PbO2阳极在硫酸溶液中的析氧失活行为

采用热分解鄄电镀法制备了以Sb 掺杂SnO₂(Sb-SnO₂)为底层的Ti 基PbO₂阳极(Ti/PbO₂). 采用加速电解寿命测试、电化学阻抗谱、XRD、SEM-EDX 等技术, 研究了Ti/PbO₂阳极在硫酸溶液中的电解失效行为和机制.结果表明,在新制备的PbO₂镀层中, 由于氧空位的存在, PbO₂镀层的内应力表现为拉应力, 随着电解的进行, 阳极表面生成的活性氧原子在向基底扩散的过程中, 将Pb³⁺态氧化为Pb⁴⁺态, 逐渐占据镀层内作为自由电子施主的氧空位, 这不仅导致镀层的导电性能下降, 同时使镀层的应力逐渐由拉应力转变为压应力, 镀层性质逐渐劣化. 这一过程基本结束时,活性氧原子才大量扩散至Ti基底导致基底的钝化, 在Ti 基底和镀层界面出现显著的界面应力, 在界面应力和镀层内压应力的共同作用下, 阳极出现鼓泡、脱落, 迅速进入失活阶段.     

Shape analysis based critical Eotvos numbers for buoyancy induced partial detachment of oil drops from hydrophilic surfaces

Removal of oil drops from solid surfaces immersed in an aqueous medium is of interest in many applications. It has been shown that drop shape analysis can be used to predict conditions at which the stability limit of a lighter than water oil drop on a solid surface immersed in an aqueous bath is reached (Adv. Colloid Interface Sci. 98 (2002) 265). However the above analysis is restricted to cases where the contact angle made by the drop is below 90degrees and when the surface conditions result in a 'pinned' contact line. In this paper, it is shown that drop shape analysis can be used to predict the critical conditions at which drop stability limit is reached for drop contact angles of 90degrees and above, which is encountered with 'hydrophilic' surfaces. This critical condition can predict the occurrence of partial oil drop detachment, before complete removal due to 'roll-up', which occurs when the hydrophilic surface is adequately smooth which prevents 'pinning' of the contact line. The critical conditions at which partial drop detachment occurs can also be approximately predicted from simple force balances. It has been shown (Adv. Colloid Interface Sci. 98 (2002) 265) that for contact angles less than 90degrees, the critical limit based on shape analysis appears to resolve the differences that arise due to alternate expressions for capillary retention force. This paper shows that even for contact angles above 90degrees, the critical conditions predicted from the shape analysis resolves the differences in the predictions from the alternate force balances. Drop shape analysis used in this paper is based on the 'Arc-length' form of Young-Laplace or 'drop shape' equation, which is different from the 'Y vs X' form of the above equation that is used in Adv. Colloid Interface Sci. 98 (2002) 265. The above drop shape equation is solved by a fourth order Runge-Kutta technique and it is shown that for angles less than 90degrees, the two forms of the drop shape equation, predict almost identical values of the critical Eotvos number. This paper highlights the competing effects of interfacial tension lowering induced drop instability and 'roll-up', a term that is used to describe the retraction of the contact line of an oil drop on a surface, in being the primary c ause for drop detachment.     

RESEARCH ANNOUNCEMENTS ON “DPK: DEEP NEURAL NETWORK APPROXIMATION OF THE FIRST PIOLA-KIRCHHOFF STRESS”

1 Introduction and Main Results Consider the first Piola-Kirchhoff stress P defined as[1]P(F)=?W(F)/?F,(1.1)where F and W refer to the deformation tensor and strain energy density.Due to the principle of material frame-indifference and the material symmetry,two important constraints should be satisfied by these relations[1].     

Residual stress/strain analysis in thin films by X-ray diffraction

Residual stresses are found in the majority of multilayer thin film structures used in modem technology. The measurement and modeling of such stress fields and the elucidation of their effects on structural reliability and device operation have been a “growth area” in the literature, with contributions from authors in various scientific and engineering disciplines.

In this article the measurement of the residual stresses in thin film structures with X-ray diffraction techniques is reviewed and the interpretation of such data and their relationship to mechanical reliability concerns are discussed.     

Effects of steric and hydrophobic forces on the rheological properties of ZrO2 suspensions

 The effect of pH on the flow behavior of ZrO₂ suspensions containing polyacrylic and octanoic acids was evaluated. In the flocculated pH regime, the flow behavior is highly shearthinning and can be described by a power-law model. The shear-thinning behavior increases with increasing degree of flocculation. Maximum shearthinning was observed at the zero zeta potential condition. Hydrophobic interaction arising from adsorbed octanoic acid was found to enhance the shear-thinning behavior. No such enhancement was observed for adsorbed polyacrylic acid. It was also illustrated that the viscosity–pH behavior is a mirror image of the yield stress–pH behavior. A quantitative particle-pair interactions model incorporating steric and hydrophobic interactions was proposed to explain the effects of polyacrylic and octanoic acids on the maximum yield stress. Received: 23 May 1997 Accepted: 4 June 1997     

Development of an HPLC method with electrochemical detection of femtomoles of 8-oxo-7,8-dihydroguanine and 8-oxo-7,8-dihydro-2'-deoxyguanosine in the presence of uric acid

A selective method based on high performance liquid chromatography with electrochemical detection (HPLC-ECD) was developed to enable simultaneous detection of 8-oxo-7,8-dihydroguanine (8-oxoGua) and 8-oxo-7,8-dihydro-2′-deoxyguanosine (8-oxodGuo), products of DNA oxidative damage, in the presence of uric acid (UA), a strong interferent in their electrochemical detection. The method developed consists of HPLC isocratic elution with amperometric detection on a glassy carbon electrode, enabling a detection limit for 8-oxoGua and 8-oxodGuo lower than 1 nM in standard mixtures. Detection of low concentrations up to 25 nM of 8-oxoGua and 8-oxodGuo in the presence of UA in a 10⁴-fold higher concentration was achieved after one-step solid phase extraction (SPE). The method was tested with urine samples and it was possible to detect and quantify the presence of 8-oxoGua, and to confirm that UA was eliminated after uricase degradation and SPE. The LOD found in urine samples was about 80 nM, a value higher than in standard mixtures, due to the increase of background current in the urine matrix. The results presented here contribute to the development of a methodological approach to simultaneous determination of 8-oxoGua and 8-oxodGuo in urine samples.     

Effect of molecular orientation distribution and crystallinity on the measurement of the crystal lattice modulus of nylon 6 by x-ray diffraction

The crystal lattice modulus of nylon 6 (-type) was measured by x-ray diffraction using nylon 6 films drawn up to five times. The measured crystal lattice modulus was 173–175 GPa for all specimens whose crystallinity and the Young's modulus were beyond 46% and 3.75 GPa, respectively. These results indicate that a state of homogenous stress can be achieved. In contrast, the values were scattered for the speciments whose crystallinity and Young's modulus are less than the above values. To study the origin, a numerical calculation of the crystal lattice modulus, as measured by x-ray diffraction, was carried out by considering effects on the orientation factors of molecular chains and crystallinity. In this calculation, a previously introduced model was employed, in which oriented crystalline layers are surrounded by oriented amorphous phases so that the strains of the two phases at the boundary are identical. The theoretical results calculated by the introduced model indicated that the crystal lattice modulus by x-ray diffraction is almost equal to the intrinsic crystal modulus if the morphology of the test specimen can be represented as a series model. In contrast, if a parallel model is more appropriate, the difference between the measured modulus and the intrinsic value can be pronounced. Such morphological dependence was found to be less pronounced with increasing high degree of molecular orientation and crystallinity.     

酸雨胁迫及稀土农用条件下菠菜及其土壤中稀土元素的赋存

利用盆栽实验研究了酸雨胁迫、稀土农用条件下 ,菠菜及其土壤中稀土元素的含量及分布特征。结果表明 :菠菜地上部分的REE含量为 0 .5 2 7～ 0 .696μg·g- 1 之间 ,地下部 2 .668～ 3 .0 0 3 μg·g- 1 。土壤 2 2 9.0 9～ 2 5 0 .3 μg·g- 1 。酸雨明显地影响作物对REE的吸收和利用 ,酸度越大 ,影响越明显。随着酸雨酸度的增大、植株体内、土壤中的REE受淋洗的作用加强而表现出REE的总量随着pH的减小而逐渐减少。施用稀土后 ,植株的地上或地下部分及其土壤中的REE含量均与对照的土壤中的REE分配模式基本相同 ,遵循稀土元素分布丰度的奇偶 (Oddo Harkins)规则、轻稀土富集 ,Eu弱负异常 ,富铈配分型 ,表明稀土元素仍然主要来自土壤并受其影响。     

SHAPE MEMORY EFFECT OF PU IONOMERS WITH IONIC GROUPS ON HARD-SEGMENTS

SMPU （shape memory polyurethane） non-ionomers and ionomers, synthesized with poly（c-caprolactone） （PCL）, 4, 4＇-diphenylmethane diisocyanate （MDI）, 1,4-butanediol （BDO）, dimethylolpropionic acid （DMPA） were measured with cyclic tensile test and strain recovery test. The relations between the structure and shape memory effect of these two series were studied with respect to the ionic group content and the effect of neutralization. The resulting data indicate that, with the introduction of asymmetrical extender, the stress at 100% elongation is decreased for PU non-ionomer and ionomer series, especially lowered sharply for non-ionomer series; the fixation ratio of ionomer series is not affected obviously by the ionic group content; the total recovery ratio of ionomer series is decreased greatly. After sufficient relaxation time for samples stretched beforehand, the switching temperature is raised slightly, whereas the recovery ratio measured with strain recovery test method is lowered with increased DMPA content. The characterization with FT-IR, DSC, DMA elucidated that, the ordered hard domain of the two series is disrupted with the introduction of DMPA which causes more hard segments to dissolve in soft phase; ionic groups on hard segment enhance the cohesion between hard segments especially at high ionic group content and significantly facilitate the phase separation compared with the corresponding non-ionomer at moderate ionic group content.     

低温低内应力化学镀镍工艺的研究

化学镀广泛应用于非金属的电镀、电铸前的施加导电层。化学镀沉积层质量与其在零件上的附着力有着密切的关系 ,重视对化学镀沉积层内应力的研究 ,开发一个低温、低内应力的化学镀镍工艺 ,对于化学镀沉积层的推广应用有着十分重要的意义。本文采用正交实验方法对低温、低内应力化学镀镍工艺进行了系统研究 ,开发出了一个低温、低内应力的化学镀镍工艺。在实验过程中发现沉积层内应力同其在零件上的结合力具有密切关系并对其进行了初步探讨。1　实验方法1 1　正交实验根据探索性实验结果分析 ,影响化学镀镍层内应力σ和沉积层速率ｒ的主要因…