激光准直仪的设计性物理实验

介绍了激光准直仪的结构、工作原理及其在设计性物理实验中的应用     

High power diode single-end-pumped Nd:YVO4 laser

A fiber-coupled diode-single-end-pumped Nd:YVO₄ laser with an Nd:YVO₄ crystal of 0.3 at% doping concentration and 3×3×10 mm³ dimensions was reported. 14.850 W of continuous-wave output power in an M² factor of 1.12 was obtained under pump power of 27.365 W, with an optical conversion efficiency of 60.49%, and a slope efficiency of 64.5%.     

Laser spectroscopic investigation of a new precursor-type polyparaphenylenevinylene

Optical, structural and morphological properties of thin films of polyparaphenylenevinylene (PPV) formed by an alkyl sulfinyl precursor route have been studied. Thin films were fabricated on an optical glass and on quartz glass either by spin-coating of the precursor solution or by layer-by-layer deposition using Langmuir–Blodgett technique. PPV precursor films were also spin-coated on gold-coated glass in order to study thin-film optical parameters by surface plasmon spectroscopy. We have been successful in forming about 40 precursor mono layers on quartz glass by Langmuir–Blodgett technique using optimized surface pressure and dipping conditions. After thermal conversion of the precursor layers good quality fluorescent PPV films of yellow colour have been obtained. Optical characterization of the films was carried out by linear absorption and emission spectroscopy, ellipsometry, and surface plasmon spectroscopy. Structural and morphological studies on the thin films were carried out by using X-ray scattering and atomic force microscopy. Wave-guided travelling-wave laser action has been achieved in a PPV film on quartz glass. The sample was transversally pumped with picosecond laser pulses (wavelength 347.15 nm, duration 35 ps). Laser emission occurred at 550 nm for pump pulse energy densities above .     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

高功率固体激光放大系统相位自校正方法研究

就光学元件间低频相位误差叠加提出用相关系数作为叠加相位结果的估计参量，并通过模拟计算和验证实验证明了相关系数能有效地对低频相位叠加结果进行比较估计，在此基础上就高功率固体激光放大系统中放大片的选取和安装提出了自校正方法并实现了自校正过程。     

二氧化碳和丙烯直接合成甲基丙烯酸的NiPMo/TiO2催化剂的研究

用溶胶 凝胶法以磷钼酸 (MPA)的镍盐溶液水解钛酸四丁酯制备了NiPMo/TiO2 催化剂 .使用ICP、XRD、TG DTA、IR、TPD MS和微反应技术研究了催化剂的化学组成、热稳定性、化学吸附性质和催化反应性能 .杂多钼酸盐与TiO2 通过O2 -在TiO2 表面发生了键合 .在 6 2 3K下 ,杂多阴离子仍保持原有的Keggin结构 .CO2 在Lewis酸位Ni(Ⅱ )和Lewis碱位Ni-O -Mo的桥氧协同作用下生成CO2 卧式吸附态Ni(Ⅱ )←O - (CO)← (O--Ni) .丙烯有多种吸附态在催化剂上吸附 .在 5 6 3K、1MPa和空速 15 0 0h-1的反应条件下 ,丙烯的摩尔转化率为 3.2 % ,产物MAA选择性为 95 % .     

激光水下扫描成像系统的图像修正机理

同步扫描系统可以克服后向散射，但同时也产生了两种非线性，一是扫描线速度的非线性，一是由于距离对光能衰减造成的非线性，两种非线性都需要修正，本文从原理上讨论水下激光成像时能量衰减的修正原理与修正方法，并给出仿真结果。     

中空光纤技术与应用特性

介绍一种采用环烯烃聚合物镀膜的中空光纤结构，阐述其传输特性，说明其使用特点，指出它在工业和医疗等领域中的应用前景。     

LD泵浦固体激光器基模振荡光的场分布噪音

通过调整泵浦光直径,使得LD端面泵浦固体激光器的振荡光工作于基模.在排除高阶横模的条件下,测量了由于热透镜的不稳定引起的光场场分布的噪音.实验发现,基模振荡光的高斯半径、光束指向角都在波动,而且光斑存在畸变波动.对一个未采取抑制措施的2W连续LD端面泵浦Nd:YAG固体激光器进行了测量.结果表明,在总功率不变的情况下,激光束峰值点附近的光强波动达到6.3%;激光的高斯半径波动达到5.8%;激光的指向角波动达到0.3mrad.     

利用相干渡越辐射测量电子束团长度的分析与计算

利用相干渡越辐射(CTR)测量短和超短电子束团长度是国际上束测领域新发展的频域测量技术.文中理论分析和数值计算了北京自由电子激光装置的皮秒级的射频电子束团序列产生的CTR,当辐射波长在长于束长(4ps)时,渡越辐射发生相干增强效应;与非相干渡越辐射相比,当λ≥2πσz时,增强的倍数约等于束团中粒子的数目(10⁸);CTR从亚毫米波到毫米波段呈宽带连续谱特性;渡越辐射能量主要集中在轴线附近,宏脉冲辐射能量高达几毫焦.设计采用偏振型束团长度测量系统,利用CTR自相关技术,实验测量该束团序列的纵向长度,并藉助傅里叶变换光谱法,推求束团电子分布.