简便快速的硫化氢测定法

本文提出了有一种简易快速测定剂来测定水样中的硫化氢的方法。该法的检出限为０．１ｍｇ／Ｌ，对１．０１ｍｇ／Ｌ的Ｈ２Ｓ样品７次测定的相对标准偏差＜４．１％，１ｈ能测定１２个样品。用本测定了几种水样中的Ｈ２Ｓ含量，回收率为８４％－１０５％。应用它可上标准法的４ｈ左右缩短到５ｍｉｎ；使分析成本降低９／１０；不需配制一系列分析试剂和仪器，只需一支小型塑料管和几片药片，便于渔业水质和环境水质的野外现场监测。     

Quantitative analysis of imazamox herbicide in environmental water samples by capillary electrophoresis electrospray ionization mass spectrometry

Capillary electrophoresis-mass spectrometry (CE-MS) with an electrospray ionization interface was applied for the quantitative analysis of imazamox pesticide in well water, potable water, and pond water. The detector response for imazamox was determined to be linear over the concentration range of 50-1 ng/ml. The limits of quantitation and detection of the method were determined to be 200 and 20 ng/l for imazamox compound in each type of water sample, respectively. The total sample preparation and CE-MS analysis time was under 2 h.     

氢化物发生-原子荧光光谱法测定水中汞的测量不确定度分析

对氢化物发生-原子荧光光谱法测定水中汞的分析方法的测量不确定度进行了估计。认为在分析的全过程中,标准溶液的配制、校准曲线的绘制以及试样的分析是测量不确定度的三项主要来源。基于这一认识,建立了相应的数学模型,对关系式中的各个变量作了分析并对其不确定度进行量化。最后,按统计学的计算方法给出了合成不确定度和扩展不确定度。     

Suppression of red cell diffusional water permeability by lipophilic solutes

The inhibitory effect of a series of neutral lipophilic solutes (methanol, ethanol, n-propanol, iso-propanol, n-butanol, iso-amylalcohol, n-hexanol, diethylether, nitrobenzene, and pyridine) on the diffusional water permeability (Pd, tot) of bovine erythrocyte membrane at 25 degrees C was studied in comparison to that of p-chloromercuri benzoate (pCMB). Permeability data were obtained by measuring the transmembrane diffusional water exchange time tau(exch) using an 1H-T2 NMR technique. Maximal inhibition by approximately 50% of Pd, tot was produced by 2 mM pCMB which completely blocked the membrane water channels in 20 min, hence suggesting the channel-to-lipid diffusional water permeability ratio of about 1:1. Furthermore, the maximal inhibitory effect of pCMB in combination with the lipophilic solutes was lower than that of pCMB alone. As pCMB does not interfere with the lipid bilayer, and provided that it blocks the water channels in solute presence as well, this confirms that the solutes induce an increase in the lipid-mediated background water permeability contribution (Pd, lipid) by the formation of aqueous leaks in the membrane hydrophobic barrier. However, faster but less efficient in permeability inhibition than pCMB (either alone or combined with solutes) were the lipophilic solutes alone. Taken together, the results indicate that the lipophilic solutes suppress the membrane total permeability Pd, tot by two opposing effects: a reduction of its channel-mediated part (Pd, channel) to the extent exceeding that of a simultaneous Pd, lipid increase. The inhibitory potency of the solutes tested appears to be correlated with their solubility in the membrane medium.     

光度法测定水样中铝

研究了铝与对乙酰基偶氮胂(ASApA)显色反应,在pH 4.7的HOAc-NaOAc缓冲溶液中,Al3+与ASApA显色形成1:2络合物,最大吸收波长位于612 nm,ε-8.19×103L·mol-1·cm-1,铝量在0～2.8μg·ml-1范围内遵守比耳定律,用于水样中铝的测定,结果满意。     

On-line determination of organophosphorus pesticides in water by solid-phase microextraction and gas chromatography with thermionic-selective detection

This paper describes the extraction of 49 organophosphorus pesti-cides (OPPs) from water samples using solid-phase microextraction (SPME). Three fibers, including a 15-μm XAD-coated fiber, a 85-μm polyacrylate-coated fiber, and a 30-μm polydimethylsilox-ane-coated fiber (PDMS), were evaluated here. The effects of stirring and the addition of NaCl to the sample were examined for the polyacrylate-coated fiber. The precision of the technique was examined for all three fibers and the extraction kinetics were investigated using the XAD- and polyacrylate-coated fibers. With some exceptions, the XAD- and polyacrylate-coated fibers performed better than the PDMS-coated fiber. The superiority of the XAD-nd polyacrylate-coated fiber. The superiority of the XAD- and polyacrylate-coated fibers over the PDMS-coated fibers can be attribuibuted to the aromatic functionalities of the XAD and the polar functionalities in the polyacrylate. The relatively high percent RSDs indicate that the SPME technique needs to be further refined before it can be used for anything other than screening. A more effective form of agitation than mechanical stirring may be neccessary to reduce variability and achieve a faster equilibrium between the sample and the SPME fiber.     

Applicability of headspace solid-phase microextraction to the determination of multi-class pesticides in waters

The applicability of headspace solid-phase microextraction (HS-SPME) to pesticide determination in water samples was demonstrated by evaluating the effects of temperature on the extraction of the pesticides. The evaluations were performed using an automated system with a heating module. The 174 pesticides that are detectable with gas chromatograph were selected objectively and impartially based on their physical properties: vapor pressure and partition coefficient between octanol and water. Of the 174 pesticides, 158 (90% of tested) were extracted with a polyacrylate-coated fiber between 30 and 100 degrees C and were determined with gas chromatograph-mass spectrometry. The extraction-temperature profiles of the 158 extracted pesticides were obtained to evaluate the effects of temperature on the extraction of pesticides. The pesticides were classified into four groups according to the shape of their extraction-temperature profiles. The line of demarcation between extractable pesticides and non-extractable pesticides could be drawn in the physical property diagram (a double logarithmic plot of their vapor pressure and partition coefficient between octanol and water). The plot also revealed relationships between classified extraction features and their physical properties. The new method for multi residue screening in which the analytes were categorized into sub-groups based on extraction temperature was developed. In order to evaluate the quantitivity of the developed method, the 45 pesticides were chosen among the pesticides that are typically monitored in waters. Linear response data for 40 of the 45 was obtained in the concentration range below 5 microg/l with correlation coefficients ranging between 0.979 and 0.999. The other five pesticides had poor responses. Relative standard deviations at the concentration of the lowest standard solution for each calibration curve of the pesticides ranged from 3.6 to 18%. The value of 0.01 microg/l in the limits of detection for 17 pesticides was achieved only under the approximate conditions for screening, not under the individually optimized conditions for each pesticide. Recoveries of tested pesticides in actual matrices were essentially in agreement with those obtained by solid-phase extraction.     

Optical biosensor for pharmaceuticals, antibiotics, hormones, endocrine disrupting chemicals and pesticides in water: Assay optimization process for estrone as example

Certain contaminants at trace concentrations in surface waters can have dramatic effects on the hormonal system of organisms in the aquatic environment. Therefore, immunoanalytical methods at a very low limit of detection (LOD) and a low limit of quantification (LOQ) are becoming more and more important for environmental analysis and especially for monitoring drinking water quality. Environmental monitoring of antibiotics, hormones, endocrine disrupting chemicals, and pesticides in real water samples (e.g. surface, ground or drinking water) with difficult matrices places high demands on chemical analysis. Biosensors have suitable characteristics such as efficiency in allowing very fast, sensitive, and cost-effective detection. Here we describe an assay optimization process with a fully automated immunoassay for estrone which resulted in a LOD below 0.20 ng L⁻¹ and a LOQ below 1.40 ng L⁻¹. In contrast to common analytical methods such as GC-MS or HPLC-MS, the biosensor used requires no sample pre-treatment and pre-concentration. The very low validation parameters for estrone are the result of the continuous optimization of the immunoassay. The basis of our sensitive assay is the antibody with a high affinity constant towards estrone. During the optimization process, we reduced the amount of antibody per sample and improved the chip surface modification. Finally, this proceeding led to a calibration routine with an amount of antibody of only 3.0 ng per sample (sample volume: 1.0 mL). The reduction of the amount of antibody per sample results in better validation parameters (LOD, LOQ, and IC₅₀), but this reduction leads to the current device-related limitation of the River Analyser (RIANA).For some endocrine disrupting compounds, no effect levels (NOELs) in the lower nanogram per liter range are reported. This defines the challenge, which analytical methods have to compete with and our RIANA instrument with its improved sensitivity for the detection of a single hormone in the lower nanogram per liter range is a powerful tool in aquatic analytics in addition to the common analytical methods.     

Limiting Partial Molar Volumes of Electrolytes in 2-Methyl-2-Butanol <Emphasis Type="Bold">+</Emphasis> Water Mixtures at 298.15 K

Partial molar volumes at infinite dilution, V⁰₂, of alkali–metal halides (LiCl, NaCl KCl RbCl CsCl, NaBr, KBr, KI), tetra-n-alkylammonium bromides, R₄NBr (R=Me, Et, n-Pr, n-Bu, n-Pen), NaBPh₄, and Ph₄PCl have been determined in binary solvent mixtures of water with 2-methyl-2-butanol covering the water-rich region and the alcohol-rich region at 298.15 K. V⁰₂ for alkali–metal halides show relatively little dependence on the solvent composition. However, in the case of hydrophobic electrolytes the observed effects are more pronounced. A good linear dependence between V⁰₂(R₄NBr) and the molecular weight of the tetra-n-alkylammonium cation is found. Limiting single-ion volumes have been obtained using the assumption that V⁰(Ph₄P⁺)–V⁰(BPh^–₄)=2.0 cm³-mol^–1. The trends in the single-ion volumes are discussed in both solvent regions.     

Liquid–solid disk extraction followed by supercritical fluid elution and gas chromatography of phenols from water

A method combining the techniques of liquid – solid disk extraction (LSDE) and supercritical fluid elution (SFE) has been developed for the phenols regulated by the Clean Water Act. LSDE uses a disk or membrane made of polytetrafluoroethylene (PTFE) fibrils impregnated with small particles, e.g. styrene divinylbenzene (SDB) resin, to extract phenols from water. After disk extraction the retained analytes are eluted from the disk using SFE. SFE is used as an alternative to liquid solvent elution with an organic solvent. Analytes are separated, identified, and quantified using gas chromatography – ion trap detector mass spectrometry (GC-ITDMS). The method is capable of sub parts per billion detection limits, and precision of 5–28% RSD. Evaluation of various disks or membranes, such as C₁₈-silica disks, SDB disks, and ion exchange membranes, has also been performed for the extraction of phenols from water. The results obtained from the in-situ aqueous acetylation of phenols and extraction of their acetates are quantitative. The utilization of LSDE and SFE techniques has proven to be a more effective approach than liquid – liquid extraction in minimizing air pollution and solvent waste.