纳米MOSFET迁移率解析模型

从玻尔兹曼方程出发，重新计算了纳米MOSFET沟道内的载流子所服从的分布函数，特别是考虑了纳米MOSFET横向电场和纵向电场之间的相互作用，并且以得到的非平衡状态下的分布函数为基础，考虑载流子寿命和速度的统计分布，给出了纳米MOSFET载流子迁移率的解析表达式.通过与数值模拟结果进行比较和分析，该迁移率解析模型形式简洁、物理概念清晰，且具有相当精度. 关键词： 玻尔兹曼方程 纳米MOSFET 迁移率 沟道有效电场     

Time delay as a key to apoptosis induction in the p53 network

A feedback mechanism that involves the proteins p53 and mdm2, induces cell death as a controlled response to severe DNA damage. A minimal model for this mechanism demonstrates that the response may be dynamic and connected with the time needed to translate the mdm2 protein. The response takes place if the dissociation constant k between p53 and mdm2 varies from its normal value. Although it is widely believed that it is an increase in k that triggers the response, we show that the experimental behaviour is better described by a decrease in the dissociation constant. The response is quite robust upon changes in the parameters of the system, as required by any control mechanism, except for few weak points, which could be connected with the onset of cancer. Received 8 May 2002 / Received in final form 9 July 2002 Published online 17 September 2002     

不同入射角度下强流脉冲电子束能量沉积剖面和束流传输系数模拟计算

 强流脉冲电子束在材料中的能量沉积剖面、能量沉积系数和束流传输系数受其入射角的影响很大，理论计算了0.5~2.0MeV的电子束以不同的入射角在Al材料中的能量沉积剖面和能量沉积系数，并且还计算了0.4~1.4MeV电子束以不同入射角穿透不同厚度C靶的束流传输系数。计算结果表明，随着入射角的增大，靶材表面层单位质量中沉积的能量增大，电子在靶材料中穿透深度减小，能量沉积系数减小，相应的束流传输系数也减小；能量为0.5~2.0MeV的电子束当入射角在60°~70°时在材料表面层单位质量中沉积的能量较大。     

An AFM, XPS and electrochemical study of molecular electroactive monolayers formed by wet chemistry functionalization of H-terminated Si(1 0 0) with vinylferrocene

Molecular electroactive monolayers have been produced from vinylferrocene (VFC) via light-assisted surface anchoring to H-terminated n- and p-Si(1 0 0) wafers prepared via wet chemistry, in a controlled atmosphere. The resulting Si-C bound hybrids have been characterized by means of XPS and AFM. Their performance as semiconductor functionalized electrodes and their surface composition have been followed by combining electrochemical and XPS measurements on the same samples, before and after use in an electrochemical cell. White-light photoactivated anchoring at short (1 h) exposure times has resulted in a mild route, with a very limited impact on the initial quality of the silicon substrate. In fact, the functionalized Si surface results negligibly oxidized, and the C/Fe atomic ratio is close to the value expected for the pure molecular species. The VFC/Si hybrids can be described as (η⁵-C₅H₅)Fe²⁺(η⁵-C₅H₄)-CH₂-CH₂-Si species, on the basis of XPS results. Electrochemical methods have been applied in order to investigate the role played by a robust, covalent Si-C anchoring mode towards substrate-molecule electronic communication, a crucial issue for a perspective development of molecular electronics devices. The response found from cyclic voltammograms for p-Si(1 0 0) functionalized electrodes, run in the dark and under illumination, has shown that the electron transfer is not limited by the number of charge carriers, confirming the occurrence of electron transfer via the Si valence band. The hybrids have shown a noticeable electrochemical stability and reversibility under cyclic voltammetry (cv), and the trend in peak current intensity vs. the scan rate was linear. The molecule-Si bond is preserved even after thousands of voltammetric cycles, although the surface coverage, evaluated from cv and XPS, decreases in the same sequence. An increasingly larger surface concentration of Fe³⁺ at the expenses of Fe²⁺ redox centers has been found at increasing number of cv’s, experimentally associated with the growth of silicon oxide. Surface SiO⁻ groups from deprotonated silanol termination, induced by the electrochemical treatments, are proposed as the associated counterions for the Fe³⁺ species. They could be responsible for the observed decrease in the electron transfer rate constant with electrode ageing.     

纳米氧化钛-乙二醇溶胶溶液的研究

选用了钛酸丁酯、硬脂酸和乙二醇作为表面活性剂，采用表面化学修饰和表面物理修饰2种方法修饰纳米氧化钛，然后分散在乙二醇溶剂中形成溶胶溶液．并通过红外光谱仪、紫外分光计、原子力显微镜，分析了表面化学修饰后的纳米氧化钛表面化学结构的变化，观测了纳米氧化钛溶胶在乙二醇溶剂中稳定性．试验结果表明表面活性剂与纳米氧化钛的表面的不饱和键之间形成了新的化学结构，粒子表面可能接枝上有机长链，提高了纳米粒子在溶剂中的相容性．表面化学修饰后的纳米氧化钛与乙二醇溶剂形成了较稳定的溶胶体系，而且纳米溶胶粒径较小．表面活性剂添加量与纳米粒子添加量控制在(1～1．2)：1时，可以获得纳米溶胶粒径较小，同时溶胶稳定性较好的纳米氧化钛-乙二醇溶胶体系．     

Transport of Neutrally Buoyant and Dense Variably Sized Colloids in a Two-Dimensional Fracture with Anisotropic Aperture

The transport of monodisperse as well as polydisperse colloid suspensions in a two-dimensional, water saturated fracture with spatially variable and anisotropic aperture is investigated with a particle tracking model. Both neutrally buoyant and dense colloid suspensions are considered. Although flow and transport in fractured subsurface formations have been studied extensively by numerous investigators, the transport of dense, polydisperse colloid suspensions in a fracture with spatially variable and anisotropic aperture has not been previously explored. Simulated snapshots and breakthrough curves of ensemble averages of several realizations of a log-normally distributed aperture field show that polydisperse colloids exhibit greater spreading than monodisperse colloids, and dense colloids show greater retardation than neutrally buoyant colloids. Moreover, it is demonstrated that aperture anisotropy oriented along the flow direction substantially increases colloid spreading; whereas, aperture anisotropy oriented transverse to the flow direction retards colloid movement.     

介孔网络电路

用二次阳极氧化法制备纳米多孔氧化铝板,然后用磁控溅射方式在纳米多孔氧化铝板表面镀金得到介孔网络电路,对该介孔网络电路进行输运测量,发现其具有非线性电阻.     

Numerical simulation of thermally and chemically nonequilibrium flows and heat transfer in underexpanded induction plasmatron jets

The results of numerical simulation are presented for thermally and chemically nonequilibrium air plasma flows in a plasmatron discharge channel and underexpanded dissociated and partially ionized air jets flowing past a cylindrical model with a blunt leading edge and cooled copper surface under the experimental conditions realized in a VGU-4 100 kW induction plasmatron (Institute for Problems in Mechanics of the Russian Academy of Sciences) (see, for example, [1, 2]). The nonequilibrium excitation of the vibrational degrees of freedom of the molecules in the modal approximation and the difference between the electron and translational heavy-particle temperatures are taken into account in the calculations. The calculated data on the heat transfer and pressure at the stagnation point are compared with the results obtained within the framework of the thermally equilibrium model. Comparison with the experimental data obtained in the Institute for Problem in Mechanics of the Russian Academy of Sciences (Laboratory for interaction between plasma and radiation and materials) and kindly provided for comparison purposes gives satisfactory agreement.     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Synthesis and characterization of a polyfluorene containing carbazole and oxadiazole dipolar pendent groups and its application to electroluminescent devices

We have synthesized a blue‐light‐emitting polyfluorene (PF) derivative ( PF‐CBZ‐OXD ) that presents bulky hole‐transporting carbazole and electron‐transporting oxadiazole pendent groups functionalized at the C‐9 positions of alternating fluorene units. The results from photoluminescence and electrochemical measurements indicate that both the side chains and the PF main chain retain their own electronic characteristics in the copolymer. An electroluminescent device incorporating this polymer as the emitting layer was turned on at 4.5 V; it exhibited a stable blue emission with a maximum external quantum efficiency of 1.1%. Moreover, we doped PF‐CBZ‐OXD and its analogue PF‐TPA‐OXD with a red‐light‐emitting iridium phosphor for use as components of phosphorescent red‐light emitters to investigate the effect of the host's HOMO energy level on the degree of charge trapping and on the electrophosphorescent efficiency. We found that spectral overlap and individual energy level matching between the host and guest were both crucial features affecting the performance of the electroluminescence devices. Atomic force microscopy measurements indicated that the dipolar nature of PF‐CBZ‐OXD , in contrast to the general nonpolarity of polydialkylfluorenes, provided a stabilizing environment that allowed homogeneous dispersion of the polar iridium triplet dopant. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2925–2937, 2007