盐酸氨溴索在碳糊电极上阳极伏安法的研究

在０．５ ｍｏｌ／Ｌ Ｈ２ＳＯ４底液中，用碳糊电极阳极伏安法测定盐酸氨溴索，被测的阳极峰电位为１．１０Ｖ（ｖｓ．ＳＣＥ），另外，在０．４６Ｖ处还产生一对可逆的氧化还原峰。１．１０ Ｖ处的峰电流与盐酸氨溴索的浓度在３．９８×１０~（－７）～６．３４ × １０~（－５）ｍｏｌ／Ｌ范围内呈良好的线性关系，该方法的检出下限为３．０ × １０~（－８）ｍｏｌ／Ｌ。用标准加入法测得回收率范围为９２．８％～１０２％，ＲＳＤ为２．９％（ｎ＝１０）。对电极响应机理进行了初步探讨，氨溴索在１．１０ Ｖ处的氧化为不可逆过程，其氧化产物在０．４６０Ｖ处产生一对２电子２质子受扩散控制的可逆波，用该波也可进行定量测定并且干扰较少，但灵敏度略低。     

羧基化碳纳米管嵌入石墨修饰电极对多巴胺和抗坏血酸的电催化

采用涂层和嵌入修饰法 ,将羧基化多层碳纳米管制成两种修饰电极。以多巴胺 (DA)和抗坏血酸(AA)为模型化合物 ,研究了两种修饰电极对DA和AA共存时的电催化作用。结果表明 :嵌入的方式比涂层的方式显示了更多的优点。嵌入修饰电极不仅使峰电流增加 ,并且使两者共存时的氧化峰位分离达 16 0mV ,同时 ,该电极对DA的响应灵敏于AA ,这有利于在大量的AA存在下实现对DA的测定。在 1× 10 - 3 mol/L的AA的存在下 ,还原电流的一阶导数与DA浓度在 5× 10 - 7～ 1× 10 - 4 mol/L范围内呈良好的线性关系 ;检测下限达 1× 10 - 7mol L。     

超声场下苯酚吸附相平衡和均相催化剂氧化降解实验研究

测定了常规条件和超声场条件下苯酚在活性炭上的吸附等温线,并研究了超声再生活性炭和均相催化剂氧化降解苯酚实验.研究结果表明,超声场作用下苯酚在活性炭上的吸附等温线降低,平衡吸附量减少,被脱附下来的苯酚及时被Cu2 和Fe3 型催化剂氧化降解,吸附剂得到更彻底再生,避免了二次污染,而且再生后的活性炭均具有较高的二次吸附能力,对于处理低浓度含酚废水具有实际意义.     

Deposition and characterization of Langmuir‐Blodgett films of cadmium arachidate/SWCNTs composites

The incorporation of single‐wall carbon nanotubes (SWCNTs) in cadmium arachidate film by means of the Langmuir‐Blodgett (LB) technique was investigated as a function of arachidic acid/SWCNT mass ratio at the air/water interface and in Langmuir‐Blodgett films. The behaviour at the air/water interface shows that SWCNTs act as an independent phase with respect to the cadmium arachidate. Deposition conditions are optimized when the weight ratio between the arachidic acid (AA) and SWCNTs is in the range 0.018:1 to 1:1. The general order of the LB multilayered structure was destroyed by the progressive density increase in SWCNT quantity as evidenced by X‐ray reflectivity (XRR) analysis. Scanning electron microscopy images indicated that when a multilayered structure was formed its layers consisted of SWCNT bundles stacked one over the other. Copyright © 2006 John Wiley & Sons, Ltd.     

金在碳糊电极上的静电吸附及溶出伏安测定

阳极溶出伏安法测定金具有灵敏度高,操作简便等优点,但共存金属往往干扰测定,影响该方法的应用。为减少干扰,已有阴极溶出伏安法的报道。 作者曾采用修饰了三烷基叔胺的碳糊电极,通过开路萃取富集和介质交换,测定矿样中的金,并且发现,碳糊电极本身能在正电位下直接富集微量金,在阴极溶出伏安法中显示了     

担载Ru_3（CO）_（12）－Fe_2（CO）_9混合簇的脱羰基作用和表面加氢反应

担载于ＺｒＯ２上的Ｒｕ３（ＣＯ）１２－Ｆｅ（ＣＯ）９混合簇的红外光谱表明，Ｒｕ３（ＣＯ）１２以Ｒｕ（ＣＯ）２Ｏ２表面络合物存在．混合族在真空中随温度升高而发生脱羰基作用，５００℃左右羰基完全脱掉；以Ａｌ２Ｏ３为载体者其羰基不易脱除，升高温度出现多种羰基带．混合簇中的Ｆｅ２－（ＣＯ）９极易脱羰基．担载混合簇在Ａｒ气中进行ＴＰＤＥ时，低温时以脱羰基为主，高于１５０℃时发生表面歧化反应而生成ＣＯ２；在Ｈ２气中，低温时仍以脱羰基为主，高于１５０℃时发生表面加氢反应而生成ＣＨ４．混合簇的脱羰基和表面反应能力与Ｒｕ／Ｆｅ比及载体有关．担载混合簇在ＣＯ加氢反应中以Ｒｕ（ＣＯ）２Ｏ２和分散Ｆｅ存在，还出现－ＣＨｘ多种表面物种．     

Coupling between polymer adsorption and colloidal particle aggregation

Studies of the adsorption of high molecular weight polymers on colloidal latex and silica particles and their subsequent flocculation were carried out. Neutral polyethylene oxide samples with both a narrow and a broad molecular weight distribution were used together with low charged cationic copolymers. The influence of the particle concentration and polymer dose on the flocculation were systematically investigated under quiescent conditions.Equilibrium bridging only occurred with polyelectrolyte, even in very dilute suspensions, at high particle coverage. In contrast to this, non-equilibrium bridging occurred with both neutral polymer and polyelectrolytes but only for more concentrated suspensions and small amounts of adsorbed polymer. Polymer adsorption in dilute suspensions, which did not show particle aggregation was measured an electrophoretic technique. In more concentrated suspensions, where flocculation takes place, we found that aggregation prevents further polymer adsorption and induces both an excluded volume and a surface effect. The consequences on the shape of the isotherms differ according to the aggregation mechanism.A significant decrease of the amount, , of adsorbed polymer is observed with non-equilibrium bridging. When both mechanisms simultaneously contribute to the aggregation, the value of depends on their relative importance. In the intermediate range of copolymer dose their respective contributions are critically sensitive to the details of the mixing step and stirring, leading to non reproducible experimental results.     

载体对负载型TiO2催化剂光催化性能的影响

 以活性碳（AC）和镁铝尖晶石（MA）为载体，采用真空吸附水解法制备了负载型光催化剂TiO2／AC和TiO2／MA，并采用TiO2溶胶负载法制备了活性碳负载催化剂TiO2（C）／AC．以氯仿为探针分子研究了其在催化剂上的吸附及光催化降解反应性能．结果表明，催化剂的制备方法、TiO2负载量与载体的吸附性能对光催化活性有明显的影响．通过优化制备条件，TiO2／AC催化剂的催化活性可提高到纳米TiO2的2．5倍．氯仿在AC上的饱和吸附量较高，但吸附强度较弱；在纳米TiO2上的吸附情况则正好相反．氯仿在AC和TiO2上吸附性质的差异有利于吸附在TiO2／AC上的氯仿分子从活性碳载体向TiO2光催化活性中心迁移．镁铝尖晶石载体对光催化反应没有明显的促进作用，与其基本上不吸附氯仿分子有关．与TiO2胶体负载法相比，真空吸附水解法是一种较好的负载型TiO2光催化剂制备方法．