聚合物共混物脆韧转变性能研究 Ⅱ准韧性聚合物共混物脆韧转变的几何模型

给出了分散相粒间基体层厚度Ｔ与分散相粒径（ｄ）、粒径分散度（σ）和分散相体积分数（）的定量关系式．发现σ对Ｔ的影响与有关，不仅Ｔ随σ的增大而增大，而且越大，这种影响越显著．用计算机图像分析仪直接测定了聚氯乙烯／丁腈橡胶、聚丙烯（ＰＰ）／三元乙丙橡胶、ＰＰ／乙烯 醋酸乙烯酯共聚物共混物的Ｔ，发现这三种共混物的Ｔ近似于对数正态分布．理论预示与实验结果很好符合．     

金属基上以YSZ为过渡层的YBCO薄膜的微观结构

采用透射电子显微术（ＴＥＭ），研究了用磁控溅射技术在柔性金属基体上制备的、钇稳定的ＺｒＯ２（ＹＳＺ）为过镀层的ＹＢａ２Ｃｕ３Ｏ７－ｙ（ＹＢＣＯ）薄膜的横断面结构。所得ＹＢＣＯ膜的超导临界转变温度Ｔｃ为９１Ｋ，临界电流密度Ｊｃ＝２×１０３Ａ／ｃｍ２（７７Ｋ，０Ｔ）。基体为Ｎｉ基合金（ＨａｓｔｅｌｏｙＣ）。ＹＳＺ层为致密、均匀的细晶组织，约１２μｍ厚，具有织构取向，并与基体紧密连接。ＹＢＣＯ层的厚度不均匀，约５００ｎｍ；ＹＢＣＯ／ＹＳＺ界面有时连接较差，在该界面上有杂质出现，杂质有可能引发裂纹。     

Evaluation of the sputtering rate variation in SIMS ultra‐shallow depth profiling using multiple short‐period delta layers

We have developed multiple short‐period delta layers as a reference material for SIMS ultra‐shallow depth profiling. Boron nitride delta layers and silicon spacer layers were sputter‐deposited alternately, with a silicon spacer thickness of 1–5 nm. These delta‐doped layers were used to measure the sputtering rate change in the initial stage of oxygen ion bombardment. A significant variation of sputtering rate was observed in the initial 3 nm or less. The sputtering rate in the initial 3 nm was estimated to be about four times larger than the steady‐state value for 1000 eV oxygen ions. Copyright © 2003 John Wiley & Sons, Ltd.     

Simultaneous determination of trace uranium(VI) and zinc(II) by adsorptive cathodic stripping voltammetry with aluminon ligand

Uranium(VI) complexed with aluminon (3-[bis(3-carboxy-4-hydroxy-phenyl)methylene]-6-oxo-1,4-cyclohexadiene-1-carboxylic acid triammonium salt) was determined by adsorptive cathodic stripping voltammetry (ACSV) using a hanging mercury drop electrode. Trace uranium(VI) and zinc(II) can be simultaneously determined in a single scan in the presence of aluminon and urea. Optimal conditions were found to be: accumulation time; 180–200 s, accumulation potential; 50 mV versus Ag/AgCl, scan rate; 40 mV s⁻¹, supporting electrolyte; 0.1 M sodium acetate buffer at pH 6.5–7.0, and concentration of aluminon; 1×10⁻⁶ M. The linear range of uranium(VI) and zinc(II) were observed over the concentration range 2–33 and 30–120 ng ml⁻¹, respectively. The detection limit (S/N=3) are 0.2 ng ml⁻¹ (uranium) and 30 ng ml⁻¹ (zinc). A good reproducibility shows RSDs of 2.5–4.0% (n=10). The procedure offers high selectivity, with the presence of urea masking some metal ions.     

Thin‐Layer Cyclic Voltammetric and Scanning Electrochemical Microscopic Study of Antioxidant Activity of Ascorbic Acid at Liquid/Liquid Interface

An electron transfer reaction between ascorbic acid (H₂A) in an aqueous solution and oxidizing agent in an organic solution immiscible with water has been studied by thin‐layer cyclic voltammetry (TLCV) for charge transfer at the interface between two immiscible electrolyte solutions (ITIES). As an antioxidant, H₂A provide electrons through the aqueous/organic interface to reduce Fc⁺ and the procedure has been proved to be a one electron process again. In this work, the first combination of TLCV and scanning electrochemical microscopy (SECM) was achieved and showed a reasonable agreement between the results from the two different approaches. Otherwise, lower concentration ratios Kr of aqueous to organic reactants was adopted, which is given as evidence to the proposed procedure of Barker.     

Electron Probe Microanalysis of HfO2 Thin Films on Conductive and Insulating Substrates

Quantitative electron probe microanalysis of highly insulating materials is a complicated problem, partially solved by coating samples with grounded thin conductive layers or using novel scanning electron microscopy (SEM) techniques, such as low-voltage and/or variable pressure SEM. In this work, some problems of quantitative X-ray microanalysis of thin HfO₂ films, in particular the possibility to determine mass thickness correlated to the density of the layer material, are discussed. For comparison, Al₂O₃, Ta₂O₅ and TiO₂ films grown onto both semiconductive Si and insulating quartz substrates were also analysed. All the films studied were synthesized by atomic layer deposition method.     

Mass transfer to horizontal gas-generating electrodes

Mass transfer to a horizontal electrode during electrolytic evolution of oxygen and hydrogen at current densities of 100 to 10 000 A/m² is studied. The mass transfer intensity is evaluated from the diffusion layer thickness, which varies from 60 to 5 μm at such current densities. Calculations show that the decrease in the diffusion layer thickness is due to bubbles with a stationary interphase surface crossing the diffusion layer. During the hydrogen evolution, the diffusion layer thickness is nearly the same for vertical and horizontal electrodes. During the oxygen evolution, the diffusion layer is much thinner for a horizontal electrode. Additional decrease of the diffusion layer thickness during the evolution of oxygen is associated with the lesser solution density in the near-electrode layer and with its transport away by means of natural convection.     

聚合物共混物脆韧转变性能研究 Ⅲ.分散相形态参数之间的关系

为了研究形态（特别是分散状态）对聚合物共混物韧性的影响，建立了准网络形态模型，定义了分散相分布系数（ξ，０＜ξ１），并给出其物理意义，推导了基体层厚度的计算公式，研究了形态参数的变化对基体层厚度的影响．对于常见的无规形态，ξ≈１．对于准网络形态，ξ＜１，并且不是常数．计算结果表明，减小ξ和分散相粒径及其分布、增大其体积分数有利于减小基体层厚度．从理论上证明了准网络形态比无规形态更有利于减小基体层厚度．     

Quantification of Valerenic Acid in Valeriana jatamansi and Valeriana officinalis by HPTLC

A simple, rapid, cost-effective and accurate high performance thin layer chromatographic method has been developed for quantification of valerenic acid in Valeriana jatamansi and Valeriana officinalis which is one of the stable compounds of Valeriana officinalis and designated as a key marker compound. Valerenic acid makes substantial contribution to the sedative and spasmolytic activity of the essential oil and extract of Valeriana officinalis. Separation and quantification was achieved by HPTLC using ternary mobile phase of hexane: ethyl acetate: acetic acid (80:20:0.5 v/v) on precoated silica gel 60F₂₅₄ aluminium plates and densitometric determination was carried out after derivatization with anisaldehyde-sulphuric acid reagent at 700 nm, in absorption-reflectance mode. The calibration curves were linear in the range of (500 ng–2.5 μg). This is the first HPTLC report for the identification and quantification of valerenic acid in Valeriana jatamansi and Valeriana officinalis.     

Effect of film thickness and supercooling on the performance of cholesteryl cinnamate liquid crystal capillary columns

Improved separations of the isomers of olefinic aliphatic insect pheromones were obtained on cholesteryl cinnamate glass capillary columns by operating in the supercooled temperature range of the liquid crystal. Capillary columns were prepared with varying film thickness of the stationary phase; choice of the correct film thickness ensured optimum retention for a wide range of compounds within the most effective temperature range of the liquid crystal. The deactivation procedures described made the liquid crystal columns suitable for separation of the geometric isomers of polar and nonpolar compounds.