聚乙烯醇双胺肟螯合纤维的合成及其吸附性能

利用预辐接技法合成了聚乙烯醇双胺肟螯合纤维。研究了影响接枝率和胺肟基团含量的因素，讨论了吸附酸度、吸附时间对Ｃｕ（Ⅱ）离子吸附容量的影响。     

Photocatalytic Oxidation of Aniline in the Gas Phase Using Porous TiO2 Thin Films

The gas-phase photocatalytic oxidation of aniline on a new kind of porous nano-TiO₂ composite films is investigated. The composite film was prepared on glass fiber with the water glass as binders and dilute H₂SO₄ solution as solidifying reagent. The surface characters were observed by scanning electron microscope. The photocatalytic degradation of aniline on the composite films was carried out in a TiO₂/UV system. Some important factors affecting the photodegradation, such as the concentration of TiO₂, the initial concentration of aniline, and the existing water vapor, are also studied. The product of photocatalytic oxidation was detected by Fourier transform-Infrared. The partial intermediate products were absorbed on TiO₂ surface, which resulted in catalyst deactivation. But when it was irradiated under UV illumination or solar irradiation for some time, the catalyst could be reused without loss of catalytic activity. Translated from the Journal of Wuhan University (Natural Science Edition), 2005, 51(2) (in Chinese)     

聚四氟乙烯纤维辐照接枝制备弱酸性离子交换剂及其对Cu~(2+)的吸附

以聚四氟乙烯纤维为基体通过6 0 Co辐射引发与丙烯酸接枝制备弱酸性阳离子交换纤维 .产物功能基含量为 3 0 6mmol g,在pH =5时该纤维达到对Cu2 + 的最大动态吸附量为 10 7 4 8mg g.使用不同浓度HCl对饱和吸附铜的接枝纤维进行洗脱 ,证实该纤维对铜离子具有优异的解吸性能     

Biomimetic piezoelectric quartz sensor for caffeine based on a molecularly imprinted polymer

A piezoelectric quartz sensor coated with molecularly imprinted polymer (MIP) for caffeine was developed. The MIP was prepared by co-polymerizing methacrylic acid (MAA) and ethylene glycol dimethacrylate (EDMA) in the presence of azobis(isobutyronitrile) as initiator, caffeine as template molecule, and chloroform as solvent. The MIP suspension in polyvinyl chloride/tetrahydrofuran (6:2:1 w/w/v) solution was spin coated onto the surface of the electrode of a 10 MHz AT-cut quartz crystal. The sensor exhibited a linear relationship between the frequency shift and caffeine concentration in the range of 1×10^–7 mg mL^–1 up to 1x10^–3 mg mL^–1 [correlation coefficient (r)=0.9935] in a stopped flow measurement mode. It has a sensitivity of about 24 Hz/ln(concentration, mg mL^–1). A steady-state response was achieved in less than 10 min. The performance characteristic of the sensor shows a promising and inexpensive alternative method of detecting caffeine. Surface studies were carried out for the reagent phase of the sensor using SEM, AFM, and XPS analysis in order to elucidate the imprinting of the caffeine molecule. The SEM micrograph, AFM image, and XPS spectra confirmed the removal of caffeine by Soxhlet extraction in the imprinting process and the rebinding of caffeine to the MIP sensing layer during measurement.     

A NEW KIND OF FIBER-SPUN FROM POLYSULFONAMIDE/ZINC SOLUTION

In this paper, we succeed in fabricating high-temperature fiber of polysulfonamide/ZnO. Polysulfonamide/ZnO nanocomposite was prepared by in-situ polymerization. Some studies and characterization of Polysulfonamide/ Zinc oxide nanocomposite with ZnO 0.5% have been done. It includes ηr,, Crystal degree and thermal property. Experiment＇s results showed that, ZnO as filler can improve crystal degree of polysulfonamide fiber. The crystal degree has been bnproved, from lower than 20% up to 27%. ηr of polysulfonamide/ Zinc oxide nanocomposite solution with ZnO 0.5% is 2.03. The maxinum weight loss of the nanocomposite occurred at 453.5 ℃.     

Transport of ionic charge and solvent in poly(3-octylthiophene) films: An electrochemical quartz crystal microbalance study

The results of a study of poly(3-octylthiophene) films with the aid of an electrochemical quartz microbalance are presented. The effect of the nature of the electrolyte anion on the determined weights of mobile species that are transported through the film/electrolyte interface is discussed. The obtained results point to a substantial role played by the solvent transport in the course of the electrode reaction. The results concerning the influence exerted by the electrode material on the observed regularities are presented.     

Aspects of thermal conductivity relative to heat flow

Summary The various techniques and methodologies of thermal conductivity measurement have been conventionally based on the determination of the rate of directional heat flow through a material having a unit temperature differential between its opposing faces. The constancy of this rate depends on the material density, its thermal resistance and the heat flow path itself. The last of these variables contributes most significantly to the true value of steady-state axial and radial heat dissipation depending on the magnitude of transient thermal diffusivity along these directions. The purpose of this paper is to exemplify the above features by defined parameters of heat flow measurement by existing methodologies. No new method is proposed here. Importantly, the relationship between the rate of heat transfer, total heat transferred and thermal conductivity at a given temperature under steady-state conditions for a fixed heat flow path will be illustrated.     

载银磷酸活化剑麻基活性炭纤维的抗菌性能研究

本文利用磷酸化方法，制备各种剑麻基活性炭纤维，并利用活性炭纤维的氧化还原特性及吸附性能，在其上负载金属银，研究并比较了这些载银活性炭纤维对大肠杆菌和金黄色葡萄球菌的杀灭作用，结果表明，磷酸浓度，活化方法，活化时间，纤维的比表面积等因素的均对材料的抗菌性能有一定的影响，磷酸活化的活性炭纤维表现出强的抗菌杀菌能力，高浓度磷酸活化后的纤维抗菌能力有所提高，并且抗菌能力随活化时间的延长而增加，抗菌前后纤维上负载的银未曾大量脱落，经5次抗菌试验后材料仍显示出很强的抗菌能力。     

Classification of cultivation area of ginseng by near infrared spectroscopy and ICP-AES

A rapid and nondestructive near infrared (NIR) method using soft independent modeling of class analogy (SIMCA) for the classification of cultivation area (Korea and China) was evaluated and confirmed. Raw, first, and second derivative NIR spectra were compared to develop a robust classification rule. The chemical properties of ginseng samples were also investigated to find out the differences between Korean samples and Chinese samples. These differences make NIR spectroscopic method viable. The average value of each Korean and Chinese ginseng sample for crude fiber, crude protein, starch, and 10 inorganic constituents were measured and compared with F-test and t-test. The inorganic constituents were also measured by induced coupled plasma-atomic emission spectroscopy (ICP-AES). It could be found that the amount of starch and ten inorganic elements for example Na, Mg, P, K, Ca, Mn, Fe, Ni, Cu and Zn in ginseng samples are considerably different based on cultivation area. SIMCA has been applied to the inorganic data to investigate the possibility of ICP-AES as classification tool. However, it was observed that the result was not equal to than NIR spectra data. The overall results showed the availability of NIR method using SIMCA would be adequate for classification of cultivation of ginseng, since NIR spectra includes useful and various information on chemical properties in spite of broad and overlapped bands.     

FFC-1离子交换纤维物理化学性能的研究

利用扫描电镜、热失重-红外、元素分析、低温氮吸附等技术和化学手段对聚羧酸基FFC-1离子交换纤维的结构与性能特点等进行了系统研究．结果表明：FFC-1离子交换纤维为含适量酰肼类交联键的聚羧酸(钠)型离子交换材料，外比表面积大和传质距离短是其反应动力学性能优异的主要原因，FFC-1纤维具有良好的化学与热稳定性。在5mol/L硫酸、硝酸、盐酸和2mol／L氢氧化钠溶液中浸泡，交换容量未见明显降低。但过氧化氢溶液对其功能基有明显破坏，CO2为FFC-1纤维在高温区间(300℃～350℃)的主要分解产物。