弯曲狭窄管内血液流的分析

与血管狭窄有关的异常血液动力学特征在血管疾病的发生和发展过程中起着重要的作用,由于血管狭窄和弯曲的综合影响,将会出现一系列有趣的流体力学现象,本文研究具有对称狭窄的弯曲小动脉内定常血液流动,在一定的假设条件下,直接从支配血液流动的Navier-Stokes方程求出问题的摄动解,由此求得弯曲狭窄管內血液流动的轴向速度、二次流速度及压力梯度等分析表达式,并进一步求得轴向和周向血管壁切应力。本文的结果是先前有关狭窄直管和弯曲均匀管流动研究的拓广。     

Steady and modulated flow of an Ostwald fluid around a rotating disk

The solutions of the continuity equation and the equations of motion of the flow in the vicinity of a rotating disk have been established for an Ostwald fluid under steady-state conditions and in modulated flow around a mean value. Under steady-state conditions, the kinematics of the flow is scarcely dependent on the rheological parameters close to the disk, however, for n < 1 long-range effects have been put forward. For modulated flow, in the high-frequency range, a behaviour very different from that observed for a Newtonian fluid was found. In the low-frequency range an asymptotic solution has been proposed which is of special interest in mass transfer problems.Presented at the Second Conference of European Rheologists, Prague, June 17–20, 1986     

A three-parameter model describing the experimental relation between shear stress and shear rate for laminar flow of aqueous polymer solutions

Summary A three-parameter model is introduced to describe the shear rate — shear stress relation for dilute aqueous solutions of polyacrylamide (Separan AP-30) or polyethylenoxide (Polyox WSR-301) in the concentration range 50 wppm – 10,000 wppm. Solutions of both polymers show for a similar rheological behaviour. This behaviour can be described by an equation having three parameters i.e. zero-shear viscosity ₀, infinite-shear viscosity , and yield stress ₀, each depending on the polymer concentration. A good agreement is found between the values calculated with this three-parameter model and the experimental results obtained with a cone-and-plate rheogoniometer and those determined with a capillary-tube rheometer.

---

Zusammenfassung Der Zusammenhang zwischen Schubspannung und Schergeschwindigkeit von strukturviskosen Flüssigkeiten wird durch ein Modell mit drei Parametern beschrieben. Mit verdünnten wäßrigen Polyacrylamid-(Separan AP-30) sowie Polyäthylenoxidlösungen (Polyox WSR-301) wird das Modell experimentell geprüft. Beide Polymerlösungen zeigen im untersuchten Schergeschwindigkeitsbereich von ein ähnliches rheologisches Verhalten. Dieses Verhalten kann mit drei konzentrationsabhängigen Größen, nämlich einer Null-Viskosität ₀, einer Grenz-Viskosität und einer Fließgrenze ₀ beschrieben werden. Die Ergebnisse von Experimenten mit einem Kegel-Platte-Rheogoniometer sowie einem Kapillarviskosimeter sind in guter Übereinstimmung mit den Werten, die mit dem Drei-Parameter-Modell berechnet worden sind.

---

a Pa^–1 physical quantity defined by:a = {1 – ( / ₀)}/ ₀ - c l concentration (wppm) - D m capillary diameter - L m length of capillary tube - P Pa pressure drop - R m radius of capillary tube - u m s^–1 average velocity - v _r m s^–1 local axial velocity at a distancer from the axis of the tube - shear rate (–dv _r /dr) - local shear rate in capillary flow - s^–1 wall shear rate in capillary flow - Pa s dynamic viscosity - _a Pa s apparent viscosity defined by eq. [2] - ( _a ) Pa s apparent viscosity in capillary tube at a distanceR from the axis - ₀ Pa s zero-shear viscosity defined by eq. [4] - Pa s infinite-shear viscosity defined by eq. [5] - l ratior/R - kg m^– density - Pa shear stress - ₀ Pa yield stress - _r Pa local shear stress in capillary flow - _R Pa wall shear stress in capillary flow _R = (PR/2L) - _v m³ s^–1 volume rate of flow With 8 figures and 1 table     

Molecular Dynamics Simulations of a β-Hairpin Fragment of Protein G by Means of Atom-Bond Electronegativity Equalization Method Fused into Molecular Mechanics (ABEEMσπ/MM)

There are some controversial opinions about the origin of folding β‐hairpin stability in aqueous solution. In this study, the structural and dynamic behavior of a 16‐residue β‐hairpin from B1 domain of protein G has been investigated at 280, 300, 350 and 450 K using molecular dynamics (MD) simulations by means of Atom‐Bond Electronegativity Equalization Method Fused into Molecular Mechanics i.e., ABEEMδπ/MM and the explicit ABEEM‐7P water solvent model. In addition, a 300 K simulation of one mutant having the aromatic residues substituted with alanines has been performed. The hydrophobic surface area, hydrophilic surface area and some structural properties have been used to measure the role of the hydrophobic interactions. It is found that the aromatic residues substituted with alanines have shown an evident destabilization of the structure and unfolding started after 1.5 ns. It is also found that the number of the main chain hydrogen bonds have different distributions through three different simulations. All above demonstrate that the hydrophobic interactions and the main chain hydrogen bonds play an important role in the stability of the folding structure of β‐hairpin in solution. Furthermore, through the structural analyses of the β‐hairpin structures from four temperature simulations and the comparison with other MD simulations of β‐hairpin peptides, the new ABEEMδπ force field can reproduce the structural data in good agreement with the experimental data.     

(SrTiO_3)_(1-x)(SrTaO_2N)_x固溶体的制备及光催化性能研究(英文)

通过高温固相反应合成了N掺杂的SrTiO3和(SrTiO3)1-x(SrTaO2N)x固溶体,对其进行了X射线衍射,紫外可见吸收光谱,X射线光电子能谱分析和比表面积的表征。随x由0增大至0.4,固溶体带隙变窄,由3.2eV降至2.3eV,吸收光谱由紫外光区扩展到可见光区。在甲醇溶液(50mLCH3OH+220mLH2O)中进行了光催化分解水产生氢气的反应,在硝酸银溶液(270mL,0.01mol·L-1)中进行了光催化分解水产生氧气的反应,在可见光(λ420nm)照射下,实现了可见光响应的光催化分解水。     

铈锆固溶体的合成及其在CH_4和CO催化燃烧反应中的应用

分别利用固态反应和共沉淀法制备了铈锆固溶体,并以其为载体制备了车用三效催化剂,考察其在CH4和CO催化燃烧反应中的作用.研究发现固态反应法所得固溶体孔分布较宽,热稳定性较差,但表面较多的缺陷位贡献于其较高的储氧性能.而共沉淀法所得样品拥有较高的热稳定性和催化活性.固溶体的还原性质可以通过铈锆比调控.关联催化剂对CH4和CO的催化氧化性能发现,具有较大比表面积、集中孔径分布和较高储氧能力的固溶体显示了较低的催化剂起燃温度和较高的催化活性.     

基于超支化温敏聚合物制备温敏金纳米粒子

通过对不同分子量的超支化聚乙烯亚胺(hyperbranched polyethyleni mine,HPEI)的端基进行部分或完全异丁酰胺(isobutyric amide,IBAm)化,可以制备一系列具有不同低临界溶解温度(Lower Critical SolutionTemperature,LCST)的超支化温敏聚合物HPEI-IBAm。通过离子键或氢键之间的相互作用,所得超支化温敏聚合物可以吸附于柠檬酸钠还原并稳定的14nm的金纳米粒子(AuNP)的表面,从而得到具有温敏性质的金纳米粒子。所得温敏金的LCST都低于其相应的温敏聚合物,其差值在0.8至6℃之间。在pH值为9.18的缓冲溶液中,通过改变所用聚合物的分子量以及异丁酰胺基团的取代度,所得温敏金的LCST可控制在21.7~48.2℃之间。此外,所得温敏金的LCST也是pH值敏感的,通过溶液pH值的改变,所得温敏金的LCST值可以在更宽的范围内调节。增加溶液的碱性,LCST可能变化不大或降低,减小溶液的碱性会使LCST升高,直到消失。在偏酸的条件下,所得金复合物通常发生聚集,变得不稳定。此外,溶液中的盐度对所得温敏金的LCST也有影响,氯化钠和硫酸钠会降低其LCST,尤其是硫酸钠的效果更显著。     

Prediction of aqueous solubilities of solid carboxylic acids with COSMO-RS

The methodology for the prediction of aqueous solubilities of solid organic compounds, and their temperature dependence, based on the Conductor-like Screening Model for Real Solvents (COSMO-RS/COSMOtherm) procedure, is presented and evaluated. The predictive capability of the quantum chemistry based program and the applied methodology was tested on the most common solid carboxylic acids. From the temperature dependence of the solubilities, the mean apparent enthalpies of solution were derived. The results obtained for a set of 27 carboxylic acids, consisting of aromatic carboxylic acids, dicarboxylic acids, as well as hydroxycarboxylic acids, are in good agreement with the experimental solubility data and their dependence with the temperature. The mean apparent enthalpies of solution, although of the same order of magnitude of the experimentally values, seem to be systematically underestimated.     

Electro-electrodialysis of HI–I2–H2O mixture using radiation-grafted polymer electrolyte membranes

In the thermochemical water-splitting iodine–sulfur process for hydrogen production, new polymer electrolyte membranes were applied in an electro-membrane process (electro-electrodialysis, EED) to increase the HI molality of HIx solution (HI + I₂ + H₂O mixture) to be over quasi-azeotropic. Radiation grafting of a styrene monomer into a poly(ethylene-co-tetrafluoroethylene) base film and subsequent sulfonation provided electrolyte membranes that had ion exchange capacities (IECs) of 1.1–1.6 mmol/g. With the EED of the HIx solutions using [HI] = [I₂] = 10 mol/kg at 40 °C the transport number of protons, ratio of permeated quantities of water to the protons, and current efficiency all appeared to depend on the IEC of the resulting membranes. When compared to Nafion, the self-made membranes exhibited lower electric cell resistance, and thereby decreasing up to 32% of the overall energy required in the concentration operation.