A theoretical investigation into the conformational changes of dibenzo-p-dioxin, thianthrene, and selenanthrene

Theoretical ab initio calculations using the HF and B3LYP methods have been carried out to investigate the conformational differences of three cyclic rings, dibenzo-p-dioxin (DPD), thianthrene (THT), and selenanthrene (SET). The physical origin for the conformational preference of each molecule has been studied using the natural bond orbital (NBO) analysis. The NBO results indicate that DPD exists in a planar form due to strong electron delocalization caused by the specific orbital interaction, around the X atom. On the other hand, THT and SET exist as puckered forms with high inversion barriers due to less effective electron delocalization. The NBO analysis also shows that the conformational stabilization in DPD is caused by a more effective overlap of the orbitals, compared with the overlap of the orbitals in THT.     

新显色剂噻二唑偶氮二甲氨基苯甲酸与铜(Ⅱ)显色反应的研究和应用

本文研究了噻二唑偶氮二甲氨基苯甲酸与Cu(Ⅱ)显色反应条件,确定在pH3.0～4.5范围形成蓝紫色络合物,组成比为1:1,摩尔吸光系数ε=4.55×10~4L·mol~(-1)·cm~(-1),1gβ=7.32。应用拟定的方法测定天然水中微量铜,获得满意的结果。     

Synthesis of N,N-diethyldithiocarbamate functionalized 1,4-polyisoprene, from natural rubber and synthetic 1,4-polyisoprene

N,N-Diethyldithiocarbamate functionnalized 1,4-polyisoprenes were prepared from 1,4-polyisoprenes (natural or synthetic). The syntheses were performed by nucleophilic addition of N,N-diethyldithiocarbamate salts upon oxirane rings of epoxidized units according to a SN2 mechanism with ring opening. Studies on model molecules of epoxidized 1,4-polyisoprene units (1,2-epoxy-1-methylcyclohexane and 4,5-epoxy-4-methyloctane) were previously achieved to develop the procedure. The best yields were obtained at low temperature in polar medium, and more especially in water with sodium N,N-diethyldithiocarbamate (DEDT-Na) as reagent. A diastereospecific addition was noted when reaction was performed in water with DEDT-Na. Afterwards, the developed procedure was successfully generalized to epoxidized synthetic polyisoprenes and epoxidized natural rubber (in THF, then in latex medium). Excellent results were obtained in latex medium with epoxidized natural rubber (ENR) latices. As with the models, a diastereospecific addition of sodium N,N-diethyldithiocarbamate trihydrate onto epoxidized 1,4-polyisoprene units of ENR was observed at the condition to bring the latex medium to pH 8 before introduction of DEDT-Na. Influence of temperature, drc, and DEDT-Na concentration were successively examined to determine the best conditions of the addition on ENR latices.     

STUDY ON THE PROPERTIES OF BLEND OF NATURAL RUBBER LATEX/METHYL METHACRYLATE GRAFTED RUBBER LATEX BY GAMMA RADIATION

Natural rubber latex(NRL)and methyl methacrylate(MMA)grafted rubber latex were blended in different ratios and irradiated at various absorbed doses by gamma rays from Co-60 source at room temperature.The tensile properties, swelling ratio and permanent set were measured.The maximum tensile strength and modulus at 500% elongation were obtained at an absorbed dose of 8 kGy.Modulus increases from 6.99 MPa to 9.87 MPa for an increase in proportion of MMA grafted rubber from 40% to 60% in the blend at similar absorbed dose.Elongation at break and swelling ratio decrease with increasing absorbed dose as well as the MMA grafted rubber content in the blends.The decreasing trend of permanent set is high up to 5 kGy absorbed dose,and beyond that dose,it becomes almost flat.     

Determination of dissolved organic nitrogen in natural waters using high-temperature catalytic oxidation

Studies on nitrogen in natural waters have generally focussed on dissolved inorganic nitrogen (DIN), primarily because of relative ease of analysis and the important influence of DIN on water quality. Advances in analytical techniques now permit the systematic study of dissolved organic nitrogen (DON), and this work has shown that DON is quantitatively significant in many waters. This article describes the sampling and analytical protocols required for rapid, precise and reliable determinations of DON, involving high-temperature catalytic oxidation (HTCO), coupled to chemiluminescence detection. This approach simultaneously determines dissolved organic carbon (DOC) and total dissolved nitrogen (TDN), and DON is derived by subtraction of DIN measured by colorimetry. The DON determination is simple to perform, exhibits excellent precision (<1% for C and 1.5% for N) and is applicable to a wide range of natural waters.     

HCN(HNC)与NH3, H2O和HF分子间相互作用的理论研究

在MP2/aug-cc-pVTZ水平上, 对HCN(HNC)与NH3, H2O和HF分子间可能存在的氢键型复合物进行了全自由度能量梯度优化, 通过在相同水平上的频率验证分析发现了稳定的分子间相互作用形式是HCN(HNC)作为质子供体或作为质子受体形成的复合物. 基组重叠误差对总相互作用能的影响均小于3.34 kJ/mol. 通过自然键轨道(NBO)分析, 研究了单体和复合物中的原子电荷和电荷转移对分子间相互作用的影响. 对称性匹配微扰理论(SAPT, Symmetry Adapted Perturbation Theory)能量分解结果表明, 在分子间相互作用中, 静电作用与诱导作用占主导地位, 而诱导作用与复合物的电荷转移之间具有良好的正相关性.     

Studies on accelerated sulphur vulcanization of natural rubber using 1-phenyl-2, 4-dithiobiuret/tertiary butyl benzothiazole sulphenamide

The use of binary accelerators has gained tremendous importance since it increases the production rate of the article made of that elastomer. The authors have analyzed the performance of a novel binary accelerator system in the sulphur vulcanization of natural rubber (NR). The vulcanizates resulting from the binary accelerated process obtained good mechanical properties, ageing and swelling resistance. Network characterization of the mixes was done using swelling measurements, stress-strain analysis etc. The chain entanglement density was measured using dynamic mechanical analysis. However the performance is found to be dependent on the relative proportion of mono, di and polysulphidic linkages in the material. The result of the study points out that the proposed system can be active in NR regardless of the vulcanization recipe and temperature. The performance of the new binary system in filled vulcanizates is also studied. Based on the processing, mechanical and chemical characterization an optimum concentration is suggested for the new system.     

Investigation into the determination of trimethylarsine in natural gas and its partitioning into gas and condensate phases using (cryotrapping)/gas chromatography coupled to inductively coupled plasma mass spectrometry and liquid/solid sorption techniques

Speciation of trialkylated arsenic compunds in natural gas, pressurized and stable condensate samples from the same gas well was performed using (Cryotrapping) Gas Chromatography-Inductively Coupled Plasma Mass Spectrometry. The major species in all phases investigated was found to be trimethylarsine with a highest concentration of 17.8 ng/L (As) in the gas phase and 33.2 μg/L (As) in the stable condensate phase. The highest amount of trimethylarsine (121 μg/L (As)) was found in the pressurized condensate, along with trace amounts of non-identified higher alkylated arsines. Volatile arsenic species in natural gas and its related products cause concern with regards to environment, safety, occupational health and gas processing. Therefore, interest lies in a fast and simple field method for the determination of volatile arsenicals. Here, we use simple liquid and solid sorption techniques, namely absorption in silver nitrate solution and adsorption on silver nitrate impregnated silica gel tubes followed by total arsenic determination as a promising tool for field monitoring of volatile arsenicals in natural gas and gas condensates. Preliminary results obtained for the sorption-based methods show that around 70% of the arsenic is determined with these methods in comparison to volatile arsenic determination using GC-ICP-MS. Furthermore, an inter-laboratory- and inter-method comparison was performed using silver nitrate impregnated silica tubes on 14 different gas samples with concentrations varying from below 1 to 1000 μg As/m³ natural gas. The results obtained from the two laboratories differ in a range of 10 to 60%, but agree within the order of magnitude, which is satisfactory for our purposes.     

Synthesis of the common left-half part of pectenotoxins

The common left-half [C31-C33(OC1-C7)-C40] part of pectenotoxins has been synthesized convergently from the C31-C35, C36-C40, and C1-C7 parts. The C31-C35 part, prepared via a new route shorter than our previous route, was coupled with the C36-C40 part through reductive lithiation and addition reactions to give an adduct stereoselectively, which was converted to a cyclic acetal corresponding to the C31-C40 part. The left-half was synthesized by a three-step process including esterification of the C31-C40 part with the C1-C7 part.     

Determination of butyltins in environmental samples using sodium tetraethylborate derivatisation: characterisation and minimisation of interferences

Interferences affecting the determination of butyltin species by sodium tetraethylborate (STEB) derivatisation followed by purge-trap preconcentration were systematically studied using synthetic solutions, natural water samples and sediment extracts. Substances that did not cause interferences included most common cations (apart from those metal ions listed below), anions, metalloids and polar organic compounds. Natural organic matter (NOM) specifically interfered with tributyltin (TBT) due to a mechanism involving partitioning of the butyltin to the hydrophobic portions of the NOM. The metal ions Ag(I) (≥2 μM), Cd(II) (≥2 μM), Cu(II) (≥0.5 μM) interfered predominantly with the determination of monobutyltin (MBT) due to catalytic degradation of the STEB reagent. Pb(II) (≥14 μM) interfered with butyltin determination by an unknown mechanism. Other interferences to the purge-trap method were shown to occur in the presence of chelating agents (e.g. EDTA) or hydrophobic liquids such as diesel fuel. A mixture comprising methanol (MeOH), EDTA and Mn(II) was used to partially mask the effect of interfering NOM and metals. Spike recoveries (mean±S.D. of n=7 different samples) of MBT, dibutyltin (DBT) and TBT in contaminated natural water samples were improved from 70±36,90±11 and 91±24 to 102±10,98±3 and 98±4%, respectively. Spike recoveries (mean±S.D. of n=5 different samples) of MBT, DBT and TBT in aliquots of sediment extracts were improved from 86±17,79±18 and 59±32 to 97±6.2,103±3.6 and 103±5.0%, respectively. The ability to analyse larger aliquots of sediment extracts in the presence of the masking mixture improved the detection limit four-fold if MBT and DBT determination was required and 10-fold if only TBT determination was required.