Raman spectroscopy and magnetic properties of KMCr(CN)6 under pressure

We study the effect of pressure on Raman spectra as well on magnetic properties of molecule-based magnets KNiCr(CN)₆ and KMnCr(CN)₆. The effect of pressure on the ν[C≡N] vibration band which is located in the 2100–2200?cm^?1 spectral range is relatively weak. Hydrostatic pressure has small almost a negligible effect on the Curie temperature of ferromagnetic KNiCr(CN)₆ while leads to a pronounced reversible Curie temperature increase occurrence of new magnetic phase under pressure in the case of KMnCr(CN)₆. Applied pressure affects magnetization curves only marginally. All pressure-induced changes are reversible.     

水下火箭水平射流初期特征研究

水中工作固体火箭发动机处于重浮力同时作用环境下, 与工作于大气环境下的固体火箭发动机具有不同的工作特性. 为进一步掌握水下固体火箭发动机的工作特性, 对具有重浮力特征的水下射流进行研究, 重点分析重浮力作用下水平喷射射流结构及推力振荡情况, 采用VOF模型对水平喷射且具有重浮力特征的三维发动机模型进行仿真模拟, 对比有/无重浮力下射流气泡的上浮特征, 并采用动量原理对发动机工作初期的射流扰动进行分析, 获得了重浮力下水下固体火箭发动机的推力振荡特征. 研究结果表明: 由于重浮力逐渐占据主导地位, 射流气泡具有明显的上浮特征, 推力与重浮力耦合后在竖直方向产生的翻转力矩更大, 通过与文献中实验对比可见, 采用VOF模型并考虑重浮力后仿真所得射流结构与实验结果更吻合.     

Interpretation of pressure recovery curves recorded simultaneously in different sections of a horizontal well borehole

A new approach to carrying out and interpreting hydrodynamic investigations of horizontal wells is proposed. The problem of determining the flow parameters of an inhomogeneous oil reservoir is considered. As the initial information, the pressure recovery curves recorded simultaneously in different sections of the horizontal well borehole are used.     

Control of mean and fluctuating forces on a circular cylinder at high Reynolds numbers

A narrow strip is used to control mean and fluctuating forces on a circular cylinder at Reynolds numbers from 2.0 × 10⁴ to 1.0 × 10⁵. The axes of the strip and cylinder are parallel. The control parameters are strip width ratio and strip position characterized by angle of attack and distance from the cylinder. Wind tunnel tests show that the vortex shedding from both sides of the cylinder can be suppressed, and mean drag and fluctuating lift on the cylinder can be reduced if the strip is installed in an effective zone downstream of the cylinder. A phenomenon of mono-side vortex shedding is found. The strip-induced local changes of velocity profiles in the near wake of the cylinder are measured, and the relation between base suction and peak value in the power spectrum of fluctuating lift is studied. The control mechanism is then discussed from different points of view. The project supported by the National Natural Science Foundation of China (10172087 and 10472124). The English text was polished by Yunming Chen.     

Interactions between a rectangular cylinder and a free-surface flow

The salient features of the interaction between a free-surface flow and a cylinder of rectangular cross-section are investigated and discussed. Laboratory-scale experiments are performed in a water channel under various flow conditions and elevations of the cylinder above the channel floor. The flow field is characterized on the basis of time-averaged and fluctuating local velocity measurements. Dynamic loadings on the cylinder are measured by two water-insulated dynamometers placed inside the cylinder structure. Starting from frequency and spectral analyses of the force signals, insights on the relationship between force dominant frequencies and the Strouhal number of the vortex shedding phenomenon are provided. Experimental results highlight the strong influence of the asymmetric configuration imposed by the two different boundary conditions (free surface and channel floor) on (i) the mean force coefficients and (ii) the vortex shedding frequencies. We provide an analysis of the nature of the dependence of average force coefficients on relevant dimensionless groups, i.e., the Reynolds number, normalized flow depth and cylinder submersion.     

Analytical approximate 3D solution for the longitudinally vibrating cylinder

Summary The paper presents a three-dimensional approximate solution of a longitudinally vibrating cylinder. It is based on the frequency equation for free waves travelling along an infinitely long cylinder which follows from the radial boundary condition on the lateral surface of the cylinder. An equivalent longitudinal traction is calculated by integration of the normal stresses over the end cross section. The full solution of the longitudinally vibrating rod adapted to given axial boundary conditions is derived. The solution is compared to numerical results, and good agreement is obtained.     

含有裂纹和夹杂的复合柱体的扭转

本文根据Saint-Venant扭转理论,提出了一种能用于扭转分析的线夹杂模型,并得到了它的基本解,进而将此解与的单层势函数解及单裂纹基本解结合,对同时带有裂纹和夹杂的复合柱体的扭转作了讨论,最后将问题归为解一组混合型积分方程,并建议了数值解法。文中通过问题的退化,证明本文提出的夹杂模型在数学和力学上都是正确的,最后作了若干数值例子的计算,其结果令人满意。     

脉动压力分布同步测量的探讨

动态气动力的研究是实验工作者极为关注的问题。特别对于二元模型动态气动力的测定,必须从脉动的压力分布通过面积加权积分来得到气动力的时间历程,而其先决条件为各测压点压力的时间历程必须是同步的,也就是要测得同一时刻诸多测点的压力。本文介绍了一种比较经济的多点同步测压方法,并对该方法的实施进行了探讨。分别对A/D卡采样的同步性、整套测压系统的同步性以及频响特性进行了测试和验证。经相关性分析,相关系数分别达到0. 9999和 0. 99。最后以圆柱表面脉动压力系数分布的测试为例,给出了单圆柱不同瞬间的压力向量图、按照瞬间压力沿表面积分得到的单个圆柱脉动升力的时间历程,以及升力的脉动频率,表明整套同步测压系统具有很好的实用性,能满足实验的需要。     

Four-field Galerkin/least-squares formulation for viscoelastic fluids

A new Galerkin/Least-Squares (GLS) stabilized finite element method is presented for computing viscoelastic flows of complex fluids described by the conformation tensor; it extends the well-established GLS method for computing flows of incompressible Newtonian fluids. GLS methods are attractive for large-scale computations because they yield linear systems that can be solved easily with iterative solvers (e.g., the Generalized Minimum Residual method) and because they allow simple combinations of interpolation functions that can be conveniently and efficiently implemented on modern distributed-memory cache-based clusters.Like other state-of-the-art methods for computing viscoelastic flows (e.g., DEVSS-TG/SUPG), the new GLS method introduces a separate variable to represent the velocity gradient; with the aid of this variable, the conservation equations of mass, momentum, conformation, and the definition of velocity gradient are converted into a set of first-order partial differential equations in four unknown fields—pressure, velocity, conformation, and velocity gradient. The unknown fields are represented by low-order (continuous piecewise linear or bilinear) finite element basis functions.The method is applied to the Oldroyd-B constitutive equation and is tested in two benchmark problems—flow in a planar channel and flow past a cylinder in a channel. Results show that (1) the mesh-convergence rate of GLS is comparable to the DEVSS-TG/SUPG method; (2) the LS stabilization permits using equal-order basis functions for all fields; (3) GLS handles effectively the advective terms in the evolution equation of the conformation tensor; and (4) GLS yields accurate results at lower computational costs than DEVSS-type methods.     

一种弹塑性材料动态起裂韧度的J表征和测试方法

在数值计算的基础上提出了一个弹塑性材料动态起裂韧度的J表征和测试方法．这一方法利用自行研制的间接杆-杆型冲击拉伸试验装置，对周边切口的短圆柱试件实施基于一维试验原理的弹塑性材料动态断裂试验；利用试件两端的平均载荷—相对位移曲线(P-δ)或平均载荷-裂纹张开位移曲线(P-△)，推广Bice远场公式获得动态J积分；采用柔度变化率法确定裂纹起裂点，从而得到动态起裂韧度JJD．这一方法的优点在于利用P-δ或P-△曲线将外力对试件所做的与裂纹运动无关的质心惯性运动动能近似地从总能量中分离出来，且平均载荷P在起裂前以至失稳扩展前是单调增的，同时试验获得的P-δ和P-△曲线光滑，这使得用J积分作为裂纹尖端的表征参量以及用柔度变化率法确定起裂点和失稳点具有坚实的物理基础．