差分吸收光谱法测量大气污染的测量误差分析

差分吸收光谱技术被广泛地应用于测量大气中微量元素的浓度，尽管该技术利用最小二乘法来反演待测气体的浓度，能够得到很高的测量精度。但是，由于仪器本身的噪声以及测量波段其它气体的干扰等，使得仪器的测量有一定的误差，而且上述因素还决定着仪器的测量下限。对差分吸收光谱方法的测量误差以及引起误差的原因作了详细的分析。     

宽带膜厚实时监控过程中膜层折射率的确定方法

为了准确计算出镀膜过程中每层膜的折射率，介绍了实时监控过程中确定膜层折射率的2种方法：一种是由实测的透射比光谱直接反算出膜层的折射率；另一种是用最小二乘法的优化算法实时拟合折射率。试验结果表明：在线反算适合单点监控，所得折射率误差小于2%。然而在实际镀膜过程中,由于宽带内膜层参数误差较大,一般大于25%。为此，采用最小二乘法拟合，即在整个宽光谱范围内采集每个波长点的信息，所得结果误差很小，一般都在2％～5%之间,有时可达到10%,在很大程度上提高了实际镀膜时膜厚监控的精度。     

用γ计数率的变化定位核元件的技术研究

用标准放射源进行模拟核材料库房监控实验,当放射源被转移出系统的时候,在不同位置探测了γ计数率变化,根据γ计数率变化的距离平方反比规律实现了被转移的放射源的定位,并估算了该放射源的源强.     

一种新型波长转换器的模块化设计

对一种新型结构全光波长转换器进行了高精度、高稳定度的模块化设计，并利用该模块实现对波长转换器参数的监控。结果表明这种新型模块对波长转换器的实现提供了可靠的保证，表现出较高的稳定度和实用性。     

Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

Structure and Structural Nonrigidity of Tetrachlorodibenzo-p-Dioxin Radical Cations

Ab initio calculations showed that the tetrachlorodibenzo-para-dioxin radical cations (TCDD RCs) with a planar structure have two steady states with asymmetric dioxin cycles. The activation barriers between these states are up to 2 kcal/mole, so that the RCs may be regarded as being structurally nonrigid within the dioxin cycle. The 2,3,7,8-TCDD RC is more stable than the 1,4,6,9-TCDD RC, the energy difference being 5.2 kcal/mole. The adiabatic ionization potential of 2,3,7,8-TCDD (7.54 eV) is 0.1 eV smaller than the corresponding potential of 1,4,6,9-TCDD. These factors account for the increased hemoproteide affinity and hence increased biological activity of 2,3,7,8-TCDD.     

Influence of radiation on thin ZnS-Tb films

Changes in thin zinc-sulfide films under the action of the γ-radiation of Co⁶⁰ are studied by investigating electroluminescence spectra of terbium embedded in these films as a luminescent probe. It is shown that changes in the relation of the intensities of bands, a decrease in their halfwidth and the background component, and simplification of the spectrum are observed in a short-wave region of the Tb radiation spectrum that corresponds to⁵D₃→⁷F_j transitions. The same modification of the radiation spectrum is characteristic of ZnS films whose crystalline structure is ordered in the course of thermal annealing at a temperature of 350°C. Based on the analysis of the data obtained it is inferred that irradiating the ZnS films with small radiation doses of 10⁴–10⁵ rad leads to the ordering of their crystalline structure due to the elimination of one of the types of structural defects. Institute of Physics of Semiconductors, National Academy of Sciences of Ukraine, 45, Nauka Ave., Kiev-28, 252650. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No. 3, pp. 338–341, May–June, 1997.     

高压下聚苯胺的结构和电性能研究

 以金刚石压腔高压装置为工具，用Ⅱ型金刚石作压砧兼红外窗口，对本征态聚苯胺进行了高压（0~8.4 GPa）就位红外光谱测试。结果表明：在4.8~5.2 GPa压力区间，代表醌环振动的吸收峰相对代表苯环振动的吸收峰变小，表明聚苯胺在此压力区间结构上发生了显著变化，且这种变化是不可逆的。聚苯胺的高压（0~14.5 GPa）电阻测量结果表明：当压力小于7.5 GPa时，电阻随压力升高而显著降低，据此认为聚苯胺为电子性导电物质；在7.5 GPa处电阻出现极小值，然后又缓慢升高，至10 GPa后基本不变。推测聚苯胺电阻极小值是由结构变化引起的。至于红外光谱与电阻测量结果反映聚苯胺结构变化的压力值不一致，可能是由于测试条件不同所致。     

Membrane introduction mass spectrometry

An overview of membrane introduction mass spectrometry (MIMS) is presented and comparisons are made with other direct sample introduction techniques. Special attention is given to the unique advantages and the limitations of newer variants on the MIMS technique, including affinity MIMS, reverse-phase and trap MIMS. The salient features of the interfaces used in MIMS are summarized and the various membrane materials commonly used are delineated. The applicability of MIMS is illustrated via discussion of

1. (i) bioreactor monitoring (represented by yeast fermentation),

2. (ii) environmental monitoring (illustrated by analysis of contaminated ground water samples) and

3. (iii) on-line chemical reaction monitoring (exemplified by the photolysis of aryl esters).

The applicability of MIMS to the analysis of environmental samples, including complex mixtures in water, air and soil, is noted.     

激光除锈过程的实时监测技术研究

对激光除锈过程中的实时监测技术进行了实验研究,结果表明:除锈过程中产生的声波强度会随着表面清洁度的变化而发生明显的变化,声波信号包含了除锈过程中的大量信息,可作为激光除锈实时监测的基本信号.