Residual stress and deformation during rapid cooling process in an epoxy plate

Residual stress in the epoxy plate during a rapid cooling process was measured by the layer removal method and calculated by the linear thermoviscoelastic theory considering specific volume relaxation. The relaxations of the tensile modulus and specific volume were measured by an Instron thermomechanical analyzer. When the starting temperature of the cooling process was near the glass transition temperature of the cured epoxy, the residual stress in the epoxy plate was smaller than when the starting temperature was higher than the glass transition temperature. However, the transient stress in the cured epoxy plate was higher when the starting temperature was near the glass transition temperature than when the starting temperature was higher than the glass transition temperature. The quenched epoxy plate was compressed in the direction parallel to the surface and expanded in the thickness direction.     

Mechanical properties of SBR-networks: I. Determination of crosslink densities by stress-strain-measurements

The tube model is applied for the treatment of stress-strain measurements on SBR networks. It is shown that this theory allows the separation of crosslink and constraint contributions to the stress-strain behavior and, also, a reliable determination of crosslink densities. The consideration of dynamical contributions is discussed and a special numerical method is developed.     

Instantaneous strain recovery elasticity and endothermic heat change in nylon-6 monofilaments and silicone rubbers

The instantaneous elastic moduli for a nylon-6 monofilament were derived on strain recoveries right after creep, stress relaxation, and rapid elongation,E _c ,E _s andE _e , respectively. It was found that during strain recoveryE _s (>E _e ) andE _e increase monotonically with increasing load,m ₁, on the sample. The extrapolated value of E_s atm ₁=0 g is almost equal to Young's modulus, 4.06 GPa. The value ofE _c also increased with increasingm ₁, and atm ₁=600 g (1.93 t cm^–2) reached about 14 GPa. The endothermic heat change right after creep, stress relaxation or rapid elongation,Q, was negligibly small. For comparison,E _s ,E _c andQ were also investigated for silicone rubber. It was found thatE _s (53.8 M Pa at the draw ratioD=1.2) decreased abruptly atD=1.3. In the range ofD=1.4–1.9,E _s was only 22.6 MPa. In the case of stress relaxation,Q increased with increasingD from 4 J mol^–1 (atD=1.2) to 56 J mol^–1 (atD=1.9). FurthermoreE _c (5.58 MPa atm ₁=133.8 g (429.4 kg cm^–2)) increased gradually with increasing m₁ and attained 16.6 MPa atm ₁=548.4 g (1.76 t cm^–2). In the case of creep,Q was in the range of 0–11.5 J mol^–1 and larger when larger loads,m ₂ were removed during the later stages of creep.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayThe author wishes to thank Mr. Keizi Igarashi and Mr. Tetsuya Yasui for helping in the experiments.     

Rheology of polystyrene solutions around the coil overlapping concentration: A phenomenological description of stresses in simple shear flow

Linear viscoelasticity behavior is described with the sum of two terms for polystyrene solutions in tricresyl phosphate around the coil overlapping concentration (K. Osaki, T. Inoue, & T. Uematsu, J Polym Sci Part B: Polym Phys 2001, 39, 211). One is a Rouse–Zimm (RZ) term represented by the Zimm theory with arbitrarily chosen values of the hydrodynamic interaction parameter and the longest relaxation time (τ_RZ). The other (the L term) consists of a relaxation mode with a single relaxation time (τ_L > τ_RZ) and a high‐frequency limiting modulus proportional to the square of the concentration. In this study, we describe the viscosity (η) and first normal stress coefficient (Ψ₁) in steady shear with simple formulas. The stress due to the L term is assumed to be given by a Kaye, Bernstein, Kearsley, and Zapas (K‐BKZ) equation with the damping function h(γ) = (1 + 0.2γ²)^?1/2, where γ is the magnitude of shear. Contributions to η and Ψ₁ from the RZ term are derived from the RZ model, in which the relaxation time in steady flow is given by τ_st = τ + (τ_RZ ? τ)/(1 + 0.35τ_RZ γ˙) instead of τ_RZ. Here, γ˙ is the rate of shear, and τ is the τ_RZ value at the infinite dilution limit. η and Ψ₁ at various concentrations for two polystyrene samples (with molecular weights of 2890 and 8420 kg mol^?1) are well described with parameters derived from dynamic viscoelasticity. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1038–1045, 2002     

Nitrotyrosine-modified proteins and oxidative stress induced by diesel exhaust particles

Protein tyrosine nitration is a post-translational modification that occurs under conditions of oxidative stress and may play a role in the pathogenesis of diseases such as asthma. Through their ability to generate reactive oxygen species in macrophages and epithelial cells, particulate pollutants, such as diesel exhaust particles (DEPs), may lead to a worsening of the asthmatic condition. In this study, we looked for evidence of oxidative modification of proteins in RAW 264.7 cell line treated with DEP chemicals. We show that the induction of oxidative stress is accompanied by 53 newly expressed proteins which are suppressed by a thiol antioxidant, N-acetylcysteine. These include antioxidant enzymes, pro-inflammatory components, and products of intermediary metabolism. In addition, inducible nitric oxide synthase (iNOS) was identified as a biologically relevant oxidative stress protein that is induced concurrent with increased NO production and protein tyrosine-nitration in DEP-exposed RAW 264.7 cells. Utilizing two-dimensional gel electrophoresis, anti-nitrotyrosine immunoblotting, and mass spectrometry led to the identification of an additional ten nitrotyrosine modified proteins, including oxidative stress proteins involved in intermediary metabolism (e.g., GAPDH and enolase), antioxidant defense (e.g., MnSOD) and inhibition of proteosomal activity (e.g., Hsp 90alpha). These oxidative proteins may serve as markers for oxidative stress generation in vivo.     

Prepared Low Stress Cubic Boron Nitride Film by Physical Vapor Deposition

We present low stress cubic boron nitride (cBN) films with a transition layer deposited on the metal alloy substrates by tuned substrate radio-frequency magnetron sputtering. The films were characterized by Fourier transform infrared spectroscopy and transmission electron microscopy (TEM). The IR peak position of cubic boron nitride at 1006.3 cm⁻¹, which is close to the stressless state, indicates that the film has very low internal stress. The TEM image shows that pure CBN phase exists on the surface of the film. Several phases of boron nitride were found at the medium implantation dose. It is believed that the transition from the low ordered phases to cBN phase occurred during implantation.     

Recovery of pyridine from aqueous solution by membrane pervaporation

Three different membranes, based on poly(dimethylsiloxane) (PDMS), cation-exchange material and poly(vinyl alcohol) (PVA) respectively, were tudied for the separation of pyridine-water mixtures by pervaporation. The PDMS membrane was preferentially permeable to pyridine and the other two were selective towards water. Three membranes showed different permeation performance, allowing the application of the technique to the separation of feeds of different composition. The temperature profile of the permeability suggests that it is possible to carry out the operation at an elevated temperature in order to achieve high productivity. A combination of the three types of membranes was designed for the production of anhydrous pyridine from dilute pyridine aqueous solution by pervaporation.     

<Emphasis Type="Italic">L</Emphasis>-Carnitine Supplementation: A New Paradigm for its Role in Exercise

Summary. Early research investigating the effects of L-carnitine supplementation has examined its role in substrate metabolism and in acute exercise performance. These studies have yielded equivocal findings, partially due to difficulties in increasing muscle carnitine concentrations. However, recent studies have proposed that L-carnitine may play a different role in exercise physiology, and preliminary results have been encouraging. Current investigations have theorized that L-carnitine supplementation facilitates exercise recovery. Proposed mechanism is as follows: 1) increased serum carnitine concentration enhances capillary endothelial function; 2) increased blood flow and reduced hypoxia mitigate the cascade of ensuing, destructive chemical events following exercise; 3) thus allowing reduced structural damage of skeletal muscle mediated by more intact receptors in muscle needed for improved protein signaling. This paradigm explains decreased markers of purine catabolism, free radical formation, and muscle tissue disruption after resistance exercise and the increased repair of muscle proteins following long-term L-carnitine supplementation.     

Age-dependent variations of cell response to oxidative stress: proteomic approach to protein expression and phosphorylation

We investigated the protein profiles of variously aged rat astrocytes in response to oxidative stress. After H2O2-exposure of cells at 100 microM for 30 min, the relative intensity of ten protein spots changed on two-dimensional (2-D) gels compared with control gels after silver staining. Matrix-assisted laser desorption/ionization-time of flight-mass spectrometry (MALDI-TOF-MS) analysis after in-gel digestion revealed that six of these spots corresponded to three kinds of proteins, each of which was composed of a protein and its modified form with a different isoelectric point (pI). These three proteins were identified as peroxiredoxins (PRDXs) II and III, and calpactin I light chain (p11). H2O2-exposure increased the intensity of the spot with lower pI and simultaneously decreased that of the spot with higher pI for both PRDXs II and III. In addition, the expression of annexin VII, S-adenosyl-L-homocysteine hydrolase, elongation factor II fragment (EF-II), and adenosine deaminase was increased by H2O2-exposure in astrocytes from variously aged rats. Using the Pro-Q Diamond staining, heat shock protein 60 kDa (Hsp 60) and alpha-tubulin were observed to be phosphorylated upon H2O2-exposure. While phosphorylation of alpha-tubulin was correlated positively with age, the changes in abundance of ten protein spots as described above were independent of age. These results suggest that aging does not suppress the responses aimed at limiting injury and promoting repair brought about by severe oxidative stress, and might affect cell dynamics including the formation of microtubules.     

Integrated production of ethanol fuel and protein from Coastal Bermudagrass

The herbaceous crops that may provide fermentable carbohydrates for production of fuels and chemicals also contain 10–20% protein. Protein coproduction with biomass-derived fuels and chemicals has important advantages: (1) food and fuel production can be integrated, and (2) protein is a high-value product that may significantly improve overall process economics. We report the results of an integrated approach to producing protein and fermentable sugars from one herbaceous species, Coastal Bermudagrass (CBG). The ammonia fiber explosion (AFEX) process makes possible over 90% conversion of cellulose and hemicellulose to simple sugars (about 650 mg reducing sugars/g dry CBG) at 5 IU cellulase/g vs < 20% conversion for untreated CBG. The AFEX treatment also improves protein extraction from CBG; over 80% protein recovery is possible from AFEX-treated CBG vs about 30% recovery from untreated CBG.