存在滑移时两圆球间的幂律流体挤压流动

基于Reynolds润滑理论分析了壁面滑移对任意圆球颗粒间幂律流体的挤压流动的影响。研究表明有壁面滑移时挤压流动的粘性力可通过引进本文定义的滑移修正系数分离出无滑移解。推导出的挤压力滑移修正系数是一积分表达式，依赖于滑移参数、幂律指数、球间隙和积分上限。一般地壁面滑移导致粘性力减小，粘性力的减小量随幂律指数的增大而增大，表明壁面滑移对剪切增稠流变材料有更大的影响；粘性力的减小量还随着滑移参数的增大而增加，而这恰与假设相符合；粘性力的减小量又随球间隙减小或积分上限的增大（从液桥情况到完全浸渍）而减小直到趋于常数，这一特性在离散元模拟时可以有效地减少计算量。     

Sample preparation procedure for the determination of sulphur and trace metals in oil products by the ICP with a minitorch using emulsions

A quick sample preparation method was used for the determination of sulphur and trace metals in oil and oily products by the ICP with a minitorch. Stable aqueous emulsions of oils and oil products were made by using two kinds of emulsifiers (one with low sulphur content, the other sulfonated). Aqueous standard solutions can be used for the preparation of calibration solutions. The contents of S, Al, Cr, Cu, Fe, Mg, Ni and Pb in aqueous emulsions were determined and the results were in good agreement with the composition of oil standard solutions used for control analysis procedure.     

Orientation and relaxation of polymer–clay solutions studied by rheology and small-angle neutron scattering

The influence of shear on viscoelastic solutions of poly(ethylene oxide) (PEO) and clay [montmorillonite, i.e., Cloisite NA+ (CNA)] was investigated with rheology and small-angle neutron scattering (SANS). The steady-state viscosity and SANS were used to measure the shear-induced orientation and relaxation of the polymer and clay platelets. Anisotropic scattering patterns developed at much lower shear rates than in pure clay solutions. The scattering anisotropy saturated at low shear rates, and the CNA clay platelets aligned with the flow, with the surface normal parallel to the gradient direction. The cessation of shear led to partial and slow randomization of the CNA platelets, whereas extremely fast relaxation was observed for laponite (LRD) platelets. These PEO–CNA networklike solutions were compared with previously reported PEO–LRD networks, and the differences and similarities, with respect to the shear orientation, relaxation, and polymer–clay interactions, were examined. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 3102–3112, 2004     

耦合发电机系统的自适应控制与同步

讨论了耦合发电机系统的自适应控制和参数未知时的自适应同步问题.设计了自适应控制器，将耦合发电机系统的混沌轨道镇定到平衡点，并使得两个参数未知的耦合发电机系统达到了混沌同步.数值模拟验证了所设计的控制器的有效性. 关键词： 耦合发电机系统 自适应控制 平衡点 同步     

动态广义球对称含荷黑洞的统计熵

利用改进了的brickwall膜模型,计算了动态广义球对称含荷黑洞的熵,研究结果表明,对于动态黑洞,将黑洞熵表示为与视界面积成正比时,则比例系数总与动态黑洞的视界速度有关 关键词： 广义球对称黑洞 黑洞熵 brick-wall膜模型 WKB近似     

Thermal stability of shear-induced precursor structures in isotactic polypropylene by rheo-X-ray techniques with couette flow geometry

Combined in situ rheo-SAXS (small-angle X-ray scattering) and -WAXD (wide-angle X-ray diffraction) studies using couette flow geometry were carried out to probe thermal stabilty of shear-induced oriented precursor structure in isotactic polypropylene (iPP) at around its normal melting point (162 °C). Although SAXS results corroborated the emerging consensus about the formation of “long-living” metastable mesomorphic precursor structures in sheared iPP melts, these are the first quantitative measures of the limiting temperature at which no oriented structures survive. At the applied shear, rate = 60 s⁻¹ and duration t_s = 5 s, the oriented iPP structures survived a temperature of 185 °C for 1 h after shear, while no stable structures were detected at and above 195 °C. Following Keller's concepts of chain orientation in flow, it is proposed that the chains with highly oriented high molecular weight fraction are primarily responsible for their stability at high temperatures. Furthermore, the effects of flow condition, specifically the shear temperature, on the distributions of oriented and unoriented crystals were determined from rheo-WAXD results. As expected, at a constant flow intensity (i.e., rate = 30 s⁻¹ and duration, t_s = 5 s), the oriented crystal fraction decreased with the increase in temperature above 155 °C, below which the oriented fraction decreased with the decrease in temperature. As a result, a crystallinty “phase” diagram, i.e., temperature versus crystal fraction ratio, exhibited a peculiar “hourglass” shape, similar to that found in many two-phase polymer–polymer blends. This can be explained by the competition between the oriented and unoriented crystals in the available crystallizable species. Below the shear temperature (155 °C), the unoriented crystals crystallized so rapidly that they overwhelmed the crystallization of the oriented crystals, thus depleting a major portion of the crystallizable species and increasing their contribution in the final total crystalline phase. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3553–3570, 2006     

Acrylic acid level and adhesive performance and peel master‐curves of acrylic pressure‐sensitive adhesives

Three series of pressure‐sensitive adhesives were prepared with constant glass‐transition temperature, using emulsion polymerization. The monomers chosen were butyl acrylate, 2‐ethylhexyl acrylate (EHA), methyl methacrylate (MMA), and acrylic acid (AA). Within each polymer series, the proportion of AA monomer was held constant for each polymer preparation but acrylic ester monomer levels were varied. Adhesion performance was assessed by measurement of loop tack, static shear resistance, and through the construction of peel master‐curves. Peel master‐curves were generated through peel tests conducted over a range of temperatures and peel rates and through application of the time–temperature superposition principle. Bulk effects dominated by polymer zero shear viscosity change as AA and EHA levels were varied were attributed to the observed effect on static shear resistance and the horizontal displacements of peel master‐curves. Static shear resistance was found to strongly correlate with log(a_C), a parameter introduced to horizontally shift peel master‐curves to form a superposed, “super master‐curve”. An interfacial interaction was proposed to account for deviations observed when loop tack was correlated with log(a_C). Surface rearrangements via hydrogen bonding with the test substrate were suggested as responsible for the interfacial interaction. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1237–1252, 2006     

Computation of moisture and temperature profiles in soil—The coupled model

The coupled model has been developed in this study for moisture transport and beat exchange in soil. The model is driven by atmospheric conditions measured in a field. The concept that soil has a surface resistance to evaporation is introduced in order to relate the evaporation from surface with the vapour flux in air. With the use of this concept, the simulation results agree quite well with the measured data.     

运用严格耦合波理论计算平面电介质光栅的衍射效率

本文阐述了严格耦合波理论的基本思想。针对横电波的情况，详细分析了运用严格耦合波理论实现光栅衍射效率计算的方法，并且进一步给出了编制计算衍射效率程序的步骤。通过一个具体计算实例表明：各衍射级分布的光能量之和等于入射光的能量，满足能量守恒定律，从而证实了计算结果的正确性。