有机小分子催化的不对称羟醛缩合反应

总结了近年来用于不对称催化羟醛缩合反应的各种有机小分子催化剂, 简要阐述了每种类型的催化剂的催化机理以及它们的优缺点, 同时对有机小分子催化反应的发展进行了展望.     

Determination of As, Sb, Se, Te and Bi in milk by slurry sampling hydride generation atomic fluorescence spectrometry

A simple and fast analytical procedure has been developed for the determination of As, Sb, Se, Te and Bi in milk samples by hydride generation atomic fluorescence spectrometry (HG-AFS). Samples were treated with aqua regia for 10 min in an ultrasound water bath and pre-reduced with KBr for total Se and Te determination or with KI and ascorbic acid for total As and Sb, the determination of Bi being possible in all with or without pre-reduction. Slurries of samples, in the presence of antifoam A, were treated with NaBH₄ in HCl medium to obtain the corresponding hydrides, and AFS measurements were processed in front of external calibrations prepared and measured in the same way as samples. Results obtained by the developed procedure compare well with those found after microwave-assisted complete digestion of samples. The proposed method is simple and fast, and only 1 ml of milk is needed. The values obtained for detection limit are 2.5, 1.6, 3, 6 and 7 ng l⁻¹ for As, Sb, Se, Te and Bi respectively in the diluted samples, with average relative standard deviation values of 3.8, 3.1, 1.9, 6.4 and 1.2% for three independent analysis of a series of commercially available samples of different origin. Data found in Spanish market samples varied from 3.2±0.3 to 11.3±0.2 ng g⁻¹ As, from 3.1±0.2 to 11.6±0.4 ng g⁻¹ Sb, from 10.7±0.5 to 25.5±0.4 ng g⁻¹ Se, from 0.9±0.2 to 9.4±0.6 ng g⁻¹ Te and from 11.5±0.1 to 27.7±0.4 ng g⁻¹ Bi.     

Selective and sensitive detection of organic contaminants in water samples by on-line trace enrichment–gas chromatography–mass spectrometry

Liquid chromatographic (LC) type trace enrichment is coupled online with capillary gas chromatography (GC) with mass spectrometric (MS) detection for the analysis of aqueous samples. A volume of 1–10 ml of an aqueous sample is preconcentrated on a trace-enrichment column packed with a polymeric stationary phase. After cleanup with HPLC-grade water the precolumn is dried with nitrogen and subsequently desorbed with ethyl acetate. A fraction of 60 μl is introduced on-line into a diphenyltetramethyldisilazane-deactivated retention gap under partially concurrent solvent evaporation conditions and using an early solvent vapor exit. The analytes are separated and detected by means of GC–MS. The potential of the LC–GC–MS system for monitoring organic pollutants in river and drinking water is studied. Target analysis is carried out with atrazine and simazine as model compounds; the detection limits achieved under full-scan and multiple ion detection conditions are 30 pg and 5 pg, respectively. Identification of unknown compounds (non-target analysis), is demonstrated using a river water sample spiked with 168 pollutants varying in polarity and volatility.     

Characteristic lengths and the structure of salt free polyelectrolyte solutions. A small angle neutron scattering study

We have studied salt free semi dilute polyelectrolyte solutions by small angle neutron scattering. Specific labelling associated with an extrapolation method has allowed the separation of the form factor of a single polyelectrolyte chainS ₁(q) and the structure factorS ₂(q). Two lengths are deduced from these two factors: the persistence lengthb _t which characterizes the electrostatic interactions along the chain by a fitting ofS ₁(q) with calculation of the scattering function for a wormlike chain, and fromS ₂(q),q _m ^–1 which characterizes the interactions between chains. These two lengths vary in the same way with the concentration of polyions (b _t C _p ^–1/2 ,q _m ^–1 C _p ^–1/2 ) and a constant relation exists between them: only one length is then necessary to describe the structure of polyelectrolyte soltuion on this semidilute concentration range.Laboratoire Commun CEA-CNRS.     

Native agarose gel electrophoresis and electroelution: A fast and cost‐effective method to separate the small and large hepatitis B capsids

Hepatitis B core antigen (HBcAg) expressed in Escherichia coli is able to self‐assemble into large and small capsids comprising 240 (triangulation number T = 4) and 180 (triangulation number T = 3) subunits, respectively. Conventionally, sucrose density gradient ultracentrifugation and SEC have been used to separate these capsids. However, good separation of the large and small particles with these methods is never achieved. In the present study, we employed a simple, fast, and cost‐effective method to separate the T = 3 and T = 4 HBcAg capsids by using native agarose gel electrophoresis followed by an electroelution method (NAGE‐EE). This is a direct, fast, and economic method for isolating the large and small HBcAg particles homogenously based on the hydrodynamic radius of the spherical particles. Dynamic light scattering analysis demonstrated that the T = 3 and T = 4 HBcAg capsids prepared using the NAGE‐EE method are monodisperse with polydispersity values of ～15% and ～13%, respectively. ELISA proved that the antigenicity of the capsids was not affected in the purification process. Overall, NAGE‐EE produced T = 3 and T = 4 capsids with a purity above 90%, and the recovery was 34% and 50%, respectively (total recovery of HBcAg is ～84%), and the operation time is 15 and 4 times lesser than that of the sucrose density gradient ultracentrifugation and SEC, respectively.     

Determination of organochlorine pesticides (OCPs) in breast milk from Rio Grande do Sul,Brazil, using a modified QuEChERS method and gas chromatography-negative chemical ionisation-mass spectrometry

ABSTRACT

The food chain is the main source of exposure to humans by organochlorine pesticides (OCPs) due to the bioaccumulation. Breast milk can accumulate OCPs, so this matrix is often used as an environmental bioindicator. The currently available methods for the determination of several OCPs and metabolites in breast milk involve, in general, multi-step sample preparation and quantification techniques with low selectivity, high cost and much time and labour. Thus, a fast and efficient method based on sample preparation using the quick, easy, cheap, effective, rugged and safe (QuEChERS) method combined with gas chromatography coupled to mass spectrometry with negative chemical ionisation (GC-NCI-MS) was developed, validated and applied for determination of 16 OCPs and metabolites in breast milk samples. The extract was cleaned by dispersive solid-phase extraction (d-SPE) using MgSO₄ and C18, evaporated in a Turbovap® system, redissolved and analysed by GC-NCI-MS. The method was validated showing acceptable recoveries (72–118%) and precision (RSD <19%). Method limits of detection (LODs) and quantification (LOQs) ranged from 0.75 to 7.5 ng g^?1 and from 2.5 to 25 ng g^?1 lipid, respectively. The method was successfully applied to 20 samples of breast milk from different regions of the Rio Grande do Sul state, Brazil, of which 75% contained residues below the LOQs.     

Radial sample load distribution under overload conditions: Analytical scale columns

The homogeneity of the sample load across the radial cross section of analytical scale columns was determined when operating under overload conditions. The study was performed using active flow technology columns operating in parallel segmentation mode. The outlet segmentation ratio was varied to enable different volume fractions of mobile phase, and thus sample, to elute from the peripheral and central flow regions of the column. The amount of solute exiting the peripheral and radial central exit ports was determined as a function of the flow segmentation ratio. The experimental data using an analytical scale column with dimensions, 100?×?4.6?mm, indicated that the sample load distribution was essentially uniform as a function of the column radial cross section.     

Determination of trans,trans‐muconic acid in workers' urine through ultra‐performance liquid chromatography coupled to tandem mass spectrometry

A novel method for the biological monitoring of benzene‐exposed workers has been developed through ultra‐performance liquid chromatography coupled to tandem mass spectrometry. The method uses trans,trans‐muconic acid in urine as the benzene‐exposure biomarker. The method was developed using a triple quadrupole mass spectrometer with enough sensitivity to facilitate diluting and injecting the urine samples directly, rather than performing a solid‐phase extraction procedure as is common in the available protocols. Moreover, compared with a conventional high‐pressure liquid chromatography system, the separation power provided by the ultra‐performance liquid chromatography system allows a 10‐fold reduction in run time. The method was adjusted to a dynamic range of between 198.9 and 4916.7 µg/L to cover the biological exposure index of trans,trans‐muconic acid in urine. Also, the method demonstrated intra‐day and inter‐day precision at 98%, and accuracy within an acceptable range of 101 ± 8%. The method has been used to quantify various types of urine samples, such as workers' urine and inter‐laboratory proficiency tests. Depending on the sample, the quantified levels ranged from less than the limit of quantitation to 3836.7 µg/L. No levels exceeding the calibration range were detected in the urine of workers, and the reported concentrations in urine for the proficiency tests were, as expected, based on known values. Moreover, the new method using sample dilution and faster chromatographic run was more effective, facilitating fast communication of results, as needed, to decision‐makers. Copyright © 2012 John Wiley & Sons, Ltd.     

Conductivity anomalies in Y–Ba–Cu–O at 40K and 100K under high quasihydrostatic pressures

Electrical resistance measurements at low temperatures and high quasihydrostatic pressures on superconducting and non-superconducting varieties of Y_0.8Ba_1.2Cu₂O₅ (obtained by annealing in oxygen and air respectively) show striking anomalies in the vicinity of 100K and 40K. Arguments are presented to show that these anomalies as also the occurrence of T 's in the oxide superconductors either in the vicinity of 100K or of 40K are connected with their layered structure containing planes of Cu-O otahedral complexes.     

Minireview: Advances in Germanium Isotope Analysis by Multiple Collector–Inductively Coupled Plasma–Mass Spectrometry

The advent of multiple collector–inductively coupled plasma–mass spectrometry (MC-ICP-MS) has made the high-precision determination of Ge isotopes possible, which leads to the widespread application of Ge isotopes in earth, ocean, and cosmochemistry fields. This paper reviews the history of Ge isotope analysis, chemical dissolution and purification, and mass spectrometry measurements. Concentrated HNO₃ is sufficient to dissolve nearly all types of samples and HF is also involved for Si-rich samples. Low-temperature ashing prior to dissolution is an alternative way to preconcentrate Ge in organic-rich samples. For different matrices, Ge isotopes can be determined by MC-ICP-MS coupled with a traditional nebulizer system or hydride generation system after two-step separation, one step cation/anion-exchange separation, or Mg/Fe co-precipitation protocols. Ion-exchange column methods are suitable for samples with elevated matrix and Ge content such as sulfides, iron oxides, silicate rocks, and coals, whereas Mg or Fe coprecipitation methods are particularly suitable for all kinds of water. Hydride generation systems are improved over traditional nebulizer system due to the smaller sample quantity and fewer matrix-related interferences. Sample-standard bracketing, double spike, and external Ga isotope normalization are used to mass bias correction and yield consistent results. Analytical methods involving Ge-poor samples and Ge isotope analyses based on different Ge species or specific Ge compound in natural environment will be important prospects in the further study. For further applications of Ge isotopes in mineral deposits such as sulfide and iron oxide deposits, sulfides, and iron oxides reference materials should be developed in the future.