Electrochemical response of ascorbic acid at conducting and electrogenerated polymer modified electrodes for electroanalytical applications: a review

The present short review deals with electroanalytical aspects of electrochemical response of ascorbic acid (Vitamin C) at conducting and electrogenerated polymer modified electrodes. Two main topics are considered: (i) electrocatalytic oxidation of ascorbate at conducting polymer modified electrodes, leading to electroanalytical techniques for ascorbate assay, and (ii) retardation of ascorbate penetration through a layer of electrogenerated polymers, leading to permselective coatings and their diverse uses, especially for biosensing devices.     

Trace level analysis of volatile and semi-volatile organic compounds in water using a membrane/jet separator interfaced to an ion trap mass spectrometer

An ion trap mass spectrometer, equipped with a membrane/jet separator interface, is used for the direct detection of volatile and semi-volatile organic compounds in aqueous solutions. Aqueous sample is passed through a capillary membrane, the outside surface of which is continuously purged by helium. The permeate is pneumatically transported to the mass spectrometer via a jet separator which acts as an additional enrichment device. The performance and response characteristics of non-porous silicone and microporous polytetrafluoroethylene (PTFE) membranes are studied. The microporous membrane allows sufficient water to pass for it to be used as a reagent gas for chemical ionization. Both types of membranes provide detection limits in the parts per trillion (pptr) to parts per billion (ppb) range with a linear dynamic range of 3 orders of magnitude for some volatile organic compounds. Results show that there is no detectable matrix effect on response in the selected cases examined. The use of microporous membranes to analyze more polar compounds, such as 5-hydroxymethyl furfuraldehyde and lactic acid, is also demonstrated. The effects of other experimental parameters, such as membrane temperature and length, on sensitivity are also investigated.     

PhenNO—TTA—乳化剂OP荧光光度法测定微量铕

研究了Ｅｕ（Ⅲ）－ＰｈｅｎＮＯ－ＴＴＡ－乳化剂ＯＰ体系的荧光性质及其用于微量铕的测定。该体系具有良好的分析特性，最低检测限可达７．０×１０＾－１４ｍｏｌ／Ｌ．     

Stainless steel capillary columns for high temperature gas chromatography

A layer of elemental silicon has been deposited on the surface of stainless steel tubing by means of chemical vapor deposition (CVD). Two kinds of capillary column were prepared from the deactivated tubing: cross-linked, silanol-terminated polydime-thylsiloxane wall coated open tubular (WCOT) columns and molecular sieve 13X porous layer open tubular (PLOT) columns. Unlike fused silica capillary columns, stainless steel WCOT and PLOT columns can be operated at temperatures in excess of 400°C. High temperature simulated distillation has been performed successfully with a macro bore WCOT column and rapid PNA (paraffin, naphthene, and aromatic) analysis with a multidimensional gas solid chromatographic (GSC) system using PLOT columns.     

Fermentation characteristics and the dynamic trend of chemical components during fermentation of Massa Medicata Fermentata

As a representative of traditionally fermented Chinese medicine, Massa Medicata Fermentata (MMF) shows the functions of invigorating the spleen and stomach and promoting digestion, which plays an important role in the treatment of gastrointestinal diseases. The fermentation mechanism and the key factors that affect the quality of MMF have not been revealed yet, which has become an urgent issue that limits its clinical application. This article aims to systematically and comprehensively reveal the transformation of physical properties and the dynamic trend of chemical components including substrate components, volatile components, and lactic acid as anaerobic fermentation product during MMF fermentation. Along with obvious hyphae growth observed for MMF, the weight of MMF decreased, and the moisture and temperature increased. Through the quantified 14 components from substrate, ferulic acid increased from 45.53 ± 6.94 to 141.89 ± 78.40 μg/g, while glycosides and phenolic acids declined except caffeic acid. Also, within the 66 volatile components analyzed, alcohols and acids increased, while aldehydes and ketones decreased. Lactic acid was not detected in the fermentation substrate, but an apparent increase in lactic acid content was observed along with the increased fermentation days, resulting in 2.54 ± 0.15 mg/g on day 8. Based on the tested components, the fermentation process of MMF was discriminated into three distinct stages by principal component analysis, and an optimal fermentation time of four days was proposed. The results of this study will be of great significance to clarify the characteristics of fermentation and conduce to improving quality standards of MMF.     

Automatic flow procedure for the determination of glycerol in wine using enzymatic reaction and spectrophotometry

An automatic flow procedure for the determination of glycerol in wines by employing a flow system based on multicommutation and enzymatic reaction is described. Glycerol dehydrogenase was immobilized on aminopropyl glass beads and packed into a column that was coupled to the flow system. The NADH produced by the enzymatic reaction was monitored by spectrophotometry at 340 nm and its radiation absorption presented a relationship with glycerol concentration. The system manifold comprised a set of three-way solenoid valves controlled by a microcomputer, which was furnished with electronic interfaces and runs a software that was designed to carry out on-line sample dilution, reagent addition, and data acquisition. The procedure allows the determination of glycerol in wine samples without any prior pretreatment. The procedure presented as profitable features a linear response range between 2.0 and 10.0 g l⁻¹ glycerol (R=0.998), a detection limit of 0.006 g l⁻¹ glycerol, a relative standard deviation of 1.8% (n=14) for a typical wine sample presenting 5.3 g l⁻¹ glycerol, a sampling throughput of 33 determinations per hour, and a NAD⁺ consumption of 0.8 mg per determination. The results were compared with those obtained using a reference method and no significant difference at 90% confidence level was observed.     

On the Criteria of Instability for Electrochemical Systems

Both cyclic-voltammetry-based and impedance-based experimental criteria that have been developed recently for the oscillatory electrochemical systems are critically appraised with two typical categories of oscillators.Consistent conclusions can be drawn by the two criteria for the category of oscillators that involve the coupling of charge transfer mainly with surface steps(e.g.ad-and desorption)such as in the electrooxidation of C1 organic molecules.Whereas,impedance-based criterion is not applicable to the category of oscillators that involve the coupling of charge transfer mainly with mass transfer(e.g.diffusion and convection) such as in the Fe(CN)6^3- reduction accompanying periodic hydrogen evolution.The reason is that the negative impedance cannot include the feedback information of convection mass transfer induced by the hydrogen evolution.However,both positive and negative nonlinear feedbacks,i.e., the diffusion-limited depletion and convection-enhanced replenishment of the Fe(CN)6^3- surface concentration,that coexist between the bistability,i.e.,Fe(CN)6^3- reduction with and without hydrogen evolution at lower and higher potential sides respectively,are all reflected in the crossed cyclic voltammogram(CCV).It can be concluded that the voltammetry-based criterion(in time domain)is more intuitive,less time-consuming and has a wider range of applications than the impedancebased one (in frequency domain).     

Simultaneous determination of traces of heavy metals by solid-phase spectrophotometry

A coupling sensitive solid phase spectrophotometric (SPS) procedure for determination of traces of heavy metals (Me-SPS) and multicomponent analysis by multiple linear regressions (MA), a simple methodology for simultaneous determination of metals in mixtures was inaugurated. The Me-SPS procedure is based on sorption of heavy metals on PAN-resin and direct absorbance measurements of colour product Me-PAN sorbed on a solid carrier in a 1-mm cell. This methodology (Me-SPS-MA) was checked by simultaneous determination of metals in synthetic mixtures with different compositions and contents of metals important in pharmaceutical practice: Zn, Pb, Cd, Cu, Co, and Ni. Good agreement between experimental and theoretical amounts of heavy metals is obtained from the recovery test (78.3–110.0%). The proposed method enables determination of particular metal ion at the ng mL⁻¹ level and it was successfully applied to the determination impurities from heavy metal traces in pharmaceutical substances (Cu in ascorbic acid, Pb in glucose, and Zn in insulin). The proposed procedure could be possible contribution to the development of pharmacopoeial methodology for a heavy metals test.     

Thermal behaviour of the homopolynuclear glyoxylate complex combinations with Cu(II) and Cr(III)

Homopolynuclear complexes of Cu(II) respectively Cr(III) with the glyoxylate dianion, C₂H₂O₄ ^2-, have been studied in non-isothermal regime in air and nitrogen. The results of the non-isothermal analysis performed for the synthesised complexes, Cu(C₂H₂O₄)·0.5H₂O, respectively [Cr₂(OH)₂(C₂H₂O₄)₂(OH₂)₄]·2H₂O, correlated with the results of the IR and TG analysis of the compounds obtained by thermal treatment from the initial complexes and the results of the GLC and XR analysis have led to the establishment of the thermal decomposition mechanisms for the two studied complexes. The decomposition mechanisms confirm the stoichiometric and structural formulae proposed for the two synthesised homopolynuclear complexes. This revised version was published online in July 2006 with corrections to the Cover Date.     

Determination of carbonyl compounds in air by HPLC using on-line analyzed microcartridges,fluorescence and chemiluminescence detection

Summary Sensitive and selective detection of dansylhydrazones of atmospheric carbonyl compounds (aldehydes and ketones) can be achieved using high performance liquid chromatography (HPLC) with fluorescence or chemiluminescence detection. The carbonyl compounds are derivatized by drawing air through small glass cartridges packed with porous glass particles impregnated with dansylhydrazine. After sampling, the contents of the cartridges are analyzed on-line by using a small plug of water (200 L) to transfer and focus the hydrazone derivatives at the head of a HPLC column. Greatly increased sensitivity over traditional methods derives from 1) analysis of the entire contents of the sampling cartridge, and 2) detection by fluoresence or peroxyoxalate chemilum-inescence. Results are compared for photo-initiated and H₂O₂-initiated peroxyoxalate chemiluminescence. This novel and practical system enables the detection of sub-ppbv concentrations of formaldehyde, acetaldehyde, acetone and higher carbonyls in air using relatively short sampling times.