超临界co2中模板法制备氧化铝多孔材料

超临界co2;活性炭;模板;氧化铝;多孔     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

微乳凝胶法制备MoO3/SiO2纳米复合氧化物及DSC-TG分析

由微乳凝胶法制备了一系列不同MoO3含量的MoO3/SiO2纳米复合氧化物,运用DSC-TG,TEM,XRD和FT-IR等技术对其进行了相应表征.结果表明:所制备复合氧化物适宜的焙烧温度为300℃;样品粒径分布在20~24 nm;样品中MoO3在SiO2表面分散良好,其单层分散阈值在12~12.5%之间;表面Mo与Si原子以Mo—O—Si键联接.     

Controlled-porosity glasses as alternative adsorbents to silica gel for HPLC

Summary The paper deals with the use of controlled-porosity glasses (CPGs) as adsorbents for HPLC. The physicochemical and chromatographic properties of small-pore CPGs are compared to the analogous properties of silica gels. The results show good correlation between them and suggest the possibility of application of CPGs as adsorbents for liquid chromatography.     

Rate processes on fractals: Theory,simulations, and experiments

Heterogeneous kinetics are shown to differ drastically from homogeneous kinetics. For the elementary reaction A + A products we show that the diffusion-limited reaction rate is proportional tot ^– h[A]² or to [A]^x, whereh=1- d _s/2, X=1+2/d _s =(h-2)(h-1), andd _s is the effective spectral dimension. We note that ford = d _s =1, h =1/2 andX = 3, for percolating clustersd _s = 4/3,h = 1/3 andX = 5/2, while for dust ds <1, 1 >h > 1/2 and >X > 3. Scaling arguments, supercomputer simulations and experiments give a consistent picture. The interplay of energetic and geometric heterogeneity results in fractal-like kinetics and is relevant to excitation fusion experiments in porous membranes, films, and polymeric glasses. However, in isotopic mixed crystals, the geometric fractal nature (percolation clusters) dominates.     

Nanostructure Pt Electrode Obtained via Self-assembly of Nanoparticles on Conductive Oxide-coated Glass Substrate

Self-assembly of platinum nanoparticles were applied to fabrication of counter electrode for dye-sensitized solar cells on conductive oxide-coated glass substrate. The present Pt electrode exhibits high exchange current density of 220 mA/cm^2, which is comparable to those prepared by electrodeposition, magnetron sputtering or thermal decomposition of platinum chloride. After analysis by transmission electron microscopy (TEM), atomic force microscopy (AFM) and X-ray photoelectron spectroscopy (XPS), it was found that the catalyst was structurally characterized as nanosized platinum metal clusters and was continuously arranged on electrode surface. The present nanostructure electrode had high electrocatalytic activity for the reduction of iodine in organic solution.     

可降解自固化类骨磷灰石支架的研究

0引言一直以来,钙磷生物材料如羟基磷灰石(hy-droxyapatite,HA)由于其成份与骨的无机成份相似,具有良好的生物相容性,作为骨修复材料引起了人们广泛的兴趣。磷酸钙骨水泥是一类可在生理条件下自固化的非陶瓷型类HA人工骨材料,这种由磷酸钙骨水泥(calcium phosphate cement,CPC)转变而成的HA,与天然骨磷灰石有类似的组成结构,植入人体后可参与新陈代谢,促进骨组织生长[1,2]。一些研究显示,CPC具有成骨活性和生物降解性,在体内被吸收的同时可引导新骨的生成,从而可克服自体骨、磷酸三钙陶瓷因吸收降解过快造成的局部缺陷以及陶瓷型HA长…     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

天然蚕丝与丝素蛋白多孔膜的生物降解性研究

较为详细地研究了经不同条件处理的丝素蛋白多孔膜材料和天然蚕丝在蛋白酶作用下的降解性能以及降解前后材料的微观形貌和结构的变化. 结果表明, 丝素蛋白材料中不同结构(构象)的含量是影响其降解速度的一个重要因素. 对于由再生丝素溶液所制备的材料, 调控其中Silk II结构(β-折叠构象)的比例可能是控制丝素蛋白材料降解速度的有效途径.     

Steam-carbon gasification catalyzed by calcium: Assessment of the porous structure of active carbons from plum stones and synthetic active carbons

A need for an elaboration of the methods for synthesis and characterization of activated carbons with a requisite porous structure has existed for a long time. One of the methods giving possibility for creating controlled mesopore and micropore structures deals with the steam gasification of various carbon materials. In this work the effects of calcium catalyst on the catalytic steam gasification of active carbons from plum stones and porous polymers are presented. Determination of micropores capacity and specific adsorption in mesopores have been performed by means of the _s method, but adsorption on the heterogeneous solids was described by the integral equation with various local isotherms. This equation has been solved by the regularization method. Based on this method the changes in structural parameters of active carbons depending on the amount of calcium catalyst were estimated.Nomenclature d width of slit-like micropore - F(x) distribution function of the half-width - p vapor pressure of sorbate - p/p _N relative pressure - PSAC Plum Stone Active Carbon - average pore radius, nm - S ₁ relative limit of the validity of experimental point on the adsorption isotherm in the computations by means of regularization method - SAC Synthetic Active Carbon - S _BET specific surface area calculated by means of BET method, m²/g - S _mes mesopore surface area, m²/g - S _mic micropore surface area, m²/g - T absolute temperature, K - V _mes sorption capacity of mesopores, cm³/g - V _mic sorption capacity of micropores, cm³/g - V _p sorption capacity of pores, cm³/g - w/w weight in weight concentration - x half-width of slit-like micropore, nm - x ₁ maximum of half-width of micropore slit, nm - average half-width of slit-like micropore, nm - X _min-X _max integration limits of thex Greek Letters Greek Letters variance of average half-width of slit-like micropore, nm² - local relative filling of micropores - total relative filling of micropores