Surface characterization and radical decay studies of oxygen plasma‐treated PMMA films

Polymethylmethacrylate (PMMA) films were modified by RF oxygen plasma with various powers applied for different periods, and the effects of these parameters on the surface properties such as hydrophilicity, surface free energy (SFE), chemistry, and topography were investigated by water contact angle, goniometer, X‐ray photoelectron spectroscopy (XPS), and atomic force microscopy, and the types of the created free radicals and their decay were detected by electron spin resonance spectroscopy (ESR). SFE and contact angle results varied depending on the plasma parameters. Oxygen plasma treatment (100 W–30 min) enhanced the hydrophilicity of PMMA surface as shown by decreasing the water contact angle from 70° to 26°. XPS analysis showed the change in the amounts of the present functionalities as well as formation of new groups as free carbonyl and carbonate groups. The roughness of the surface increased considerably from ~2 nm to ~75 nm after 100 W–30 min oxygen plasma treatment. ESR analysis indicated the introduction of peroxy radicals by oxygen plasma treatment, and the intensity of the radicals increased with increasing the applied power. Significant decrease in radical concentration was observed especially for the samples treated with higher powers when the samples were kept under the atmospheric conditions. As a conclusion, RF plasma, causes changes in the chemical and physical properties of the materials depending on the applied parameters, and can be used for the creation of specific groups or radicals to link or immobilize active molecules onto the surface of a material. Copyright © 2012 John Wiley & Sons, Ltd.     

Preparation and Characterization of Styrene/Butyl Acrylate Emulsifier-Free Latex with 2-Acrylamido-2-Methyl Propane Sulfonic Acid as a Reactive Emulsifier

A kind of emulsifier-free latex (FL) was successfully synthesized from styrene (St) and butyl acrylate (BA) with 2-acrylamido-2-methyl propane sulfonic acid (AMPS) as a reactive emulsifier. The particle size of latex particles, stability against electrolytes, minimum film forming temperature (MFT) and water contact angle (CA) were evaluated and compared with a conventional latex (CL). Test results show that FL has larger particle size, better stability against electrolytes and lower MFT value compared with CL; higher AMPS content leads to smaller particle size and smaller water CA.     

Influence of Interfacial Tension on Seeded Calcium Carbonate Scale Precipitation: Effect of Adsorbed Asphaltenes

Clay particles with adsorbed asphaltenes, which are commonly found in produced water, have been used as seed particles during precipitation of calcium carbonate in order to determine whether such particles may influence the kinetics of precipitation. The results show that the presence of the adsorbed asphaltenes accelerates the precipitation, and there is also a significant difference between different types of adsorbed asphaltenes. The adsorption of asphaltenes at the seed surface leads to a significant increase in the interfacial tension between the seed surface and the aqueous solution, and calcium carbonate therefore precipitates at the seed surface in order to reduce this high interfacial tension.     

Skin Constituents as Cosmetic Ingredients. Part II: A Study of Bio‐Mimetic Monoglycerides Behavior at the Squalene‐Water Interface by the “Pendant Drop” Method in a Dynamic Mode

This work aims at presenting the viscoelastic behavior of bio‐mimetic monoglycerides used as emulsifier in a mixture made of two non‐miscible liquids, squalene and water. The measurement of the interfacial tension, carried out by the “pendant drop” method in “dynamic” mode, made it possible to characterize these amphiphilic molecules according to the value of their elastic modulus, ?, as well as their relaxation time, τ_R.

The analysis of these parameters, as well as those developed in the previous publication [L. Blasco et al. (2006) Skin constituents as cosmetic ingredients. Part I: A Study of bio‐mimetic monoglyceride behavior at the squalene‐water interface by the “pendant drop” method in a static mode. J. Dispers. Sci. Technol., 27(6).] shows that the hydrocarbon chain structure, such as its length, the presence of one or more unsaturations, hydroxyl function, affects the behavior of surfactant molecules at the squalene/water interface.     

Elastic,dielectric and optical constants of the nematic mixture E49

The Merck nematic mixture E49 exhibits a large nematic interval (0–100 °C) and a large dielectric anisotropy. Both of these features make E49 interesting for applications and basic physics. Unfortunately, no systematic measurements of the material constants of this mixture and their temperature dependence have been reported in the literature. In this paper we report experimental measurements of the splay and bend elastic constants (K ₁₁ and K ₃₃) of the ordinary and the extraordinary refractive indices (n _ort and n _par) at the wavelength λ?=?632.8 nm and of the two elastic constants parallel and orthogonal to the director (ε_par and ε_ort) at the frequency ν?=?5?kHz. The temperature dependence of all of these parameters is found in the temperature range 25–99 °C. The measurements of the elastic constants are performed using both a dielectric and an optical method simultaneously on the same nematic sample. The results obtained using the two methods are in a satisfactory agreement between them within the estimated experimental uncertainty. The ordinary and the extraordinary indices are measured using the prism method.     

Simultaneous effect of carbon and water on NOx adsorption on a stabilized Pt–Ba/Al2O3 catalyst

The influence of the presence of H₂O on the contact between carbon, used as model soot, and a model four-way catalyst (1% Pt–10% BaO/Al₂O₃) was investigated. NO_x adsorption/TPD cycles at 300 °C together with XRD, XPS and DRIFTS characterizations showed that only surface nitrate species are destabilized by the carbon present in the catalytic bed, leading to a decrease of the NO_x storage capacity and carbonate species formation. In another way, injection of water in the reactive gas flow decreases also the NO_x storage capacity of the catalyst, but promotes the formation of stable nitrate species. A non-cumulative effect of carbon and water was observed. It was proposed that a competition between the destabilization, by carbon, of weakly bonded surface nitrate species and the enhancement of bulk nitrate species formation in the presence of water occurs.     

Photophysics of Fluorescent Contact Sensors Based on the Dicyanodihydrofuran Motif

Fluorescent molecular rotors have been used for measurements of local mobility on molecular length scales, for example to determine viscosity, and for the visualization of contact between two surfaces. In the present work, we deepen our insight into the excited-state deactivation kinetics and mechanics of dicyanodihydrofuran-based molecular rotors. We extend the scope of the use of this class of rotors for contact sensing with a red-shifted member of the family. This allows for contact detection with a range of excitation wavelengths up to ∼600 nm. Steady-state fluorescence shows that the fluorescence quantum yield of these rotors depends not only on the rigidity of their environment, but – under certain conditions – also on its polarity. While excited state decay via rotation about the exocyclic double bond is rapid in nonpolar solvents and twisting of a single bond allows for fast decay in polar solvents, the barriers for both processes are significant in solvents of intermediate polarity. This effect may also occur in other molecular rotors, and it should be considered when applying such molecules as local mobility probes.     

纳米表面相互作用及振动测头模型

如何实现高精度的测量是现代制造业及微电子技术领域的热点问题之一. 基于微纳米测头的三坐标测量机是当前实现高精度测量的重要手段. 随着测量尺寸的减小, 常用的纳米/微纳尺度的测头与待测表面之间形成静态接触, 其表面相互作用成为了影响其测量精度和可靠性的关键因素之一. 本文基于一种触发式振动测头, 研究了其动力学模型, 并通过对测头纳米尺度表面相互作用的理论分析及数值模拟, 确立了测头振动参数与表面相互作用之间的关联. 实验研究表明, 参数优化后的谐振微纳测头能有效抑制表面作用带来的干扰, 提高测量精度.     

Investigation of fill factor losses on 20.2% efficient n‐type mono‐like silicon solar cells with laser contact opening

Large area (243.36 cm²) back‐junction passivated emitter, rear totally diffused (PERT) solar cells with laser contact opening (LCO) on n‐type mono‐like crystalline Si with efficiencies of 20.2% are presented. Boron emitters with high electrical quality (implied open circuit voltage iV_OC up to 700 mV) are formed during a co‐diffusion step using SiO_x:B layers. Increasing the rear metal contact coverage, we observed a decrease in fill factor (FF) instead of the expected increase due to the decrease of the back side series resistance. We show that it can be attributed to recombination centers (RCs) in the space charge region underneath the contact spots inducing an increasing second diode contribution. The presented empirical model for the RCs implemented in Synopsys Sentaurus TCAD allows for a successful reproduction of the FF, pseudo FF and V_OC behaviour with contact coverage. According to this model, the RCs induced by laser ablation and subsequently evaporation of Al have a shallow exponential distribution with a characteristic length of L_T = 0.2 µm and an effective surface density of N *_T0 = 25 cm^–1. (© 2016 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

The Formation of Imidazolium Salt Intimate (Contact) Ion Pairs in Solution

1‐n‐Butyl‐2,3‐dimethylimidazolium (BMMI) ionic liquids (ILs) associated with different anions undergo H/D exchange preferentially at 2‐Me group of the imidazolium in deuterated solvents. This process is mainly related to the existence of ion pairs rather than the anion basicity. The H/D exchange occurs in solvents (CDCl₃ and MeCN for instance) in which intimate contact ion pairs are present and the anion possesses a labile H in its structure, such as hydrogen carbonate and prolinate. In D₂O, separated ion pairs are formed and the H/D exchange does not occur. A plausible catalytic cycle is that the IL behaves as a neutral base in the course of all H/D exchange processes. NMR experiments, density functional calculations, and molecular dynamics simulations corroborate these hypotheses.