Electrochemical Study of Catechol and Hydroquinone Using Activated Glassy Carbon Electrodes

Abstract

Glassy carbon electrodes polished with some ceramics particles(TiB₂ SiC and TiC) show activation for the oxidation and reduction of catechol and hydroquinone. The activation was found to depend on the hardness of glassy carbon and ceramic particles.     

Electrochemical Behavior of Hydroquinone at Poly (Acridine Orange)–Modified Electrode and Its Separate Detection in the Presence of o‐Hydroquinone and m‐Hydroquinone

Abstract

Poly (acridine orange) (PAO) film–modified electrode was prepared by the electrooxidation of Acridine orange on a glassy carbon electrode (GCE) for the detection of hydroquinone in the presence of o‐hydroquinone and m‐hydroquinone. The electrochemical behavior of hydroquinone on the modified electrode was investigated with respect to different solution acidity, scan rate, and accumulation time. A pair of sharp and well‐defined peaks was obtained at 0.45 and 0.42 V [vs. a saturated calomel electrode (SCE)] at the PAO film–modified electrode. The potential difference between this pair of cathodic and anodic peaks was decreased to only 30 mV as compared to the 241 mV that was obtained on the bare glassy carbon electrode (GCE). As to o‐hydroquinone and m‐hydroquinone, their corresponding oxidation peaks appeared at 0.55 V and 0.89 V (vs. SCE), respectively. The oxidation potential differences between these three isomers enabled the separate detection of hydroquinone. Under the optimum experimental situation, the oxidation peak current of hydroquinone was proportional to the concentration at the range of 6.8×10^?7–9.6×10^?5 M. The detection limit was been estimated as 3×10^?7 M with 130 s accumulation. This method was applied to the hydroquinone detection in tap water samples.     

Study of the characteristic fragmentation behavior of hydroquinone glycosides by electrospray ionization tandem mass spectrometry with optimization of collision energy

The fragmentation behavior of hydroquinone glycosides involving one or two sugar groups from Fraxinus sieboldiana and their analogue arbutin was investigated systematically by electrospray ionization tandem mass spectrometry in negative ion mode. The characteristic fragmentation reaction of these compounds was through the homolytic and heterolytic cleavage of the O‐glycosidic bond to produce radical aglycone ion ([Y₀ ? H]^??) and aglycone ion (Y₀^?), respectively. Unambiguous differentiation between the mono‐O‐glycoside isomers which differ in glycosylation position was achieved by comparing the relative abundance of [Y₀ ? H]^?? and Y₀^? ions with the optimized collision energy. In the fragmentation of 1, 4‐di‐O‐glycosides, only the Y₀^? ion was produced when the first glucosyl residue was expelled. However, both the [Y₀ ? H]^?? and Y₀^? ions were present when the second glucosyl residue was eliminated. In addition, an interesting [Y₀‐2H]^? ion was present in the product ion spectra of hydroquinone glycosides with methoxy group(s) substituted at C‐3 or/and C‐5 positions of the benzene ring. The results of this study can facilitate the rapid determination of hydroquinone glycosides in crude plant extracts and also reveal that the systematic investigation and optimization of collision energy play an important role in the differentiation of isomers which have subtle differences in structures. Copyright © 2009 John Wiley & Sons, Ltd.     

EQCM监测高氯酸溶液中金电极上苯二酚电荷转移配合物的沉积

用电化学石英晶体微天平(EQCM)研究了高氯酸溶液中电位环扫过程中邻(间、对)苯二酚/醌电荷转移配合物(CTC)的生成和电沉积。结果发现,邻(对)苯二酚可产生CTC并在电极上沉积,而间苯二酚仅发生电聚合反应。以邻苯二酚为例考察了高氯酸和邻苯二酚浓度及电位扫描速度的影响。红外光谱证实了邻苯二酚/醌CTC的生成。结果发现,添加肝素钠对邻苯二酚/醌CTC的沉积有显著影响,肝素钠质量浓度分别低/高于0.05 g/L时,能增强/减弱沉积现象。EQCM技术可作为一种快速、简便、灵敏的工具可望用于CTC制备过程中的实时监测和筛选。     

超分子化学──富电子对苯二酚聚醚链系列产品的高效液相色谱法分析

介绍了超分子化合物（Ｃ）合成过程中间产物富电子对苯二酚聚醚链（ＨＱ）系列产品的高效液相色谱分离方法。采用ＮｕｃｌｅｏｓｉｌＣ（１８）柱,以紫外检测器（２２６ｎｍ）检测和甲醇－水（７５：２５,Ｖ／Ｖ）作流动相,可得到满意的分离效果。     

Synthesis and properties of novel aromatic poly(o-hydroxy amide)s and polybenzoxazoles based on the bis(ether benzoyl chloride)s from hydroquinone and its methyl-, tert-butyl-, and phenyl-substituted derivatives

Four series of poly(o-hydroxy amide)s were prepared by the low-temperature solution polycondensation of the bis(ether benzoyl chloride)s extended from hydroquinone and its methyl-, tert-butyl-, or phenyl-substituted derivatives with three bis(o-aminophenol)s. Most of the poly(o-hydroxy amide)s displayed an amorphous nature, were readily soluble in various polar solvents such as N,N-dimethylacetamide (DMAc), and could be solution-cast into flexible and tough films. These poly(o-hydroxy amide)s had glass transition temperatures (T_g) in the range of 152–185°C and could be thermally cyclodehydrated into the corresponding polybenzoxazoles approximately in the region of 200–400°C, as evidenced by the DSC thermograms. The thermally converted benzoxazole polymers exhibited T_gs in the range of 215–247°C and did not show significant weight loss before 500°C either in nitrogen or in air. © 1999 John Wiley & Sons, Inc. J Polym Sci A: Polym Chem 37: 2129–2136, 1999     

Thermotropic liquid-crystalline copolyesters containing substituted phenylene terephthalate and ethylene terephthalate units

Three series of aromatic, thermotropic copolyesters, based on terephthalic acid (TA), ethylene glycol (EG), and another diol were prepared. The third monomer was selected from three different hydroquinones including, ethoxyhydroquinone (EHQ), phenylhydroquinone (PHQ), and hydroquinone itself (HQ). The amounts of the different hydroquinone terephthalate units were varied while the amounts of ethylene terephthalate units remained constant. The copolymers and terpolymers were characterized for solubility, for morphology by polarized light microscopy (PLM), for molecular weight by solution viscometry, and by NMR, DSC, and TGA. At elevated temperatures all samples, when observed by PLM, displayed the characteristic texture of a nematic phase. The melting transition temperatures, T_m, were found to vary from 255 to 325°C, while the 5 wt % loss temperatures, T_d, were found to vary from 330 to 440°C. The inherent viscosities varied from 0.6 to 1.9 dL/g. Increases in the HQ monomer content caused a decreased solubility and an increase in melting point. Copolymer compositions determined by NMR showed that only about one-half of the EG added was incorporated into the copolymers. © 1997 John Wiley & Sons, Inc.