Dynamic Rebound Behavior of Silica/Natural Rubber Composites: Fly Ash Particles and Precipitated Silica

This article investigated the elastic response of natural rubber (NR) compounds filled with silica from fly ash particles (FASi) and commercial precipitated silica (PSi), through a dynamic rebound test. The effects of silica content and initial drop‐height on the height and number of rebounds, dynamic stiffness, and the energy loss were of interest. The results suggested that the unfilled NR vulcanizates exhibited a greater elastic response than the FASi and PSi‐filled vulcanized composites. For given silica contents, the NR compounds with FASi had better elastic response than those with PSi, where the elastic response decreased with an increase in silica content. The greater the silica contents, the higher the dynamic stiffness of the composites. The initial drop‐height had no effects on the elastic response change for the unfilled NR compound, but resulted in an increase in the energy loss for the silica‐filled NR composites. The differences in the elastic responses for the NR compounds filled with silica from FASi and PSi were associated with the differences in crosslink density and the filler–filler interaction influenced by content of bis(3‐triethoxysilylpropyl) tetrasulfane (designated as Si69) used.     

Synthesis,Characterization, and Catalytic Behavior of Bamboo Rice Husk Ash

In this paper, we report the use of bamboo rice husk ash as an efficient, greener, reusable, and biodegradable heterogeneous catalyst for the synthesis of tetrahydro‐4H ‐chromene‐3‐carbonitriles via the one‐pot three‐component reaction of malononitrile with aromatic aldehydes and dimedone or 1,3‐cyclohexanedione. The formation of bamboo rice husk ash‐silica has been confirmed by several analytical techniques.     

生物质与烟煤混合灰熔融特性影响因素的研究

为探究气氛、混合比及残炭含量对生物质与煤混合灰熔融特性的影响,将松木屑灰与乌海烟煤灰按不同质量比混合,采用智能灰熔点仪测定各混合灰样在不同气氛下的灰熔融温度,X射线衍射仪从矿物质演变角度分析混合灰熔融温度变化的原因。结果表明,由于铁尖晶石和铁橄榄石的生成,使混合灰的熔融温度在弱还原性气氛下比氧化性气氛下低,且差值的大小与混合灰中Fe含量有关;随松木屑灰含量的增加,钙铝黄长石、镁黄长石、白榴石等低温共熔物的生成量增加,使混合灰的熔融温度降低;此外,由于Fe-C共熔体(Fe_xC_y)的生成、灰锥局部还原性气氛及残炭的"骨架"作用,使混合灰的熔融温度随煤灰中残炭含量的增加呈现先升高后降低再升高的趋势。     

Nano Silicon from Nano Silica Using Natural Resource (Rha) for Solar Cell Fabrication

Abstract

High purity (～99%) nano silica with an average particle size of ～100 nm was extracted at pH 3 at 650°C from a natural resource, rice husk, using alkaline extraction followed by acid precipitation method. Using nano silica as a precursor, silicon (Si) nanoparticles have been synthesized by high-temperature magnesiothermic reduction method. The prepared sample was characterized by X-ray diffraction, particle size analyzer, Fourier transform infrared spectroscopy, transmission electron microscopy, X-ray fluorescence analyzer, and UV–Vis spectroscopy. The comprehensive characterization studies indicate the pure phase formation of Si and the variation of particle size from 70 nm to 100 nm for samples synthesized at different sintering temperatures. Moreover, the silicon nanoparticles produced at 850°C have pure phase formation, high purity, and good absorption peaks. The efficiency calculated through IV characteristics is found to be increasing in silicon and ruthenium combination (2.67%), which is better than that achieved from the conventional solar cells. The produced silicon nanoparticles could be applied as an anode material for solar cell fabrication.     

Electroless plating of copper on fly ash cenospheres using polyaniline‐Pd activation

The polyaniline of different intrinsic oxidation states, viz., the emeraldine (EM) and the leucoemeraldine (LM) states, were coated on 3‐aminopropyltriethoxy silane modified fly ash cenospheres. Without prior sensitization by SnCl₂ solution, Pd activation by PdCl₂ solution was carried out on EM and LM laden cenospheres, followed by electroless plating of copper (Cu). The topography and composition of the composites were characterized by scanning electron microscopy, X‐ray diffraction, and X‐ray photoelectron spectroscopy, etc. The results indicate that the oxidation state of the LM layer showed a much bigger increase than that of the EM layer in the Pd activation process, while coupled Pd reduction underwent to a more extent on the LM layer. The metallic Pd atoms on the LM and EM layers surface initiated the subsequent electroless plating of Cu, and the coated Cu on LM laden cenospheres had a much more uniform and compact morphology than that on EM laden cenospheres. Copyright © 2012 John Wiley & Sons, Ltd.     

A New Organophosphorus Insecticides Removal Process Using Fly ASH

Abstract

Fly ash and soil mixtures with a range of fly ash content from 1 to 100% were used to study adsorption and desorption of four organophosphorus insecticides, ethyl parathion, methyl parathion, fenitrothion and fenthion, in batch experiments. The object of the study was to develop a treatment process using fly ash as sorbent material to isolate/immobilize organic contaminants from aqueous solutions. The adsorption isotherms fit the Freundlich equation x/m=K_dC^1/n. The K_d values increase with the increase of the fly ash content. The isotherms seem to fit the S type, in mixtures of soil with a fly ash content from 0 to 10%, which implies that adsorption becomes easier as the concentration in the liquid phase increases. In mixtures of soil with a fly ash content from 25 to 50% the isotherms become L type and correspond to a decrease of site availability as the solution concentration increases. Finally in mixtures of soil with a fly ash content over 50%, C type adsorption was observed which correspond to a constant partition of the insecticides between the bulk solution and the adsorbent. Mass balance estimations show that the mean percent amounts of insecticides for a range of concentration 0.5–15 mg/l, removed by adsorption in the soil sample are 81.56 % for ethyl parathion, 48.97 % for methyl parathion, 67.06 % for fenitrothion and 86.65 % for fenthion. The adsorption increases as the fly ash content increased and reach the 100% in the “pure” fly ash. The adsorbed amounts of insecticides in mixtures of soils with >50% fly ash content, are up to 99%. In contrast, the amounts of desorption in water decrease as the fly ash content increase.

The results of this research demonstrate that the fly ash shows a significant capacity for adsorption of organophosphorus compounds from aqueous solution and can be used for pesticide removal process.     

Elution behaviour and environmental impact of heavy metals and rare-earth elements from volcanic ashes of Mt. Oyama,Miyake Island

To obtain information on the environmental impact of materials eluted from volcanic ashes of Mt. Oyama, Miyake Island, which erupted in July 2000, the dissolution behaviours of heavy metals and rare-earth elements from the volcanic ashes were examined. The most important characteristic of the Mt. Oyama eruption is that sulphur dioxide (SO₂) gas has been continuously released, and all persons living on Miyake Island have been required to evacuate. To estimate in terms of the volcanic eruption using SO₂ gas, the ash nature in Mt. Usu, Hokkaido, was also examined and compared with that in Mt. Oyama. When rain water mixed the ashes, the water from the ashes of Mt. Oyama became acidic because of the sulphuric acid. Therefore, SO₂ gas in Mt. Oyama can accelerate the dissolution of protons and heavy metals in the ashes, whereas the rain water in Mt. Usu was not acidic and the dissolution of the heavy metals was not so evident compared with that in the case of Mt. Oyama. With this sulphuric acid, heavy metals such as As, Cd, Pb and Hg in the ashes in Mt. Oyama easily dissolved owing to the low pH. The ashes in Mt. Oyama had been released for eight years and the amount of fallen ashes was estimated to be 33 billion tons. The weights of the harmful heavy metals in the volcanic ashes, such as As, Cd, Pb and Hg, were estimated to be 3.8?×?10², 1.3?×?10³, 1.1?×?10³ and 29?kg, respectively, and these heavy metals were dissolved and diluted in seawater. Therefore, the concentration and species (chemical form) of these metals should be carefully monitored in the future. Moreover, SO₂ gas, which has a direct effect on human health and has been monitored continuously, causes other effects, such as facilitation of metal ion elution and rock aeration.     

Concise Synthesis of (3Z)-Dodecen-12-olide,Pheromone Component of the Emerald Ash Borer

Emerald ash borer (EAB), Agrilus planipennis Fairmaire, is an invasive insect that has killed millions of ash trees in Canada and the USA. (3Z)-Dodecen-12-olide is a known female-produced pheromone of this insect, and a concise, three-step synthesis of a 2:1 blend of (3Z)-dodecen-12-olide and (3E)-dodecen-12-olide starting from commercially available (2-carboxyethyl)triphenylphosphonium bromide and 10-bromo-1-decene is described. The key steps in this synthesis are a lithium-salt-free Wittig reaction and an intramolecular S_N2 esterification. Both of these macrocyclic lactones are behaviorally active toward EAB, and the 2:1 blend whose synthesis is described here has the potential to be a detection agent, mating disruptor, or mass trapping agent, which could be used in the control of EAB.     

基于布谷鸟算法与BP神经网络的煤灰变形温度预测

以120种煤样为数据基础,采用布谷鸟算法(CS)优化BP(Back Propagation)神经网络,建立了CSBP模型对单煤、煤掺添加剂和配煤等3类样本的煤灰变形温度(DT)样本进行预测。模型以煤灰化学成分及其组合参数等13个变量作为输入量,以变形温度(DT)作为输出量。CSBP模型预测结果与BP神经网络模型预测结果进行对比发现,无论是单煤、煤掺添加剂还是配煤,CSBP模型较BP模型对煤灰变形温度(DT)的预测都更加精准,平均相对误差分别达到了3.11%、4.08%和4.22%。另外,对比3类样本预测结果发现,无论是CSBP模型还是BP模型,相比单煤预测而言,煤掺添加剂及配煤的预测误差都有明显的增加。     

灰中酸性成分对灰熔融温度的影响

搜集并统计了世界129种典型煤种、城市污水污泥及污泥/煤混烧灰样的灰成分及灰熔融特征温度等相关数据,研究灰中酸性成分SiO2、Al2O3、TiO2和P2O5对灰熔融特性的影响。结果表明,Al2O3是决定灰熔点的主要因素,酸性金属氧化物SiO2、Al2O3和TiO2形成的耐熔矿物质石英、偏高岭石、莫来石、金红石等可提高灰熔点。非金属氧化物P2O5与污泥和污泥/煤的灰熔点FT二次拟合很好且明显降低熔点,污泥灰中P2O5含量显著高于煤灰是导致其熔点明显低于煤的重要原因。