Influence of corrugation frequency and amplitude on the stress state of hollow elliptic cylinders

The influence of corrugation frequency and amplitude on the displacement and stress fields is analyzed based on an approach to solving stress problems for corrugated elliptical cylinders with certain end conditions.Translated from Prikladnaya Mekhanika, Vol. 40, No. 9, pp. 87–93, September 2004.     

轴压作用下充液圆柱壳屈曲的实验研究

本文从实验及理论两个方面对充满液体的圆柱壳在轴向压力作用下液体内压的变化进行了实际测试及理论定性分析．采用薄壳理论分析了屈曲前液体内压随轴向压力的变化规律，讨论了壳材料、几何参数及边界约束对内压的影响．通过实验实际测定了内压随轴向压力的变化规律．通过实验手段测定了充满液体的圆柱壳临界载荷、屈曲模态，讨论了充满液体的圆柱壳的承载能力等问题．     

绕旋转圆柱流动涡尾流结构和临界状态特性

采用作者提出的基于区域分解，有限差分法与涡法杂交的数值方法，结合高阶隐式差分格式，和以修正的不完全ＬＵ分解为预处理器的共轭梯度法作求解器，系统地研究了雷诺数Ｒｅ＝１０００，旋转速度比α∈（０．５，３．２５）范围内，绕旋转圆柱从突然起到充分发展，长时间内尾流旋涡结构和阻力，升力系数的变化规律，计算所得流动图案与实验流场显示符合很好。数值试验证帝了临界状态的存在，并首次给出了临界状态时的旋涡结构特性。     

Spatial Estimates for the Constrained Anisotropic Elastic Cylinder

This paper establishes spatial estimates in a prismatic (semi-infinite) cylinder occupied by an anisotropic homogeneous linear elastic material, whose elasticity tensor is strongly elliptic. The cylinder is maintained in equilibrium under zero body force, zero displacement on the lateral boundary and pointwise specified displacement over the base. The other plane end is subject to zero displacement (when the cylinder is finite, say). The limiting case of a semi-infinite cylinder is also considered and zero displacement on the remote end (at large distance) is not assumed in this case. A first approach is developed by considering two mean-square cross-sectional measures of the displacement vector whose spatial evolution with respect to the axial variable is studied by means of a technique based on a second-order differential inequality. Conditions on the elastic constants are derived that show the cross-sectional measures exhibit alternative behaviour and in particular for the semi-infinite cylinder that there is either at least exponential growth or at most exponential decay. A second approach considers cross-sectional integrals involving the displacement and its gradient and furnishes information upon the spatial evolution, without restricting the range of strongly elliptic elastic constants. Such models are principally based upon a first-order differential inequality as well as on one of second order. The general results are explicitly presented for transversely isotropic materials and graphically illustrated for a cortical bone.     

亚临界雷诺数下圆柱绕流的大涡模拟

本文应用Smagorinsky涡粘性模式和二阶精度的有限体积法对圆柱绕流的流场进行大涡模拟．求解了非正交曲线坐标系下的N-S方程,对雷诺数为100和20000的工况进行了计算．计算结果与实验及动力涡粘性模式的结果进行了比较,表明计算对于层流及高亚临界雷诺数的湍流流动是合理的     

Regimes of vortex shedding from an in-line oscillating circular cylinder in the uniform flow

A finite volume method for the time dependent viscous incompressible flow around an in-line oscillating circular cylinder at Reynolds number of 200, 855 is presented in this paper. The Navier-Stokes equations in a finite volume form are solved with a moving grid system, based on a time dependent coordinate transformation. To investigate the vortex-shedding characteristics behind the circular cylinder and the effects of Reynolds number and other non-dimensional parameters such as reduced amplitude and reduced frequency， several numerical schemes have been tested with different amplitude and frequency close to Sto and a harmonic at each Reynolds number. Present numerical results indicate several types of vortex shedding mode which is known mainly depending on the reduced frequency and also the reduced amplitude, which is called synchronization or lock-on.     

周向导波在空心圆柱体中传播的数值模拟研究

在石油、化工、食品和城市供水等行业,由于腐蚀等原因而引起泄漏事故,造成巨大的经济损失和资源浪费.因此,能够预先检测到管道缺陷避免事故发生显得十分重要.基于弹性动力学理论,利用Matlab编程实现周向导波在空心圆柱体中传播的数值模拟.利用特征函数展开法计算出周向导波的频散曲线及0.6MHz和1MHz各个模态的时域波形图并据此分析激励方式同周向导波传播的关系,频率为1MHz或0.6MHz时,1和2模态在空心圆柱壳中传播的周向导波中处于主导地位:各模态的径向或周向位移幅度会受到激励入射角的影响而变化并且周向导波的位移幅度随着激励入射角的增加而增加:得到特定频率下,周向导波各模态径向、周向位移的变化关系.本文结果为进一步利用实验方法研究周向导波在空心圆柱体中传播特性和缺陷检测奠定了基础.     

Some new characteristics of the confined flow over circular cylinders at low reynolds numbers

This study summarises some new characteristics of the fluid flow over a confined circular cylinder at low Reynolds numbers. Results from both two- and three-dimensional direct numerical simulations are presented at blockage ratio between 0.1 and 0.9 and Reynolds number between 120 and 500. Floquet stability analysis of selected cases will also be presented. From the two-dimensional simulations, it is found that the fluctuating lift forces decreases with blockage ratio and becomes zero (where the flow is steady) at blockage ratio of approximately 0.7–0.8. Upon further increasing the blockage ratio to 0.9, the simulations show a dramatic increase in the fluctuating lift forces, nearly an order of magnitude greater than previously reported for an unconfined cylinder flow. It is also found that for blockage ratio of 0.5, there is a long term two-dimensional instability that becomes more prominent with increasing Reynolds number. This instability has a time scale of approximately 105 time units ($D/U_{\mathit{max}}$) at Reynolds number of 500. In addition, the transition between two- and three-dimensional flow at blockage ratios up to 0.5 is investigated. It is shown that the transition Reynolds number decreases with increasing blockage ratio. At high blockage ratio of 0.5, as we increase the Reynolds number, the transition to three-dimensional flow is shown to go from unsteady two-dimensional to steady three-dimensional before transitioning to unsteady three-dimensional flow.     

Rotating Variable-thickness Orthotropic Cylinder Containing a Solid Core of Uniform-thickness

This paper presents accurate elastic solutions for the rotating variable-thickness and/or uniform-thickness orthotropic circular cylinders. The present circular cylinder may contain a uniform-thickness solid core of rigid or homogeneously isotropic material. Different cases of rotating cylinders of various cores are investigated. These cylinders include completely isotropic solid cylinder, uniform-thickness orthotropic cylinder containing an isotropic core, variable-thickness orthotropic cylinder containing an isotropic core, uniform-thickness orthotropic cylinder containing a rigid core, and variable-thickness orthotropic cylinder containing a rigid core. For all cases studied, exact elastic solutions are obtained and numerical results are presented. The results include the radial, hoop, and axial stresses and radial displacement of the five cylinder configurations. The distributions of displacement and stresses through the radial direction of the rotating cylinder are obtained and comparisons between different cases are made at the same angular velocity.