Degradative chain transfer in vinyl acetate polymerizations using toluene as solvent

In this work, we propose that retardation in vinyl acetate polymerization rate in the presence of toluene is due to degradative chain transfer. The transfer constant to toluene (C_trs) determined using the Mayo method is equal to 3.8 × 10^?3, which is remarkably similar to the value calculated from the rate data, assuming degradative chain transfer (2.7 × 10^?3). Simulations, including chain‐length‐dependent termination, were carried out to compare our degradative chain transfer model with experimental results. The conversion–time profiles showed excellent agreement between experiment and simulation. Good agreement was found for the M_n data as a function of conversion. The experimental and simulation data strongly support the postulate that degradative chain transfer is the dominant kinetic mechanism. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3620–3625, 2007     

Champ de vitesse dans un échangeur à vortex en régime turbulentHeat exchanger velocity field with turbulent inlet condition

We consider the isothermal flow through a cylindrical flat chamber, a model of some particular heat exchanger, for which LDV measurements and a numerical simulation have been performed. Experimental results show the establishment of an important vortex zone, the secondary flow extending all along the chamber radius. This observation leads to an expected significant increase of the fluid mixing. Results issued from the numerical simulation appear to be in close agreement with experimental data. Nevertheless, the k–ε model used here must be improved to obtain a better approach near the vortex centre. To cite this article: S. Petitot et al., C. R. Mecanique 330 (2002) 593–599.     

抓好数学建模竞赛 推动数学教学改革

本文通过近几年组织数学建模教学和指导学生参加竞赛的实践 ,探索抓好数学建模竞赛 ,促进数学教学改革 ,推动数学素质教育 ,提高人才培养质量的途径、措施和方法     

脉冲压缩光栅光路调节新方法研究

介绍了一种简单而实用的大口径脉冲压缩光栅光路调节方法,有效解决了普通光路调节方法中轴向调节精度不高的问题。首先由全息透镜(光栅)成像公式出发,推导出了该光路调节的基本原理。并从光栅记录系统与光栅衍射波像差的关系,结合初级像差理论推导得出叠栅条纹像差为0.4786λ,大约是光栅衍射波像差(0.25λ)的两倍,利用此关系也可对光栅衍射波像差进行实时监测。从数值模拟结果可知,利用叠栅条纹法调节光路可将光栅波像差减至0.06λ,相应的轴向误差量为0.007 mm,可有效提高了轴向调节精度。     

Quantitative Comparison of REAPDOR and TRAPDOR Experiments by Numerical Simulations and Determination of H–Al Distances in Zeolites

Quantitative H–Al distances in acid sites of two zeolites with MFI and IFR framework topology were obtained by numerical simulation of ¹H{²⁷Al} rotational echo adiabatic passage double resonance (REAPDOR) experiments. A ²⁷Al offset-dependent data set yields for each resolved ¹H NMR line a corresponding nuclear electric quadrupole coupling constant of the neighboring ²⁷Al site. This information is used for analyzing a second data set for on-resonance irradiation, where the dipolar evolution time (number of rotor cycles) was varied, to yield the ¹H–²⁷Al dipolar coupling constant. Numerical simulations indicate that the REAPDOR method does not depend significantly on the polar angles, defining the orientation of the electric field gradient tensor of ²⁷Al with respect to the Al–H dipolar vector. In contrast, the transfer of populations in double resonance sequence is sensitive to these angles, and it can be thus used to measure them.     

空位在金刚石近(001)表面扩散的分子动力学模拟

用分子动力学方法模拟了空位在金刚石近(001)表面的扩散过程,研究了温度对空位扩散的影响.结果表明,当温度为1000K左右时,位于近表面第二层上的空位开始向表面运动;当温度在1400—2000K时,空位完全扩散到表面.这与实验结果和其他计算结果符合得很好.同时发现,温度为1400—1800K时,空位的扩散经历了两次迁移运动,其分别对应了均方位移图中的两个极大值.在不施加任何约束的条件下得到了空位的动态扩散路径,空位在金刚石近(001)表面的扩散势垒约为042eV.并探讨了一定温度下空位数目增多及其不同排列 关键词： 金刚石 空位 扩散 分子动力学     

Optimal design of a convergent-barrel cold spray nozzle by numerical method

A convergent-barrel (CB) cold spray nozzle was designed through numerical simulation. It was found that the main factors influencing significantly particle velocity and temperature include the length and diameter of the barrel section, the nature of the accelerating gas and its pressure and temperature, and the particle size. Particles can achieve a relatively low velocity but a high temperature under the same gas pressure using a CB nozzle compared to a convergent-divergent (CD) nozzle. The experiment results with Cu powder using the designed CB nozzle confirmed that particle deposition can be realized under a lower gas pressure with a CB nozzle.     

Performance and simulation of an on-board guided-wave optical processor for airborne SAR applications

This paper describes the performance and simulation of a compact integrated optical processor for the real-time reconstruction of two-dimensional images in airborne stripmap synthetic aperture radar applications. The functional behavior of the processor is explained in some detail. The design criteria are briefly given. The simulation step allowed the main processor characteristics and properties to be identified. A number of comparisons were obtained in airborne SAR mission scenarios between the predictions of the optical device and those achieved by the modern electronic digital approach, based on the wavefront reconstruction method by matched filtering.     

Residual currents and corridor of flow in the Rio de la Plata

The Rio de la Plata is a large and shallow water body that discharges onto the Atlantic Ocean. The main driving forces for the river flow are the bathymetry, tides, the outflow from the Paraná and Uruguay rivers and the winds. A numerical model covering the entire river was set up with the objective of increasing our understanding of the hydrographical features and morphological dynamics in the Estuary. The simulations revealed a counter-clockwise residual circulation in the Samborombón Bay and an eastward net flow near the Uruguayan coast. The residual flow is forced by both the tides and the bathymetry. The residence time for the entire river ranges from 40 to 80 days. However, residence times above 120 days was found in the Samborombón Bay. Three corridors of flow have been identified.     

基于二次插值的非饱和土壤水流问题的特征差分方法及数值模拟

本文针对一类非饱和土壤水流问题,提出了基于二次插值的特征差分格式,得到了严谨的L2模误差估计.并作了数值试验,指明方法的有效性.