Teaching of process analytical chemistry

In the teaching of analytical chemistry for chemical engineering students it is essential today to teach the chemical analysis of dynamic systems, not only in the process control of the modern technological systems, where the control of composition or structure of different material streams is necessary, but also in all other instances where analysis, decision and intervention follow each other, forming a closed cycle. Teaching can be made effective if students already have a knowledge of the basic disciplines (including analytical chemistry). The schedule of the teaching programme should include the mathematical statistical treatment of process signals, quality of the signals, signal-improvement methods, characteristics of instruments, calibration and an introduction to sensors, analysers suitable for continuous or periodical measurements and local area networks. As practical exercizes an apparatus for investigation of the dynamic properties of a thermoanalytical detector system, a computer program for simulating process variables and the control loop including the measuring system are presented.     

发光分析

本文是《分析试验室》定期评述中“发光分析”课题的第四篇评述文章，它评述在１９９５年１月～１９９６年１２月间我国发光分析的发展概况，内容包括：荧光，磷光，化学发光和生物发光分析等方面，引用文献３５４篇。     

流动注射双安培法测定葛根素

利用不可逆电对的双安培检测原理,建立了流动注射双安培直接检测葛根素的电化学新方法.使用经过恒电位预阳极化处理的双铂电极,通过耦合葛根素在一支电极上的氧化和氧化铂在另一支电极上的还原两个不可逆电极过程,构成流动注射双安培检测体系.在外加电位差为0.2 V时,pH 8.94的碳酸钠-碳酸氢钠缓冲溶液中,测得氧化电流与葛根素浓度在6.0×10-6～1.0×10-3 mol/L范围内呈线性关系(r=0.997 4,n=8),检出限为1.0×10-6 mol/L.连续40次测定6.0 ×10-4 mol/L的葛根素,RSD=1.58%.用该方法对葛根素含量进行了测定,结果令人满意.     

pH sensitivity of Si--C linked organic monolayers on crystalline silicon surfaces.

The electrochemical behavior of Si--C linked organic monolayers is studied in electrolyte-insulator-Si devices, under conditions normally encountered in potentiometric biosensors, to gain fundamental knowledge on the behavior of such Si electrodes under practical conditions. This is done via titration experiments, Mott-Schottky data analysis, and data fitting using a site-binding model. The results are compared with those of native SiO(2) layers and native SiO(2) layers modified with hexamethyldisilazane. All samples display pH sensitivity. The number of Si--OH groups on the alkylated samples is calculated to be less than 0.7 % of that of a pure SiO(2) insulator, which still causes a pH sensitivity of approximately 25 mV per pH unit in the pH range: 4-7. The alkylated samples hardly suffer from response changes during up- and down-going titrations, which indicates that very little oxide is additionally formed during the measurements. The pK(a) values of all samples with monolayers (4.0-4.4) are lower than that of native SiO(2) (6.0). The long-term drift (of approximately 1 mV h(-1)) is moderate. The results indicate that biosensors composed of alkylated Si substrates are feasible if a cross-sensitivity towards pH in the sensor signal is taken into account.     

Investigation of the detection limit for the determination,by pyrolysis-capillary GC,of the thickness of ultra thin PMMA layers coated on to PET film

The determination of nanometer thick layers of poly(methyl methacrylate) coated on to the surface of poly(ethylene terephthalate) film has been investigated by high resolution pyrolysis gas chromatography without sample pretreatment or modification of the instrumentation used. A good linear relationship was observed between the quantity of the characteristic pyrolysate and the thickness of the poly(methyl methacrylate) layer; the detection limit was sufficient to enable the quantitation of poly(methyl methacrylate)-to-poly(ethylene terephthalate) film thickness ratios of 1:20000 in composite materials.     

SIAmate-a compact and modular sequential injection analysis controller

A number of sequential injection analysis (SIA) measurement methods have been developed during the last years. Almost all have been used in laboratory conditions with good results, but very few have been implemented as on-line methods, applied to non-stop measurements, producing immediate results for process control. The transfer of an SIA system from laboratory to an industrial facility [J. Ruzicka, Anal. Chim. Acta 261 (1992) 3] requires a whole new range of details to be taken into account. Some SIA platform related topics will be discussed. There are numerous ways of building an SIA system that meets the needs of the industry. One alternative, SIAmate, is presented.     

Effect of the ionic strength of salts on retention and overloading behavior of ionizable compounds in reversed-phase liquid chromatography I. XTerra-C18

The influence of the salt concentration (potassium chloride) on the retention and overloading behavior of the propranolol cation (R'-NH2+ -R) on an XTerra-C18 column, in a methanol:water solution, was investigated. The adsorption isotherm data were first determined by frontal analysis (FA) for a mobile phase without salt (25% methanol, v/v). It was shown that the adsorption energy distribution calculated from these raw adsorption data is bimodal and that the isotherm model that best accounts for these data is the bi-Moreau model. Assuming that the addition of a salt into the mobile phase changes the numerical values of the parameters of the isotherm model, not its mathematical form, we used the inverse method (IM) of chromatography to determine the isotherm with seven salt concentrations in the mobile phase (40% methanol, v/v; 0, 0.002, 0.005, 0.01, 0.05, 0.1 and 0.2 M). The saturation capacities of the model increase, q(s,1) by a factor two and q(s,2) by a factor four, with increasing salt concentration in the range studied while the adsorption constant b1 increases four times and b2 decreases four times. Adsorbate-adsorbate interactions vanish in the presence of salt, consistent with results obtained previously on a C18-Kromasil column. Finally, besides the ionic strength of the solution, the size, valence, and nature of the salt ions affect the thermodynamic as well as the mass transfer kinetics of the adsorption mechanism of propranolol on the XTerra column.     

Chemometric analysis of groundwater quality data of alluvial aquifer of Gangetic plain, North India

Water quality data set from the alluvial region in the Gangetic plain in northern India, which is known for high fluoride levels in soil and groundwater, has been analysed by chemometric techniques, such as principal component analysis (PCA), discriminant analysis (DA) and partial least squares (PLS) in order to investigate the compositional differences between surface and groundwater samples, spatial variations in groundwater composition and influence of natural and anthropogenic factors. Trilinear plots of major ions showed that the groundwater in this region is mainly of Na/K-bicarbonate type. PCA performed on complete data matrix yielded six significant PCs explaining 65% of the data variance. Although, PCA rendered considerable data reduction, it could not clearly group and distinguish the sample types (dug well, hand-pump and surface water). However, a visible differentiation between the water samples pertaining to two watersheds (Khar and Loni) was obtained. DA identified six discriminating variables between surface and groundwater and also between different types of samples (dug well, hand pump and surface water). Distinct grouping of the surface and groundwater samples was achieved using the PLS technique. It further showed that the groundwater samples are dominated by variables having origin both in natural and anthropogenic sources in the region, whereas, variables of industrial origin dominate the surface water samples. It also suggested that the groundwater sources are contaminated with various industrial contaminants in the region.     

Imaging fiber microarray fluorescent ion sensors based on bulk optode microspheres

Optical imaging fibers with micrometer-sized wells were used as a sensing platform for the development of microarray optical ion sensors based on selective bulk extraction principles established earlier for optodes. Uniform 10 μm sized microspheres based on plasticized poly(vinyl chloride) containing various combinations of ionophores, fluoroionophores and lipophilic ion-exchangers were prepared for the detection of sodium, potassium, calcium and chloride, and deposited onto the wells of etched fiber bundles. Specifically, sodium sensing particles were based on tert-butylcalix[4]arene tetraacetic acid tetraethylester, potassium particles on 2-dodecyl-2-methyl-1,3-propanediyl bis[N-[5′-nitro(benzo-15-crown-5)-4′-yl]carbamate] (BME-44), calcium particles on an acrylic derivative of ETH 129 (AU-1) covalently attached to a methacrylic polymer, and chloride particles based on the anticrown ionophore [9]mercuracarborand-3 (MC-3). The fluorescence emission characteristics of individual microspheres were observed from the backside of the fibers and were found to selectively and rapidly change as a function of the sample composition. The optical characteristics of the particles were found to be comparable to that of corresponding thin optode films and particles deposited onto microscope glass slides. The measuring ranges (logarithmic molar concentrations) at pH 7.0 were found as −3 to 0 for sodium, −3.5 to −0.5 for potassium, −7 to −2 for calcium, and −5 to 0.5 for chloride. Selectivities were determined over other common electrolytes and found to be sufficient for physiological applications. The simultaneous deposition of sodium and chloride sensing particles was successfully performed, demonstrating that such microarray sensors are capable of simultaneously sensing multiple analytes. This technology is compatible with other microsphere-based fluorescent sensing principles, forming a promising total analysis platform for a variety of applications.     

Synthesis, Crystal Structure and Inhibition of the K562 Cell Proliferation of N＇-Tertbutylaminocarbonyl-N-2-chlorophenoxyacetylthiourea

The title compound N'-tert-butylaminocarbonyl-N-2-chlorophenoxyacetylthiou- rea has been synthesized for the first time. Complete assignments were achieved by IR, 1H NHR and single-crystal X-ray diffraction analyses. The inhibitory rate of the cellular growth of K562 cells (chronic myeloid 1eukemic cells) was measured using MTT [3-(4,5-dimethylthiazo-2-y1)-2,5-di- phenyltetra-zolium bromide] assay. The cell apoptosis was assessed by agarose gel electrophoresis to find that the title compound has antiproliferation and apoptosis inducing effects on K562 cells. In order to investigate the relationship between structure and activity of the target compound, we report its crystal structure and biological behavior in the present paper. Crystallographic data: C14H18- ClN3O3S, Mr = 343.82, orthorhombic, space group Pnma, a = 19.786(6), b = 6.789(2), c = 12.938(4) , V = 1738.0(9) 3, Z = 4, Dc = 1.314 g/cm3, F(000) = 720, μ(MoKα) = 0.354 mm-1, R = 0.0378 and wR = 0.0941. The molecule is a planar structure.