Adaptive synchronization and lag synchronization of uncertain dynamical system with time delay based on parameter identification

In this paper, the adaptive synchronization and lag synchronization are considered for uncertain dynamical system with time delay based on parameter identification and a novel control method is then further given using the Lyapunov functional method. With this new and effective method, parameter identification and lag synchronization can be achieved simultaneously. Simulation results are given to justify the theoretical analysis in this paper.     

JLab Hall-A上小角度GDH实验中的粒子鉴别及其效率

在JLab的A大厅上的小角度GDH实验中, 因为散射截面及截面不对称度的测量需要干净的电子样本和足够的事例统计, 径迹在簇射量能器和气体阈契仑柯夫探测器理的信息被用来完成粒子鉴别的任务. 通过优化粒子在两种探测器里的信息筛选条件, 可以得到较高的电子接收效率和π的去除能力. 因为探测器的分辨能力与粒子的动量等运动学参量有关, 所以对于不同的数据的粒子鉴别条件分别进行了优化, 并得到了对应的电子接收效率和π的去除能力.     

EMD与神经网络在气液两相流流型识别中的应用

本文提出了EMD与Elman神经网络相结合的气液两相流流型识别的新方法.将压差波动信号经验模态分解(EMD)后的固有模态函数(IMF)进行分析、提取IMF能量作为Elman神经网络的输入特征向量,对水平管内的气液两相流流型进行识别.实验结果表明:该方法优于BP网络且稳定、识别率高,具有可行性.     

Identification of a fault zone ahead of the tunnel excavation face using the extended Kalman filter

Simulation of mechanized tunneling and on-site excavation require very good knowledge of the geomechanical and material properties. Identification of the material must be fast and continuously performed during tunnel excavation for the best possible strategies for advancing the tunnel boring machine. We present in this work the use of the extended Kalman filter (EKF) for identification of the inclined fault zone ahead of the face. The EKF showed fast and stable convergence of the model parameters under study. In comparison with the particle swarm optimization technique applied to the same back analysis problem, faster convergence of the identified parameters as well as high robustness with respect to the choice of the initial parameter values have been observed.     

Role of Ag addition in L10 ordering of FePt-based nanocomposite magnets

The FePt system has important perspectives as high-temperature corrosion-resistant magnets. In the form of rapidly solidified melt-spun ribbons, FePt-based magnets may exhibit in certain cases a two-phase hard–soft magnetic behaviour. The present paper deals with a microstructural and magnetic study of FePtAgB alloys with increasing Ag content. The aim is to identify and confirm the effect of Ag addition in decreasing the temperature of the FePt disorder–order structural phase transformation. A detailed high-resolution transmission electron microscopy study is employed, and the alternative disposal of hard and soft regions within the two-phase microstructure is observed and interpreted with respect to the X-ray diffraction results. In the as-cast Ag-containing samples, it is shown that there is an optimum of the Ag content for which best magnetic properties are obtained. Ag addition creates a nonlinear behaviour of the coercive field and the ordering parameter, similar to the RKKY interaction-induced interlayer exchange coupling (IEC) observed in magnetic layers separated by non-magnetic spacer layers. Direct formation of the L1₀ phase from the as-cast state in the FePtAgB alloys is reported with magnetic parameters compatible to other exchange spring permanent nanomagnets. These findings open novel perspectives into utilization of such alloys in applications requiring magnets operating in high-temperature industrial environments.     

Anomalous thermochromic transition of poly(di‐n‐octylsilane)

The thermochromic behavior of poly(di‐n‐octylsilane) {[Si(C₈H₁₇)₂]_n; PDOS} was studied by ultraviolet (UV) absorption, differential scanning calorimetry, and X‐ray diffraction measurements. The structure of PDOS in the low‐temperature phase strongly depended on not only the temperature but also the rate of cooling, that is, the thermal history. Temperature‐dependent UV absorption spectra were highly dependent on thermal hysteresis. Cooled rapidly (10 K/min), PDOS showed two absorption peaks at 3.32 and 3.51 eV in low‐temperature‐ordered phases, whereas a single absorption peak at 3.32 eV became predominant with slow cooling (0.3 K/min). The appearance of the two peaks at low temperatures suggested that a mixture of different conformations was introduced by rapid cooling. A fiber diffraction pattern measured at 240 K after rapid cooling also showed evidence of the existence of novel conformation. A temperature‐dependent powder X‐ray diffraction pattern changed significantly between 270 and 280 K. Rapid cooling reduced the intensity of the X‐ray diffraction peak in this temperature region. This intensity change was explained by the conformational mixture in the polymer. © 2001 John Wiley & Sons, Inc. J Polym Sci B: Polym Phys 39: 1085–1092, 2001     

对用稳定图识别真假模态的一点改进

利用单位样值响应矩阵和自由响应的特征值分解形式中的特征值前的系数矩阵的范数作稳定判据，结合稳定图识别真假模态，计算表明，本方法具有较好的分解能力。     

Identification of ground water flow patterns using particle models

Particle models are often used to simulate transport processes in ground water. The ground water flow pattern is one of the driving parameters of the transport model. In this paper a parameter identification algorithm is developed for particle type models to identify the underlying flow pattern from concentration measurements. The estimation problem is solved with a gradient based algorithm. For each generated particle track, the adjoint track is determined to efficiently compute gradient of the criterion.     

Adaptive finite element methods for the identification of distributed parameters in elliptic equation

In this paper, adaptive finite element method is developed for the estimation of distributed parameter in elliptic equation. Both upper and lower error bound are derived and used to improve the accuracy by appropriate mesh refinement. An efficient preconditioned project gradient algorithm is employed to solve the nonlinear least-squares problem arising in the context of parameter identification problem. The efficiency of our error estimators is demonstrated by some numerical experiments.      

基于弹性波散射对二维障碍物边界的识别

给出了二维障碍物弹性波散射场的一种近似积分形式 ,基于 Fourier变换法建立了均匀障碍物特征函数与其远场散射振幅中形状因子的关系式 ,最后就基体为锌 ,对圆形和椭圆形截面铁夹杂进行了计算机模拟 ,结果表明该反演方法对定量无损检测技术具有应用价值。