手性液晶掺杂剂（S）—4‘—辛氧基—4—（2—酰氧基—丙氧基）联苯的合成

手性液晶掺杂剂（Ｓ）┐４┐辛氧基┐４┐（２┐酰氧基┐丙氧基）联苯的合成马汝建李培荣国斌＊（华东理工大学化学系上海２００２３７）关键词铁电液晶材料，手性液晶掺杂剂，合成，手征性１９９７－０２－０３收稿，１９９７－０８－０７修回铁电液晶显示器所用的材料...     

The effect of grass fiber filler on curing characteristics and mechanical properties of natural rubber

Natural rubber is reinforced with a novel type of grass fiber (Cyperus Tegetum Rox b). The effects of fiber loading of different mesh sizes on curing characteristics and mechanical properties of grass fiber filled natural rubber composite are studied. Since 400 mesh grass fiber loaded natural rubber composite shows superior mechanical properties, therefore the effect of silane coupling agent was studied for this particular composite. Here composites were prepared by using water leached grass fiber. Optimum cure time increases with the increase in fiber loading but the change in scorch time is less. The same trend of increase in optimum cure time is observed in the presence of Si69. But the value is higher compared to that of rubber composite without Si69. With increase in the fiber loading, modulus and hardness of the composite increases but tensile strength decreases. The mechanical properties of the composite, namely moduli at 200 and 300% elongation and hardness increase in the presence of Si69 but tensile strength is less compared to that of the composite without Si69. Elongation at break is not much affected due to the presence of Si69. Copyright © 2004 John Wiley & Sons, Ltd.     

Preparation of a novel molecularly imprinted polymer using a water-soluble crosslinking agent

A molecularly imprinted polymer was prepared using a water-soluble crosslinking agent. An ionic complex was utilized as the assembly for the template molecule and the functional monomer, and water as porogenic solvent during preparation of the imprinted polymer. The results of chromatographic evaluations for the prepared polymer suggested that the polymer had much lower hydrophobicity compared with usual octadecyl group bonded silica or the usual molecular imprinted polymer prepared from ethyleneglycol dimethacrylate, and the selective recognition ability for template molecule in the completely aqueous condition.     

Selective Formation of Spinel Iron Oxide in Thin Films by Complexing Agent-Assisted Sol-Gel Processing

The structure of iron oxide was controlled by regulating the hydrolytic polymerization of aquo iron complexes with organic polydentate ligands such as diols. Iron oxides were prepared by calcining the precursor polymers obtained from iron nitrate nonahydrate and diols. When the diols were 1,2-pentanediol, 1,2-hexanediol and 1,2-octanediol, α-Fe₂O₃ with corundum structure appeared exclusively or as the main crystalline phase, in spite of the amount of diol used and the calcination temperature. In the case of 1,2-decanediol and 1,2-dodecanediol, when five moles of the diols were used to one mole of iron nitrate and the calcination temperatures were below 400°C, ψ-Fe₂O₃ with spinel structure appeared as the main phase and, when less than five moles of the diols were used, α-Fe₂O₃ appeared exclusively or as the main phase, irrespective of the calcination temperature. This tendency was also observed in thin films. Thus, a transparent magnetic film composed of γ-Fe₂O₃ could be prepared by applying a benzene solution of the iron polymer, obtained with 5 equivalents of 1,2-decanediol, on quartz and calcining the gel film at 350°C.     

一测多评方法应用于高效液相色谱法测定防晒产品中15种防晒剂的含量

选用CAPCELL PAK C18色谱柱为分离柱,柱温为30℃,进样体积为10.0μL,并用不同比例的(A)甲醇、(B)四氢呋喃和(C)0.008 2mol·L^-1高氯酸溶液的混合液作为流动相,按程序梯度洗脱模式对市售防晒产品中所用的15种防晒剂的标准品进行色谱分离,并在波长311nm处进行紫外检测。实样分析时,称取样品0.25g,用甲醇、四氢呋喃、水和高氯酸(体积比为250∶450∶300∶0.2)的混合液(以下简称混合溶剂)15 mL超声提取30 min,用混合溶剂定容至25.0mL,离心10min,分取上清液1.0mL,加入混合溶剂定容至10.0mL,经0.45μm滤膜过滤,取滤液按仪器工作条件进行高效液相色谱分析。结果表明:所测定的15种防晒剂在一定的质量浓度范围内与其对应的峰面积呈线性关系。选定其中的二苯酮-3为参照物,并根据其余14种化合物的质量浓度和峰面积计算了各化合物的相对校正因子和相对保留时间等参数,确定了用一测多评法(QAMS)测定防晒产品中15种防晒剂的条件。还对色谱柱的型号、色谱仪器的型号以及柱温、进样量等对相对校正因子和保留时间可能产生影响的因素进行了系统试验。证明了在选定的色谱柱型号的前提下,用QAMS方法可实现防晒产品中15种防晒剂含量的同时测定。应用QAMS方法测定了6个批次防晒产品中的防晒剂含量,所得结果与用标准曲线法计算的结果基本一致,表明QAMS方法在降低检测成本和节省检测时间方面效果显著。     

Barium dichromate [BaCr2O7], a mild reagent for oxidation of alcohols to their corresponding carbonyls in non-aqueous polar aprotic media

Barium dichromate is used as a mild oxidizing agent for the selective conversion of primary and secondary alcohols to their corresponding aldehydes and ketones, respectively. Over-oxidation does not occur and primary alcohols undergo oxidation to the aldehyde. Primary and secondary benzylic alcohols are oxidized faster and more efficiently.     

发用防晒剂DDABDT的反相高效液相色谱法测定

建立了反相高效液相色谱法测定发用防晒剂二甲基对胺基苯甲酰胺丙基十二烷基二甲胺甲苯磺酸盐(简称DDABDT)的方法.采用的色谱条件为色谱柱Symmetry C8柱,流动相为V(乙腈):V(10 mmol/L NaAc)=65:35溶液(含体积分数0.02%三氟乙酸,pH5.04),流速1.0 mL/min;检测波长305 nm;进样量20μL.DDABDT质量浓度为0.05～1000 mg/L时,其浓度与峰面积呈良好的线性关系(R2＞0.999),检出限为0.02 mg/L(S/N=3).洗发水A中DDABDT的回收率在98.0%～102%之间,发样提取液中DDABDT的平均回收率在85%～108%之间.洗发水中DDABDT浓度测定日内和日间相对标准分别为1.2%,3.4%.头发吸附DDABDT含量测定日内和日间相对标准偏差(RSD)分别为9.1%,9.8%.同时以高效液相色谱-电喷雾离子化质谱对色谱法测定样品的DDABDT峰进行了验证.该方法已用于洗发水及头发吸附DDABDT的分析.     

气相色谱-质谱法分析土壤中神经性毒剂及糜烂性毒剂

建立了土壤中神经性毒剂及糜烂性毒剂GC—MS-SIM分析法，对土壤中6种毒剂的样品制备和二步萃取方法进行了研究；该法的回收率在80．7％～89．5％，6种毒剂在0．5～10mg/L范围内毒剂质量浓度和峰面积有良好的线性相关，方法检出限为4～20ng／g，该法适用于痕量化学战剂分析。     

Effects of coupling agents on mechanical and morphological behavior of the PP/HDPE blend with two different CaCO3

The main purpose of incorporating fillers, such as calcium carbonate, into blends of polyolefins is to decrease costs and change tensile and impact properties. Structural differences between both components give rise to the formation of large filler agglomerates in the polymer matrix, which influence the mechanical response of the material. Therefore, the coupling agents of the Lica 12 type at various concentrations was used to facilitate the link between filler and matrix (the latter consisting of PP/HDPE 80/20 wt). Filler was added to the PP/HDPE blend at a 30 wt.% concentration. Two types of calcium carbonate (CaCO₃) were used. These have different average sizes (3.0 and 1.8 μm) which were determined by means of laser diffraction techniques. In addition other coupling agents of the titanate type, such as Lica 09, Lica 01, zirconates ZN 12, and a 1:1 mixture of Lica 12 and Lica 01, were used. This study clearly demonstrated that the addition of the coupling agent to CaCO₃ modifies the mechanical properties of the PP/HDPE/CaCO₃ composites. Values of the mechanical properties indicate that due to its characteristics, each coupling agent gives rise to increases in a particular mechanical property. In the case of Lica 01 an increase was verified in Young’s modulus at 0.7 wt.% and in elongation at break at both concentrations (0.3 and 0.7 wt.%), whereas ZN 12 brought about an increase in elongation at break. The 1:1 mixture of Lica 12 and Lica 01 caused impact resistance of the blend of PP/HDPE with CaCO₃ to increase considerably.     

Enzyme inhibitors as chemical tools to study enzyme catalysis: rational design, synthesis, and applications

Carefully designed molecules that are intimately related to the reaction mechanism of enzymes are often highly selective and potent inhibitors that serve as extremely useful chemical probes for understanding the reaction mechanism and structure of enzymes. This article describes the design, synthesis, and applications of specific inhibitors of two mechanistically distinct groups of enzymes, ATP-dependent amide ligases and Ser- and Thr-hydrolases. Our strategy is based on the premise that stable analogues of the transition state (transition-state analogues) are highly potent inhibitors that serve as good mechanistic probes, and that a key structure of a good inhibitor of one enzyme is also utilized for the inhibitors of other enzymes that share the same chemistry in their catalyzed reactions, irrespective of the degree of structural similarity and evolutionary link between the enzymes. According to these principles, we designed and synthesized a series of phosphinate- and sulfoximine-based transition-state analogue inhibitors of glutathione synthetase, gamma-glutamylcysteine synthetase and asparagine synthetase. For the second group of enzymes, we synthesized a gamma-monofluorophosphono glutamate analogue for mechanism-based affinity labeling of gamma-glutamyltranspeptidase and fluorescent phosphonic acid esters for the active-site titration of lipase. These inhibitors were used successfully as ligands for detailed kinetic analyses, X-ray crystallography, and mass analysis of the enzymes to identify the key amino acid residues responsible for catalysis and substrate recognition in the transition state.