Simultaneous determination of hydride (Se) and non-hydride-forming (Ca,Mg, K,P, S and Zn) elements in various beverages (beer,coffee, and milk), with minimum sample preparation,by ICP–AES and use of a dual-mode sample-introduction system

A method has been developed enabling direct analysis (i.e. after dilution only) of beer, instant coffee, milk, and milk powder by ICP–AES. Analysis of the beverages after dilution with a low concentration of HNO₃ was used for accurate determination of essential minor and trace elements (Ca, Mg, K, P, S, and Zn). Selenium, introduced as the hydride, was determined simultaneously with the other non-hydride-forming elements using the commercial multi-mode sample-introduction system (MSIS). To obtain accurate results, however, some simple pre-treatment was needed. Analysis was also performed after microwave-assisted decomposition of the samples. Three different modes of sample-preparation, i.e. dilution only, partial decomposition (aqua regia treatment), and complete decomposition were compared. The results obtained by use of the three different sample-preparation methods were in very good agreement. Results from analysis of certified reference material (SRM 1459 non-fat milk powder) also verified the accuracy of the methods. The limit of detection obtained for Se using dual-mode sample introduction was 0.5 ng mL^–1, which corresponds to approximately 2 ng g^–1 in beer and approximately 4 ng g^–1 in coffee and milk when using the recommended procedure.     

用原子捕获技术提高火焰原子吸收光谱法的灵敏度

采用简易的石英原子捕获器，使Ｃｕ，Ａｇ，Ａｕ，Ｚｎ，Ｃｄ，Ｐｂ，Ｓｂ，Ｂｉ等易挥发元素在空气－乙炔火焰原子吸收光谱法中的灵敏度提高了３～５倍，并有较好的精密度，相对标准偏差在１％左右，方法中用此技术测定了标准物质中Ｐｂ、Ｃｄ的含量，获得了满意的结果，它较之石墨炉原子吸收光地具有快速，简便的特点，具有较大的实用价值。     

Procedure for dissolving wolframite in order to determine trace elements by atomic absorption spectrometry

An analytical procedure for dissolving wolframite in order to determine trace elements by atomic absorption is reported. After decomposition of the mineral by alkaline fusion, the cooled flux is dissolved by heating with aqua regia. The finely crystalline precipitate of tungstite, which forms on standing, is filtered and dissolved by heating with aqua regia. Tungstite forms again in the latter solution and the filtration and solubilization are repeated until the solution contains negligible amounts of trace elements. Following this procedure, trace elements in 35 samples of natural wolframite have been dissolved and the solutions obtained have been analyzed by atomic absorption spectrometry for Fe, Mn, Cu, Zn, Pb, Co, Ni and Cd.     

Analysis of non-organic elements in plant foliage using polarised X-ray fluorescence spectrometry

An X-ray fluorescence (XRF) method for the rapid and non-destructive analysis of 30 non-organic elements in plant leaves over five orders of magnitude concentration from several percentage of dry weight to sub-milligram per kilogram, is described. There is a growing need for a simple method of monitoring non-organic trace elements in plant material, especially those which accumulate in soils with application of fertilisers, both inorganic and biosolids. Earlier attempts to use XRF for the analysis of plant material suffered from sensitivity loss due to the high background of organic matrices caused by scattering of the X-ray source. We overcome this by using polarised X-ray sources in a Cartesian geometrical arrangement with sample and energy dispersive detector (EDPXRF), a configuration which can achieve an order of magnitude reduction in background compared with unpolarised sources. Further sensitivity gains are made using a high power tube as a source of primary X-rays and for some analytes employing secondary targets for near-monochromatic excitation. Sample preparation is simple involving only pulverising and briquetting of dried samples. Accuracy is evaluated by comparing data obtained for the suite of NIST plant leaf samples (NIST 1515 apple leaves, NIST 1547 peach leaves, NIST 1570a spinach leaves, NIST 1573a tomato leaves and NIST 1575a pine needles) and tobacco leaf standards CTA-OTL-1 and CTA-VTL-2. The data compare well over the whole concentration range and the method provides a rapid analytical tool for monitoring potentially toxic trace elements in all types of foliage with adequate sensitivity for many purposes.     

腐殖质与铀和超铀元素相互作用的研究进展

腐殖质是一类广泛存在于自然界中的高分子有机化合物,能与放射性核素相互作用,从而影响其在自然环境中的化学形态、迁移沉降、氧化还原行为等。本文介绍了目前国内外关于腐殖质与铀和超铀元素相互作用的研究现状和进展,并对存在的问题及今后的发展方向进行了初步讨论。     

高血压类风湿症疗效与锌,钙关系初探

以临床典型病案为例，探讨了中医中药传统理论和现代微量元素研究的关系，重点讨论了向量元素锌、宏量元素钙与高血压、风湿症的病因病机和治疗关系。     

拓扑指数法研究稀土显色剂结构与铈显色反应对比度的关系

计算了４３种不对称变色酸双偶氮膦酸型显色剂的Ａｍ拓扑指数，并将其与结构选择性因子相结合，用于偶氮类显色剂结构与铈显色反应对比度的相关性研究，讨论了显色剂结构对拓扑指数有译比度的影响。     

1,2‐Dithioquadratato‐ und 1,2‐Dithiooxalatoindate(III)

Indium(III) chloride forms in water with potassium 1,2‐dithiooxalate (dto) and potassium 1,2‐dithiosquarate (dtsq) stable coordination compounds. Due to the higher bridging ability of the 1,2‐dithiooxalate ligand in all cases only thiooxalate bridged binuclear complexes were found. From 1,2‐dithioquadratate with an identical donor atom set mononuclear trischelates could be isolated. Five crystalline complexes, (BzlMe₃N)₄[(dto)₂In(dto)In(dto)₂] ( 1 ), (BzlPh₃P)₄[(dto)₂In(dto)In(dto)₂] ( 2 ), (BzlMe₃N)₃[In(dtsq)₃] ( 3 ), (Bu₄N)₃[In(dtsq)₃] ( 4 ) and (Ph₄P)[In(dtsq)₂(DMF)₂] ( 5 ), have been isolated and characterized by X‐ray analyses. Due to the type of the complex and the cations involved these compounds crystallize in different space groups with the following parameters: 1 , monoclinic in P2₁/c with a = 14.4035(5) Å, b = 10.8141(5) Å, c = 23.3698(9) Å, β = 124.664(2)°, and Z = 2; 2 , triclinic in P with a = 11.3872(7) Å, b = 13.6669(9) Å, c = 17.4296(10) Å, α = 88.883(5)°, β = 96.763(1)°, γ = 74.587(5)°, and Z = 1; 3 , hexagonal in R3 with a = 20.6501(16) Å, b = 20.6501(16) Å, c = 19.0706(13) Å and Z = 6; 4 , monoclinic in P2₁/c with a = 22.7650(15) Å, b = 20.4656(10) Å, c = 14.4770(9) Å, β = 101.095(5)°, and Z = 4; 5 , triclinic in P with a = 9.2227(6) Å, b = 15.3876(9) Å, c = 15.5298(9) Å, α = 110.526(1)°, β = 100.138(1)°, γ = 101.003(1)°, and Z = 2.     

ICP-AES determination of trace elements after preconcentrated with p-dimethylaminobenzaldehyde-modified nanometer SiO2 from sample solution

A new method that utilizes p-dimethylaminobenzaldehyde-modified nanometer SiO₂ (SiO₂-p-DMABD) as a solid phase extractant has been developed for simultaneous preconcentration of trace Cr(III), Cu(II), Fe(III) and Pb(II) prior to the measurement by inductively coupled plasma atomic emission spectrometry (ICP-AES). The preconcentration conditions of analytes were investigated, including the pH value, the shaking time, the mass of sorbent, the sample flow rate and volume, the elution condition and the interfering ions. The adsorption capacity of nanometer SiO₂-p-DMABD was found to be (mg g^− 1) Cr(III): 6.2, Cu(II): 18.6, Fe(III): 4.7 and Pb(II): 6.0 at pH 4. The adsorbed metals were quantitatively eluted with 4 mL of 1.0 mol L^− 1 HCl. According to the definition of IUPAC, the detection limits (3σ) of this method for Cr(III), Cu(II), Fe(III) and Pb(II) were 0.79, 1.27, 0.40 and 1.79 ng mL^− 1, respectively. The proposed method achieved satisfied results when it was applied to the determination of trace Cr(III), Cu(II), Fe(III) and Pb(II) in biological and water samples.     

Synthesis of PbTiO3 ceramics using mechanical alloying and solid state sintering

The pressure-less sintering behavior of PbTiO₃ powders synthesized by mechanical alloying TiO₂ and PbO was investigated using dilatometry and Rietveld refinements of X-ray diffraction patterns. As-synthesized, the powders are nanocrystalline with a mean particle size of 20 nm. Pressure-less sintering in the range 500-1050°C gives single phase ceramics with densities of 85-90% and crystallite sizes in the range 80-400 nm. Cracking due to the paraelectric-ferroelectric phase transition was not observed in samples sintered below 700°C due to the small crystallite size whereas macroscopic cracks formed in samples sintered above 700°C. Rietveld analysis indicates the formation of Pb vacancies in samples sintered and held for 24 h at intermediate temperatures (600-1000°C) which gives some insight into the mechanism of Pb loss and second phase formation in this system.