激光标线的原理和实验

根据几何光学知识分析了激光标线原理.理论和实验表明:激光标线长度与激光光束形状、光学元件形状及材料折射率有关.并讨论了激光标线向两侧扩展的原因.     

57Fe Mössbauer spectroscopic study of (25−x)MnO–xZnO–15Fe2O3–60B2O3 glasses

The ⁵⁷Fe Mössbauer technique has been used to investigate the effect of zinc oxide substitution in (25???x)MnO–xZnO–15Fe₂O₃–60B₂O₃ glass system (x?=?0, 5, 10, 15 and 20 mol% of ZnO ). Mössbauer absorption spectra for all the samples recorded at room temperature suggest the existence of the two paramagnetic quadrupole doublets. The observed variations in hyperfine parameters have been explained on the basis of cations distribution and exchange interaction at the lattice sites and it is concluded that B–B interaction increases while the metal–metal interaction decreases due to replacement of manganese oxide by zinc oxide. These results suggest that the present glass system exhibits a paramagnetic behaviour that changes towards the weak paramagnetic when manganese oxide was replaced with zinc oxide.     

1.54μmEr3+,Yb3+共掺玻璃激光器的速率方程及数值分析

LD抽运共掺Er,Yb玻璃激光器中的跃迁过程较复杂,针对双掺离子之间的能量传递和Er3+的多种跃迁过程,给出了详细的准三能级系统的速率方程,在合理简化后进行了数值分析,分析了Er3+掺杂浓度和介质长度、抽运光斑、输出镜透过率、谐振腔长、抽运光的椭圆度等因素对激光阈值及斜率效率的影响. 关键词： 1.54μm激光 Er3+玻璃 速率方程 数值分析     

Fe对掺钕磷酸盐激光玻璃激光性能的影响

 在理论分析的基础上，具体讨论了Fe质量分数小于10^-4对1 053 nm处光吸收损耗和Nd³⁺无辐射跃迁几率的影响规律，发现Fe在1 053 nm处的光吸收损耗和Nd³⁺无辐射跃迁能量转移都与Fe质量分数成平方关系增长， Fe对1 053 nm光吸收的影响较大而Fe与Nd³⁺之间的能量转移不足50 Hz。这对生产过程中Fe含量的控制有重要指导意义。     

Upconversion luminescence of Tm^3＋/Yb^3＋ codoped oxyfluoride glasses

Novel oxyfluoride glasses are developed with the composition of 30SiO2-15Al2O3-28PbF2-22CdF2-0.1TmF3 - xYbF3 - （4.9 - x） AlF3（x=0, 0.5, 1.0, 1.5, 2.0） in tool fraction, Furthermore, the upconversion luminescence characteristics under a 970nm excitation are investigated. Intense blue, red and near infrared luminescences peaked at 453nm, 476nm, 647nm and 789nm, which correspond to the transitions of Tm^3＋： ^1D2 →^3F4, ^1G4 →^3H6, ^1G4 →^3F4, and ^3H4 →^3H6, respectively, are observed. Due to the sensitization of Yb^3＋ ions, all the upconversion luminescence intensities are enhanced considerably with Yb^3＋ concentration increasing. The upconversion mechanisms are discussed based on the energy matching rule and quadratic dependence on excitation power. The results indicate that the dominant mechanism is the excited state absorption for those upconversion emissions.     

The origin of the formation of cavities in galvanized coatings

The role of water‐soluble corrosion products on galvanized wires was examined. The samples used were industrial hot‐dip galvanized wires, which were exposed to the open air under all weather conditions for a relatively short time (6 and 12 months), in an urban environment close to the sea. The samples were studied by different methods, i.e. scanning electron microscopy (SEM), transmission electron microscopy (TEM), X‐ray diffraction (XRD) and optical microscopy (OM). Several phases were detected because of the galvanization procedure and the steel substrate. Furthermore, phases which were formed as a result of the reaction of zinc with the atmosphere were also detected. These were oxides like ZnO, carbonates like ZnCO₃ and hydrated Zn and Fe sulfates. Their presence influences the corrosion resistance of the wires, which finally, strongly depends on the solubility of the wires in water. The SO₄^2? compounds especially are very soluble and consequently are easily removed from the coating surface, leading to its degradation by the formation of cavities. In any case, their presence, even after a short period of exposure, implies that the coating is highly affected by the atmosphere of the modern city. Copyright © 2006 John Wiley & Sons, Ltd.     

Eu3+掺杂硼酸盐玻璃的光谱性质研究

测试了不同浓度掺杂下Eu^3＋离子在硼酸盐玻璃的吸收光谱、激发光谱与发射光谱，根据荧光光谱计算了各样品的强度参数力2与／24，分析了Eu^3＋离子掺杂浓度对其发光强度的影响．研究结果表明：在Eu^3＋离子高掺杂浓度时，会发生浓度猝灭效应，但由于Eu^3＋激活离子之间能量传递几率很小，使得Eu^3＋离子猝灭浓度较高。     

彩色透明微晶玻璃的吸收光谱

在Li2O-Al2O3-SiO2系统玻璃中掺入少量晶核剂TiO2,ZrO2,P2O5，再掺入稀土离子和过渡金属离子作为着色剂，在高温下溶制得到彩色透明玻璃，对上述玻璃进行微晶化处理，用差热分析（DTA）确定其晶化温度，测定与讨论了所获彩色透明微晶玻璃在紫外波段至近红外波段的吸收光谱特性，研究结果表明，玻璃微晶化后，由于基质玻璃对光的微弱散射，引起吸收的增强，但不改变稀土离子和过渡金属离子的本征吸收峰位。     

两种以Znq2为基体的新型电致发光材料的合成与性能

以8-羟基喹啉为配体的金属配合物是一种性能优良的有机电致发光材料,其中有关8-羟基喹啉铝(Alq₃)研究已有大量报道,8-羟基喹啉锌(Znq₂)研究还有待发展。介绍了两种以Znq₂为基体的新型有机电致发光材料Znq₂(H₂O)₂和(Znq₂)₄的合成方法。用IR、XRD、TG、DTA和荧光测试方法进行表征与分析表明:Znq₂(H₂O)₂和(Znq₂)₄的玻璃化温度(T_g)分别为104.2℃和204.9℃;在161℃下Znq₂(H₂O)₂脱去水分子成为Znq₂,在361℃高温下四聚体(Znq₂)₄裂解为单体Znq₂;Znq₂(H₂O)₂和(Znq₂)₄具有很好的发光性能,在光致发光谱中λ_max分别是505,550nm。     

Optical current transducers using flint glass fiber as the faraday sensor element

This paper describes development of the optical current transducers using flint glass fiber as the Faraday effect sensing element. Excellent polarization properties of the fiber with low birefringence are described, and the design and test data of a current transducer using the fiber manufactured for use in electric power facilities are reviewed. Experimental results on flexible characteristics of a scheme with round trip light transmission in the fiber is also reported.