The effect of polyvinyl alcohol (PVA) on the optical,electrical and solid state properties of copper zinc tin sulfide (CZTS) deposited by sensitive spray pyrolysis (SSP)

Recently, the use of CZTS as the basis for other generation of low cost thin films solar cells has stimulated further researches. Its excellent p-type absorber nature, relatively high absorption coefficient and ideal energy band-gap of 1.5eV motivated these efforts. Additionally, CZTS consist of earth-abundant, cheap and non-toxic elements with very low manufacturing cost. Initially, copper indium gallium selenide (CIGS) solar cell device emerged but suffered limitations in further development because of rare indium and gallium in the device structure therefore, CZTS is recently preferred as an alternative to CIGS commercial solar cell absorber layer. In this work, solution mixture of CZTS and PVA was deposited on a substrate at temperature of 150 °C. Sensitive spray pyrolysis was used to grow the thin films where calculated amount of the precursor mixture was allowed to fall and be deposited on a heated substrate to form CZTS/PVA thin films. Subsequently, the thin film samples were annealed at a temperature of 200^oCfor 1 h to achieving pure crystalline thin film formation. SEM, XRD analysis, Optical, Solid State properties and Raman analysis were studied. The XRD analysis showed that the thin films fell into the pure kesterite structure of CZTS. Results show that produced thin films exhibited higher absorption coefficient and optical conductivity than pure CZTS, 10⁶ m^?1 and 10¹⁴(S^?1) against 10⁴cm^?1 and 10¹²(S^?1) respectively. The band-gap is between 1.53eV and 1.73eV. Using a PVA concentration of 0.05 M yielded highest absorbance and optical conductivity with lowest real dielectric constant and transmittance. These improved optical, electrical and solid state properties suitably qualify these thin films as absorber layer material for solar cell applications.     

Characterization of nitrate ions adsorption and diffusion in P（DMAEMA/HEMA） hydrogels

In this work, the adsorption and diffusion behavior of nitrate ions into polycationic P（DMAEMA/HEMA） hydrogels is analyzed. Experimental results indicated that nitrate ions can be removed efficiently from aqueous solutions. Adsorption isotherm of gels was well according to the Langmuir and Langmuir-Freundlich models. At the same time, the diffusion behavior of nitrate ions from P（DMAEMA/HEMA） hydrogels was investigated. The diffusion coefficients are strongly influenced by the changes of temperature and pH value of solutions. At the same time, D does not depend on the gels cross-linking ratio and initial solute concentration.     

关于Borg定理

Borg定理是判定周期系数二阶线性微分方程稳定的一个重要定理,这个定理在一定意义下是不可改进的.本文利用判别式的一个新形式,在弱的限制下,得到判定周期系数二阶线性微分方程稳定的定理,所得结论改进了Borg定理的判定结果.     

Degrees of stretched Kostka coefficients

Given a partition λ and a composition β, the stretched Kostka coefficient is the map n ↦ K _{n λ,n β} sending each positive integer n to the Kostka coefficient indexed by n λ and n β. Kirillov and Reshetikhin (J. Soviet Math. 41(2), 925–955, 1988) have shown that stretched Kostka coefficients are polynomial functions of n. King, Tollu, and Toumazet have conjectured that these polynomials always have nonnegative coefficients (CRM Proc. Lecture Notes 34, 99–112, 2004), and they have given a conjectural expression for their degrees (Séminaire Lotharingien de Combinatoire 54A, 2006). We prove the values conjectured by King, Tollu, and Toumazet for the degrees of stretched Kostka coefficients. Our proof depends upon the polyhedral geometry of Gelfand–Tsetlin polytopes and uses tilings of GT-patterns, a combinatorial structure introduced in De Loera and McAllister, (Discret. Comput. Geom. 32(4), 459–470, 2004). Research supported by NSF VIGRE Grant No. DMS-0135345 and by NWO Mathematics Cluster DIAMANT.     

Free-solvent model shows osmotic pressure is the dominant factor in limiting flux during protein ultrafiltration

In protein ultrafiltration (UF), the limiting flux phenomenon has been generally considered a consequence of the presence of membrane fouling or the perceived formation of a cake/gel layer that develops at high operating pressures. Subsequently, numerous theoretical models on gel/cake physics have been made to address how these factors can result in limiting flux. In a paradigm shift, the present article reestablishes the significance of osmotic pressure by examining its contribution to limiting flux in the framework of the recently developed free solvent osmotic pressure model. The resulting free-solvent-based flux model (FSB) uses the Kedem–Katchalsky model, film theory and the free solvent representation for osmotic pressure in its development. Single protein tangential-flow diafiltration experiments (30 kDa MWCO CRC membranes) were also conducted using ovalbumin (OVA, 45 kDa), bovine serum albumin (BSA, 69 kDa), and immuno-gamma globulin (IgG, 155 kDa) in moderate NaCl buffered solutions at pH 4.5, 5.4, 7 and 7.4. The membrane was preconditioned to minimize membrane fouling development during the experimental procedure. The pressure was randomly selected and flux and sieving were determined. The experimental results clearly demonstrated that the limiting flux phenomenon is not dominated by membrane fouling and the FSB model theoretically illustrates that osmotic pressure is the primary factor in limiting flux during UF. The FSB model provides excellent agreement with the experimental results while producing realistic protein wall concentrations. In addition, the pH dependence of the limiting flux is shown to correlate to the pH dependency of the specific protein diffusion coefficient.     

Correlation and prediction of partition coefficient between the gas phase and water, and the solvents dry methyl acetate, dry and wet ethyl acetate, and dry and wet butyl acetate

Experimental partition coefficient data have been compiled from the published literature for the water/methyl acetate, water/ethyl acetate and water/butyl acetate partition systems, log P data, and for the gas/methyl acetate, gas/ethyl acetate and gas/butyl acetate partition systems, log K data. Application of the Abraham solvation parameter model to the sets of partition coefficients leads to equations that correlate the log P data and log K data to 0.18 log units for the three dry alkyl acetate solvents. Slightly larger deviations were noted for solute partition into both wet ethyl acetate and wet butyl acetate. The derived correlations were validated using training set and test set analyses.     

Modeling aqueous electrolyte solutions: Part 1. Fully dissociated electrolytes

Liquid densities (pvT), vapor pressures (VLE), and mean ionic activity coefficients (MIAC) at 25 °C of 115 single-salt electrolyte solutions containing univalent up to trivalent ions are modeled with the ePC-SAFT equation of state proposed by Cameretti et al. [L.F. Cameretti, G. Sadowski, J.M. Mollerup, Ind. Eng. Chem. Res. 44 (2005) 3355–3362; ibid., 8944]. For each ion, only two model parameters were adjusted to experimental density and MIAC data. Without using any additional binary parameters, ePC-SAFT is able to reproduce experimental data of the respective salt solutions up to high electrolyte molalities. Moreover, it is even able to describe the reversed MIAC series for alkali hydroxides and fluorides.     

Preparation and nonlinear optical properties of novel Y-type polyesters with highly enhanced thermal stability of second harmonic generation

3,4-Di-(2′-hydroxyethoxy)benzylidenemalononitrile (3) was prepared and condensed with terephthaloyl chloride and adipoyl chloride to yield novel Y-type polyesters (4-5) containing 3,4-dioxybenzylidenemalononitrile groups as NLO-chromophores, which constituted parts of the polymer main-chains. The resulting polymers 4-5 are soluble in common organic solvents such as acetone and N,N-dimethylformamide. They showed thermal stability up to 300 °C in thermogravimetric analysis with glass-transition temperatures obtained from differential scanning calorimetry in the range 89-91 °C. The second harmonic generation (SHG) coefficients (d₃₃) of poled polymer films at the 1064 nm fundamental wavelength were around 2.47 pm/V. The dipole alignment exhibited high thermal stability even at 10 °C higher than T_g, and there is no SHG decay below 100 °C due to the partial main-chain character of polymer structure, which is acceptable for NLO device applications.     

不同温度下脯氨酸在非水阴离子、阳离子及非离子型表面活性剂中的相互作用

Density and viscosity data of proline (Pro) in sodium dodecyl sulfate/cetyltrimethylammonium bromide/poly (oxyethylene) isooctyl phenyl ether in formamide were measured at 298.15, 303.15, 308.15, and 313.15K and 0.1MPa. The density data were utilized to evaluate standard partial molar volumes (φ0V) and partial molar isobaric expansibility (φ0E). The viscosity data were used to evaluate A-and B-coefficients, free energy of activation of viscous flow (⊿μ0*1) and (⊿μ0*2), per mole of solvent and solute respectively, enthalpy (⊿H*) and entropy (⊿S*) of activation of viscous flow. The results obtained were utilized in the qualitative elucidation of the Pro-surfactant/formamide and Pro-Pro interactions in the present systems.     

空气在二甲基硅油和液压油中的溶解度

对于诸多工程运用场合, 获得空气在硅油以及液压油中溶解度可靠的数据至关重要. 针对已有测量装置及方法的不足, 建立了一种基于理想气体状态方程来确定气体溶解量的新型精密活塞式装置. 获得了温度为293.2及353.2 K, 压力在0-350 kPa范围内, 空气在500cSt 二甲基硅油中的本生溶解度表达式. 测量了298.2 K时20cSt二甲基硅油及国产32#抗磨液压油在多种气相压力下的本生溶解度. 精度及可靠性分析表明实验数据的误差范围为6%. 本生溶解度与气相压力呈较好的线性关系, 以摩尔分数表示的溶解度与压力呈非线性关系, 但可用Krichevsky-Ilinskaya方程拟合. 发现空气在相对分子质量差异很大的两种二甲基硅油中的本生溶解度很接近, 由此提出, 对于小分子的非极性溶质在聚合物溶剂中的溶解度, 用聚合物单体的摩尔数而不是聚合物分子摩尔数来表示摩尔浓度更有利于实验数据的外推和工程应用. 对于相对分子质量差别较大或无法确定相对分子质量的溶剂, 工程应用中适宜采用本生溶解度.