CBP/Alq3有机量子阱结构的光致发光

采用多源有机分子气相沉积系统(OMBD)制备了CBP/Alq₃有机多量子阱结构,利用电化学循环伏安特性和吸收光谱、小角X射线衍射、荧光光谱研究了量子阱的能带、结构和光致发光的特性。电化学循环伏安特性和吸收光谱的测量结果表明,CBP的最低占据分子轨道(LUMO)与最高占据分子轨道(HOMO)的位置分别为-2.74,-6.00eV,Alq₃的LUMO与HOMO的位置分别为-3.10,-5.80eV,所以CBP/Alq₃有机量子阱为Ⅰ型量子阱结构。小角X衍射测量显示,在小角的位置(2θ的范围在0°～3°)观察到了对应于量子阱结构的多级布拉格衍射峰,表明多层量子阱结构是有序的层状结构,界面比较完整,界面质量比较好。荧光光谱的研究结果表明,Ⅰ型量子阱结构可以有效地把能量从垒层传递给阱层,从而增强了阱层材料的发光。阱层的厚度对发光峰的位置影响很大,随阱层厚度减小,阱层材料的发光峰出现蓝移现象。并对引起发光峰蓝移的原因进行了讨论。     

两种蓝色有机电致发光材料

重点研究以两种蓝色OEL材料蒽类衍生物JBEM和联苯乙烯衍生物DPVBi分别作基质，以perylene作掺杂剂的器件的电致发光性能，特别研究了它稳定性，在这度和效率方面，两种器件并没有很大差别，然而在稳定性方面却有很大差别，蒽类衍生物JBEM的器件在100cd/m^2初始亮度下，半亮度寿命可达1035h，而DPVBi的器件在同样条件下，半亮度寿命为255h。通过分析两种器件的能级图，认为稳定性的差别可能源于两种蓝光材料本身的热稳定性不同，JBEM优于DPVBi，是一种很有前途的蓝色发光材料。     

LaB6在低压强氮气和氦气中的放电特性

 研究了LaB₆在1~10 Pa氮气和氦气中的直流和脉冲放电特性以及放电过程对电极的影响。结果表明，电极直径为5 mm的LaB6氦气放电管在脉冲工作状态下可以长期稳定放电。在脉冲电压为2.2 kV、脉冲宽度10 ms、频率13.3 Hz下，脉冲峰值放电电流超过120 A。氦气放电管在放电过程中，阴极表面有离子的清洗和活化作用，可以使电极的表面逸出功降低，提高放电管的发射能力和稳定性。LaB₆作为气体放电电极具有寿命长、延迟时间短、放电电流大等优点，可用于重复强流脉冲气体放电的高压高速开关器件。     

The effect of ITO films thickness on the properties of flexible organic light emitting diode

Indium tin oxide (ITO) thin films were deposited on cyclic olefin copolymer substrate at room temperature by an inverse target sputtering system. The crystal structure and the surface morphology of the deposited ITO films were examined by X-ray diffraction and atomic force microscopy, separately. The electrical properties of the conductive films were explored by four-point probing. Visible spectrometer was used to measure the optical properties of ITO-coated films. The performance of the flexible organic light emitting diode device with different thickness anode was investigated in this study.     

偶氮苯衍生物三阶非线性的四波混频研究

用皮秒Ｎｄ：ＹＡＧ激光器的倍频光（５３２ｎｍ）对具有离域π－共轭电子云结构的偶氮苯类样品材料作简并四波混频补给，测得三阶非线性电极化率ｘ＾（３）和它们的时间响应分别为１０＾－９ｅｓｕ和２０ｐｓ，并对影响ｘ＾（３）的瞬时光栅作用和ｘ＾（３）的响应时间人了讨论。     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

激光二极管自混合干涉和微振动的实验观测

介绍了利用LabView软件虚拟示波器和信号源,对激光二极管自混合干涉和微振动进行的实验观测.该实验可以作为本科低年级学生的综合设计实验.     

Physical Analysis of a Possibility to Reach the 1.30-μm Emission from the GaAs-Based VCSELs with the InGaAs/GaAs Quantum-Well Active Regions and the Intentionally Detuned Optical Cavities

Physical aspects of an operation of the GaAs-based InGaAs/GaAs quantum-well (QW) VCSELs with the intentionally detuned optical cavities have been considered in the present paper using the comprehensive three-dimensional self-consistent optical–electrical–thermal-gain simulation. In GaAs-based structures, very good DBR resonator mirrors and a very efficient methods to confine radially both the current spreading and the electromagnetic field with the aid of oxide apertures may be applied. It has been found using the above simulation that even currently available immature technology enables manufacturing the above devices emitting radiation of wavelengths over 1.20 μm. In particular, while the room-temperature 1.30-μm lasing emission is still beyond possibilities of the InGaAs/GaAs QW VCSELs, these structures may offer analogous 1.25-μm emission, especially for the high-power and/or high-temperature operation.