Self‐Assembly,Spectroscopic and Electrochemical Studies of Nickel(II)‐4,8‐Diazaundecanediamide Complex

The self‐assembly of NiCl₂·6H₂O with a diaminodiamide ligand 4,8‐diazaundecanediamide (L‐2,3,2) gave a [Ni(C₉H₂₀N₄O₂)(Cl)(H₂O)] Cl·2H₂O ( 1 ). The structure of 1 was characterized by single‐crystal X‐ray diffraction analysis. Structural data for 1 indicate that the Ni(II) is coordinated to two tertiary N atoms, two O atoms, one water and one chloride in a distorted octahedral geometry. Crystal data for 1: orthorhombic, space group P 21nb, a = 9.5796(3) Å, b = 12.3463(4) Å, c = 14.6305(5) Å, Z = 4. Through NH···Cl–Ni (H···Cl 2.42 Å, N···Cl 3.24 Å, NH···Cl 158°) and OH···Cl–Ni contacts (H···Cl 2.36 Å, O···Cl 3.08 Å, OH···Cl 143°), each cationic moiety [Ni(C₉H₂₀N₄O₂) (Cl)(H₂O)]⁺ in 1 is linked to neighboring ones, producing a charged hydrogen‐bonded 1D chainlike structure. Thermogrametric analysis of compound 1 is consistent with the crystallographic observations. The electronic absorption spectrum of Ni(L‐2,3,2)²⁺ in aqueous solution shows four absorption bands, which are assigned to the ³A_2g → ³T_2g, ³T_2g → ¹Eg, ³T_2g → ³T_1g, and ³A_2g → ³T_1g transitions of triplet‐ground state, distorted octahedral nickel(II) complex. The cyclic volammetric measurement shows that Ni²⁺ is more easily reduced than Ni(L‐2,3,2)²⁺ in aqueous solution.     

BaF（Cl,Br）：Sm^2＋的光谱烧孔与光激励发光过程

Ｘ射线辐照前后，在ＢａＦ（Ｃｌ，Ｂｒ）：Ｓｍ＾２＋中以５６０ｎｍ的Ｎｄ：ＹＡＧ脉冲光在液氮温度下进行了双光子烧孔实验和光激励发光实验，结果表明，Ｓｍ＾２＋掺杂的碱土金属氟卤化物光谱烧孔过程中伴随着光激励发光过程，这一过程直接影响光谱烧孔过程的进行。     

碳纳米管添加剂对质子交换膜燃料电池低铂载量膜电极性能的影响研究

以碳纳米管（CNT）作为低铂载量膜电极（CCM）催化层（0.1 mg_Pt·cm^-2）添加剂，研究了CNT的添加方式对催化层微观结构以及膜电极性能的影响.结果表明，与常规低铂载量催化层相比，在其表面喷涂一层CNT或将CNT均匀分散到Pt/C催化层中均有利于提升低铂载量膜电极的输出性能，在70℃和100%相对湿度条件下最高输出功率比常规低铂载量膜电极的0.522 W·cm^-2分别提升了22.4%和60.0%，并且均匀分散添加方式优于分层添加方式.其原因在于分层添加CNT后改善了低铂催化层和气体扩散层之间的接触界面，降低了催化层与扩散层间的接触电阻，而均匀分散添加方式除了可降低界面接触电阻外，还显著改善了低铂催化层中的气体传输，大幅提升了Pt催化剂的利用效率，使得膜电极电化学反应电阻明显降低.进一步对均匀分散添加方式中CNT的载量进行优化，表明CNT添加量为37.5 μg·cm^-2时电池输出性能最佳，70℃和100%相对湿度条件下的最大输出功率达到0.91 W·cm^-2.本研究工作表明，将CNT均匀分散添加到催化层中是一种有效提升低铂载量膜电极性能的方法.     

Reversible Immobilization of Peptides: Surface Modification and In Situ Detection by Attenuated Total Reflection FTIR Spectroscopy

A generic method is described for the reversible immobilization of polyhistidine‐bearing polypeptides and proteins on attenuated total reflecting (ATR) sensor surfaces for the detection of biomolecular interactions by FTIR spectroscopy. Nitrilotriacetic acid (NTA) groups are covalently attached to self‐assembled monolayers of either thioalkanes on gold films or mercaptosilanes on silicon dioxide films deposited on germanium internal reflection elements. Complex formation between Ni²⁺ ions and NTA groups activates the ATR sensor surface for the selective binding of polyhistidine sequences. This approach not only allows a stable and reversible immobilization of histidine‐tagged peptides (His–peptides) but also simultaneously allows the direct in situ quantification of surface‐adsorbed molecules from their specific FTIR spectral bands. The surface concentrations of both NTA and His–peptide on silanized surfaces were determined to be 1.1 and 0.4 molecules nm^?2, respectively, which means that the surface is densely covered. A comparison of experimental FTIR spectra with simulated spectra reveals a surface‐enhancement effect of one order of magnitude for the gold surfaces. With the presented sensor surfaces, new ways are opened up to investigate, in situ and with high sensitivity and reproducibility, protein–ligand, protein–protein, protein–DNA interactions, and DNA hybridization by ATR–FTIR spectroscopy.     

Titanium-based molecular squares and rectangles: syntheses by self-assembly reactions of titanocene fragments and aromatic N-heterocycles

This paper reports on the potential of titanium compounds as building blocks for supramolecular polygons. Self-assembly reactions of low-valent titanocene units and N-heterocyclic bridging ligands lead to novel titanium-based supramolecular squares. Pyrazine (3), 4,4'-bipyridine (4), and tetrazine (5) were used as bridging ligands, and the acetylene complexes [Cp2Ti{eta2-C2(SiMe3)2}] (1) and [(tBuCp)2Ti{eta2-C2(SiMe3)2}] (2) as sources of titanocene fragments. Molecular rectangles can be synthesized by stepwise reduction of the titanocene dichlorides [Cp(2)TiCl2] and [(tBuCp)2TiCl2] and consecutive coordination of two different bridging ligands. The resulting complexes are the first examples of molecular rectangles containing bent metallocene corner units. Single-crystal X-ray analyses of the tetranuclear compounds revealed the geometric properties of the molecular polygons in the solid state. Comparison of bond lengths and angles in coordinated and free ligands reveals the reduced state of the bridging ligand in the low-valent titanium compounds. The syntheses and properties of these novel, highly air- and moisture-sensitive compounds are discussed.     

Self-assembled metallocycles with two interactive binding domains

Five metallocycles 1 a-e have been self-assembled from S-shaped bispyridyl ligands 2 a-e and a palladium complex, [Pd(dppp)(OTf)(2)] (dppp=1,3-bis(diphenylphosphanyl)propane), and have been characterized by elemental analysis and various spectroscopic methods including (1)H NMR spectroscopy and electrospray ionization (ESI) mass spectrometry. These metallocycles all are monocyclic compounds, but can fold to generate two binding domains bearing hydrogen-bonding sites based on pyridine-2,6-dicarboxamide units. The binding properties of the metallocycles with N,N,N',N'-tetramethylterephthalamide (G) have been probed by means of ESI mass spectrometry and (1)H NMR spectroscopy. The results both in the gas phase and in solution are consistent with the fact that the metallocycles accommodate two molecules of the guest G. Thus, the ESI mass spectra clearly show fragments corresponding to the 1:2 complexes in all cases. (1)H NMR studies on 1 a and G support the formation of a 1:2 complex in solution; the titration curves are nicely fitted to a 1:2 binding isotherm, but not to a 1:1 binding isotherm. In addition, a Job plot also suggests a 1:2 binding mode between 1 a and G, showing maximum complexation at approximately 0.33 mol fraction of the metallocycle 1 a in CDCl(3). The binding constants K(1) and K(2) are calculated to be 1600 and 1400 M(-1) (+/-10 %), respectively, at 25 degrees C in CDCl(3), indicative of positively cooperative binding. This positive cooperativity was confirmed by the Hill equation, affording a Hill coefficient of n = 1.6. Owing to insufficient solubility in CDCl(3), for comparison purposes the binding properties of the metallocycles 1 b-e were investigated in a more polar medium, 3 % CD(3)CN/CDCl(3). (1)H NMR titrations revealed that the metallocycles all bind two molecules of the guest G with Hill coefficients ranging from 1.4 to 1.8. This positive cooperativity may be attributed to a structural reorganization of the second binding cavity when the first guest binds to either one of the subcavities present in the metallocycles.     

Syntheses,Characterization and Crystal Structures of Three Structurally Similar Dinuclear Schiff Base Cadmium(II) Complexes with Bridging Azide or Thiocyanate Ligands

Three novel Schiff base cadmium(II) complexes, derived from the end‐on (μ‐1,1‐N₃) azide or end‐to‐end (μ‐1,3‐NCS) thio cyanate bridges and similar tridentate Schiff base ligands, have been synthesized under similar synthetic procedures and their crystal structures determined by X‐ray diffraction methods. They are the dinuclear double end‐on azide‐bridged [Cd₂(L1)₂(N₃)₂(μ‐1,1‐N₃)₂] ( 1 ), the dinuclear double end‐on azide‐bridged [Cd₂(L2)₂(N₃)₂(μ‐1,1‐N₃)₂] ( 2 ), and the dinuclear double end‐to‐end thiocyanate‐bridged [Cd₂(L3)₂(NCS)₂(μ_1,3‐NCS)₂] ( 3 ), where L1, L2 and L3 are three similar tridentate Schiff bases obtained by condensation of 2‐pyridylaldehyde with N,N‐diethylethane‐1,2‐diamine, of 2‐pyridylaldehyde with N‐isopropylethane‐1,2‐diamine, and of 2‐pyridylaldehyde with N,N‐dimethylpropane‐1,3‐diamine, respectively. Each cadmium(II) centre in the complexes is in a distorted octahedral coordination. There is a crystallographic inversion centre in each of the complexes. The similar small ligands used as the secondary ligands in the preparation of the cadmium(II) complexes with similar Schiff bases can result in similar structures.     

Metal-complex assemblies constructed from the flexible hinge-like ligand H2bhnq: structural versatility and dynamic behavior in the solid state

Novel metal-complex assemblies constructed from the flexible hinge-like ligand H(2)bhnq (H(2)bhnq=2,2'-bi(3-hydroxy-1,4-naphthoquinone)) have been synthesized. The X-ray crystal structures of these compounds reveal that four types of architectures are accessible by variation of the metal ions. In copper(II) compounds 1-3, the chelating bhnq(2-) ions bridge copper(II) centers to form one-dimensional zigzag chains. The chains of 1-3 are arranged by hydrogen-bonding interactions and stacking interactions to produce porous structures. Cobalt(II) and zinc(II) compounds 4 and 5 form one-dimensional helical chains. In 4 and 5, the crystal packing induces spontaneous resolution of the helical chains with chiral cavities formed perpendicular to the helices. Nickel(II) compounds 6 and 7 form cyclic tetramers. The fourth architecture, a dimer (compound 8), is obtained by the reaction of zinc(II) and bhnq(2-) in MeOH. In these compounds, changes of the dihedral angles and the metal-coordination mode of the bhnq(2-) ion induce the structural versatility. The assemblies of the zigzag chains of the copper(II) compounds exhibit reversible vapochromic behavior. UV/Vis, powder X-ray diffraction, EPR, and adsorption isotherm measurements indicate that this vapochromic behavior is based on the hinge-like flexibility of the bhnq(2-) ion.