Electrical conduction and dielectric properties of vanadium phosphate glasses doped with lithium

AC conductivity and dielectric studies on vanadium phosphate glasses doped with lithium have been carried out in the frequency range 0.2-100 kHz and temperature range 290-493 K. The frequency dependence of the conductivity at higher frequencies in glasses obeys a power relationship, σ_ac=Aω^s. The obtained values of the power s lie in the range 0.5≤s≤1 for both undoped and doped with low lithium content which confirms the electron hopping between V⁴⁺ and V⁵⁺ ions. For doped glasses with high lithium content, the values of s≤0.5 which confirm the domination of ionic conductivity. The study of frequency dependence of both dielectric constant and dielectric loss showed a decrease with increasing frequency while they increase with increasing temperature. The results have been explained on the basis of frequency assistance of electron hopping besides the ionic polarization of the glasses. The bulk conductivity increases with increasing temperature whereas decreases with increasing lithium content which means a reduction of the V⁵⁺.     

介质加载环板慢波结构高频特性研究

 提出了一种适用于环板结构的计算等效相对介电常数的方法，利用变分法导出了介质加载环板慢波结构的色散方程和耦合阻抗表达式。计算结果表明，介质加载能够有效降低环板慢波结构的工作电压。计算结果与CST-MWS的模拟结果吻合良好，说明所提出的计算等效相对介电常数的方法和计算色散方程的方法对环板慢波结构是切实可行的。     

Frequency dependence of ionic conductivity and dielectric relaxation studies in Na3H(SO4)2 single crystal

Electrical impedance measurements of Na₃H(SO₄)₂ were performed as a function of both temperature and frequency. The electrical conductivity and dielectric relaxation have been evaluated. The temperature dependence of electrical conductivity reveals that the sample crystals transformed to the fast ionic state in the high temperature phase. The dynamical disordering of hydrogen and sodium atoms and the orientation of SO₄ tetrahedra results in fast ionic conductivity. In addition to the proton conduction, the possibility of a Na⁺ contribution to the conductivity in the high temperature phase is proposed. The frequency dependence of AC conductivity is proportional to ω^s. The value of the exponent, s, lies between 0.85 and 0.46 in the room temperature phase, whereas it remains almost constant, 0.6, in the high-temperature phase. The dielectric dispersion is examined using the modulus formalism. An Arrhenius-type behavior is observed when the crystal undergoes the structural phase transition.     

Dielectric properties of a hydrated sulfonated poly(styrene-ethylene/butylenes-styrene) triblock copolymer

The present study showed that sulfonated poly(styrene-ethylene/butylenes-styrene) (S-SEBS) triblock copolymer ionomers can be made to exhibit dielectric constants on the order of a hundreds thousand. Although they are too lossy at this point to use as dielectric materials in capacitors or as electrostrictive Maxwell effect transducer materials because of their high hydrogen ion conductivity, the results of these initial dielectric studies as a function of ion content were used to try to understand the effects of a polar plasticizer, water, on dielectric properties of the acid form of this ionomer. This was done before moving on to more tightly bound ions (rather than the hydrogen ions of the sulfonic acid groups used here) and to other polar, less mobile plasticizers (which also interact strongly with the ionic dipoles). The discovery of such high dielectric constants suggested the possibility that low dielectric loss versions of this type of polymer, as well as other members of the class known as ionomers, might find future applications as extremely high dielectric constant materials in capacitors or transducers. Experimental results for films with degrees of sulfonation on the order of 10% or more showed dielectric constants on the order of ?′ ∼ 100,000 but dielectric loss tangents near D = tan δ ∼ 0.3, when the materials were exposed to high humidity conditions. Experiments to determine the effects of water content on the material's dielectric response showed that water can easily move into and out of the films studied and that this transport behavior is strongly correlated to the relative humidity of the environment and to the degree of sulfonation. Water content, in this case, was thus the primary consideration when attempting to understand the observed high dielectric constants in films with degree of sulfonation greater than 5.5%. However, vacuum-dried films were, also, examined and observed to exhibit a dielectric constant on the order of 2 until the degree of sulfonation was greater than 11%. Above this value, the dielectric constant increased by approximately 100% to a value on the order of 4.     

On additives, morphological evolution and dielectric breakdown in low density polyethylene

A series of low density polyethylene systems has been studied with respect to structural evolution and short-term dielectric breakdown behaviour. All materials were based upon a single polymer, that is commonly used in high voltage applications, but with different additives. In all three of these systems, multiple melting transitions were observed, as a result of molecular fractionation effects during crystallization. In the virgin polymer, a space-filling banded spherulitic morphology was found to develop at low temperatures (102 °C and below) whereas, at higher temperatures, only a few isolated axialites were observed. Inclusion of the antioxidant resulted in greatly increased nucleation densities, such that, at low temperatures, no evidence of spherulitic organisation remained. At higher temperatures, sheaf-like lamellar aggregates developed, which were much smaller and much more numerous than in the case of the virgin polymer. Further addition of dicumyl peroxide (DCP) resulted in the rapid formation of a crosslinked network at 200 °C. Some crosslinking also occurred at 150 °C, but over a much longer timescale. Where extensive crosslinking occurred prior to crystallization, the resulting gel inhibited structural development, such that only a few small, isolated sheaves were able to form at 102 °C. In view of the principal application area of this material, the breakdown strength of each of the above systems was then measured and the whole data set was analysed statistically. When structural factors were considered alongside the statistics, no clear trends emerged to indicate that either the compositional or morphological variations were reflected in the short-term electrical failure processes.     

Dielectric investigations of associate formation process in thin nitrobenzene interlayers formed between metal substrates

Studies of thickness and temperature dependencies of the dielectric susceptibility of nitrobenzene interlayers formed on conductive substrates were carried out. The obtained data were processed under the assumption of the existence of dimers (with opposite directions of molecular dipole moments) in orientationally ordered wall-adjacent layers. The results were treated on the basis of Lifshits theory.     

System Identification Models of the Equivalent Permittivity for Rain Medium

The dielectric constant for rain medium is investigated by utilizing the system identification method. The rain rate model and frequency model of permittivity in millimeter waves band for rain medium are presented. The results obtained with models are in very good agreement with references in calculating the attenuation of electromagnetic waves induced by rain, which Shows that the obtained models are valid and practicable. The cross-polar discrimination gotten with rain rate model is in agreement with references.     

Impedance and dielectric studies of ferroelectric SrBi2Nb2O9 ceramics

This paper reports the dielectric and impedance characteristics of ferroelectric SrBi₂Nb₂O₉ (SBN) ceramics in the 100 Hz-1 MHz frequency range at various temperatures (300-823 K). A strong low frequency dielectric dispersion (LFDD) associated with an impedance relaxation has been found to exist in these ceramics in the temperature range 573-823 K. The Z″ of the AC complex impedance showed two distinct slopes in the frequency range 100 Hz-1 MHz suggesting the existence of two dispersion mechanisms. This non-ideal behavior has been explained on the basis of the expression, Z*=R₀/(1+(iω/ω₁)^m+(iω/ω₂)ⁿ) [J. Phys. Chem. Solids 53 (1992) 1] where ω₁ and ω₂ characterize the lattice response and the charge carrier behavior, respectively. The exponents m and n were obtained from the curve fitting. The exponent n was found to exhibit a minimum at the Curie temperature, T_c (723 K) whereas the m was temperature independent.     

Dielectric and conduction mechanism studies of PVA-orthophosphoric acid polymer electrolyte

Polyvinyl alcohol (PVA)-based proton conducting polymer electrolytes have been prepared by the solution cast technique. The conductivity is observed to increase from 10⁻⁹ to 10⁻⁴ S cm⁻¹ as a result of orthophosphoric acid (H₃PO₄) addition. The plot of conductivity vs temperature shows that a phase transition occurred at 343 K in the sample PVA-33 wt% H₃PO₄. The β-relaxation peak is observed at 313 K. The glass transition temperature of PVA-33 wt% H₃PO₄ is 343 K. Orthophosphoric acid seems to play a dual role, i.e., as a proton source and as a plasticizer. The ac conductivity σ _ac = Aω ^s was also calculated in the temperature range from 303 to 353 K. The conduction mechanism was inferred by plotting the graph of s vs T from which the conduction mechanism for sample PVA-17 wt% H₃PO₄ was inferred to occur by way of the overlapping large polaron tunneling (OLPT) model and the conduction mechanism for the sample PVA-33 wt% H₃PO₄ by way of the correlated barrier height (CBH) model.     

Three-body problem in the theory of the dielectric constant

We study the corrections to the Clausius-Mossotti formula for the dielectric constant of a disordered system of polarizable spherical particles. Previously we have derived an exact cluster expansion for the correction terms. Here we study the three-body correction in detail. We derive an explicit expression for the integrand of the three-body cluster integral for a system of polarizable point dipoles.