毛细管放电X光激光装置中的预脉冲电源

 针对目前毛细管放电X 光激光装置产生的预脉冲电流幅值过大、持续时间较短的问题，提出了增加预脉冲开关抑制原有预脉冲，再外加由脉冲成形网络组成的预脉冲发生器，产生所需预脉冲的改造方案。可在主脉冲来临之前产生幅度10~50A，持续时间约17μs的方波预脉冲电流，来满足毛细管放电泵浦类氖氩X光激光实验的需要。     

白炽灯延寿节电开关

运用交流电路中线圈的自感特性，制成一种白炽灯的延寿节电开关，它可消除白炽灯起动瞬间的浪涌电流，延长白炽灯寿命，节约用电。     

Cr^4＋：YAG可饱和吸收特性测量

测量了Cr4+:YAG材料的可饱和吸收特性,用多种数据分析方法处理了实验结果,Cr4+:YAG的基态吸收截面σgs=11×10-19cm2,激发态吸收截面σes=1.2×10-19cm2。     

稳态锁模产生4ps激光脉冲

首次利用ＧａＡｓ光电导开关，控制Ｎｄ：ＹＬＦ激光器腔内Ｑ值，实现稳态锁模，获得脉宽和能量稳定性极高的４ｐｓ激光脉冲。     

反向驱动的异质结有机薄膜电致发光

成功制备了结构为ITO／PDDOPV／PPQ／Al的异质结聚合物发光二极管。该器件在正反向偏压下均可发光。在正向偏压下的光发射主要来自PDDOPV，但在反向偏压下的光发射则包括来自PPQ的蓝光发射和PDDOPV的黄光发射。蓝光强度与黄光强度的比值随着反向偏压的增加而增加，当反向直流电压分别为22V、24V、26V、28V时，其电致发光光谱中PPQ与PDDOPV的峰高比IPPQ／IPDDOPV分别为1．092、1．329、1．605、2．046。换句话说，该器件的发光颜色是压控可调的，这对实现彩色显示是极为有利的。分析了在反向偏压下的发光机理以及IPPQ／IPDDOPV受电压控制的原因。     

EchSGB远距离照明条件下的焦开关

推导了复变量双曲余弦平方-高斯光束(EchSGB)被无光阑透镜聚焦后的轴上光强分布公式,在此基础上通过数值计算和分析发现,EchSGB只有在远距离照明条件下才存在焦开关现象.焦点跃变位置随光束参数和对应高斯光束的菲涅尔数不同而变化,得到了EchSGB在平顶情形下产生焦开关的相对入射距离为11.13,表明在远距离照明和无光阑透镜精密调焦时,对于EchSGB要考虑焦开关现象的影响.     

Growth Behavior of CdS Nanoparticles Embedded in Polymer and Sol-Gel Silica Matrices: Relationship with Surface-State Related Luminescence

Chemical techniques were employed to synthesize CdS nanoparticles embedded in polymer (PEG 300) and sol-gel silica matrices. Systematic growth of particles (radius 3–9 nm) was obtained by adjusting post-deposition annealing temperature and time to examine the dependence of surface-state–related luminescence on particle size. Photoluminescence (PL) peak energy showed a linear dependence with a gentle slope in the weak confinement region and a steep slope in the strong confinement region, the divergence being observed near the excitonic Bohr radius for CdS. The empirical relation proposed for the weak confinement region could be used for estimating chemically prepared CdS nanoparticle size with a high degree of reliability from PL peak energy.     

Upconversion luminescence of Tm^3＋/Yb^3＋ codoped oxyfluoride glasses

Novel oxyfluoride glasses are developed with the composition of 30SiO2-15Al2O3-28PbF2-22CdF2-0.1TmF3 - xYbF3 - （4.9 - x） AlF3（x=0, 0.5, 1.0, 1.5, 2.0） in tool fraction, Furthermore, the upconversion luminescence characteristics under a 970nm excitation are investigated. Intense blue, red and near infrared luminescences peaked at 453nm, 476nm, 647nm and 789nm, which correspond to the transitions of Tm^3＋： ^1D2 →^3F4, ^1G4 →^3H6, ^1G4 →^3F4, and ^3H4 →^3H6, respectively, are observed. Due to the sensitization of Yb^3＋ ions, all the upconversion luminescence intensities are enhanced considerably with Yb^3＋ concentration increasing. The upconversion mechanisms are discussed based on the energy matching rule and quadratic dependence on excitation power. The results indicate that the dominant mechanism is the excited state absorption for those upconversion emissions.     

LaB6在低压强氮气和氦气中的放电特性

 研究了LaB₆在1~10 Pa氮气和氦气中的直流和脉冲放电特性以及放电过程对电极的影响。结果表明，电极直径为5 mm的LaB6氦气放电管在脉冲工作状态下可以长期稳定放电。在脉冲电压为2.2 kV、脉冲宽度10 ms、频率13.3 Hz下，脉冲峰值放电电流超过120 A。氦气放电管在放电过程中，阴极表面有离子的清洗和活化作用，可以使电极的表面逸出功降低，提高放电管的发射能力和稳定性。LaB₆作为气体放电电极具有寿命长、延迟时间短、放电电流大等优点，可用于重复强流脉冲气体放电的高压高速开关器件。     

Bipyridinophane‐containing conjugated polymers modulated with an intramolecular aromatic C?H/π interaction

Bipyridinophane–fluorene conjugated copolymers have been synthesized via Suzuki and Heck coupling reactions from 5,8‐dibromo‐2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane and suitable fluorene precursors. Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P7 ) exhibits large absorption and emission redshifts of 20 and 34 nm, respectively, with respect to its planar reference polymer Poly[2,7‐(9,9‐dihexylfluorene)‐co‐alt‐1,4‐(2,5‐dimethylbenzene)] ( P11 ), which bears the same polymer backbone as P7 . These spectral shifts originate from intramolecular aromatic C? H/π interactions, which are evidenced by ultraviolet–visible and ¹H NMR spectra as well as X‐ray single‐crystal structural analysis. However, the effect of the intramolecular aromatic C? H/π interactions on the spectral shift in poly[9,9‐dihexylfluorene‐2,7‐yleneethynylene‐co‐alt‐5,8‐(2,11‐dithia[3]paracyclo[3](4,4′)‐2,2′‐bipyridinophane)] ( P10 ) is much weaker. Most interestingly, the quenching behaviors of these two conjugated polymers are largely dependent on the polymer backbone. For example, the fluorescence of P7 is efficiently quenched by Cu²⁺, Co²⁺, Ni²⁺, Zn²⁺, Mn²⁺, and Ag⁺ ions. In contrast, only Cu²⁺, Co²⁺, and Ni²⁺ ions can partially quench the fluorescence of P10 , but much less efficiently than the fluorescence of P7 . The static Stern–Volmer quenching constants of Cu²⁺, Co²⁺, and Ni²⁺ ions toward P7 are of the order of 10⁶ M^?1, being 1300, 2500, and 37,300 times larger than those of P10 , respectively. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 4154–4164, 2006