samplers generally gave higher results. Sampling rates (Q_k) were determined experimentally, and their values were higher than those supplied by the producer. As the experimental calculation of Q_k values is generally carried out by the suppliers in exposure chambers with only the target compounds present in the air samples, as well as in concentrations dissimilar to those found in ambient air, the use of constant settled Q_k can lead to inaccurate results in complex samples.