书籍扫描图像畸变参数自动计算方法的研究

为实现书籍扫描图像的畸变自动校正,提出用多项式来描述各像素的理论灰度g(zi)与页面上对应点到扫描仪工作平面距离zi二者之间的关系。为确立该多项式,在畸变参数已知条件下扫描一幅图像,根据已知畸变参数求出zi,即可按最小二乘法原理由各像素灰度的实际值求出多项式的各个系数。实验证明,采用4阶多项式已能满足一般要求,并求出了各系数。对任意扫描图像,自动计算畸变参数的方法为:首先利用扫描图像上页边空白处各像素的灰度,对畸变参数进行估计,并求出zi的估计值;然后代入所确立的多项式,可求得g(zi);通过调整各畸变参数的估计值,直到g(zi)与gi最为接近,即得最佳畸变参数。用于图像校正实验,获得了较好的校正效果,最大误差由不校正时的41%下降到了6.9%。这使得无需用户测量并输入有关畸变参数即可进行自动校正。     

理想气体吸热和放热的讨论

根据热力学第一定律和理想气体状态方程推导了理想气体的热容量公式,并对理想气体在p-V图上的直线过程和循环过程的温度变化及吸热和放热进行了讨论.     

彩色透明微晶玻璃的吸收光谱

在Li2O-Al2O3-SiO2系统玻璃中掺入少量晶核剂TiO2,ZrO2,P2O5，再掺入稀土离子和过渡金属离子作为着色剂，在高温下溶制得到彩色透明玻璃，对上述玻璃进行微晶化处理，用差热分析（DTA）确定其晶化温度，测定与讨论了所获彩色透明微晶玻璃在紫外波段至近红外波段的吸收光谱特性，研究结果表明，玻璃微晶化后，由于基质玻璃对光的微弱散射，引起吸收的增强，但不改变稀土离子和过渡金属离子的本征吸收峰位。     

傅里叶变换红外光谱与拉曼光谱分析碳青霉烯药物亚胺培南的结构特征

本文采用傅里叶变换红外光谱和激光拉曼光谱对碳青霉烯药物亚胺培南进行光谱检测,并对其的分子振动光谱与结构特征进行分析和探讨,分析了亚胺培南在固相状态下的结构形式,从而为药物合成及质量控制提供了重要的参考价值。     

Microperforated insertion units: An alternative strategy to design microperforated panels

Microperforated panels (MPPs) coupled to a rigid wall have been proposed recently as an alternative to porous absorbers in situations having concerns with bacterial contamination and small particles discharge, like food, pharmaceutical and microelectronic industries. There exists also an increasing interest for MPP absorbers in the transportation industry and civil engineering. In general, an optimally designed MPP with good broadband absorption requires many submillimetric holes distributed over a panel of also submillimetric thickness. Such thin plates or foils become so fragile that they need to be protected from mechanical damage. In this paper, an alternative strategy is investigated which allows the design of MPPs with panels of millimetric thickness while maintaining their acoustic performance. These absorbers, named microperforated insertion units (MIUs), avoid the structural problems of the classical MPPs. An assessment of the sound absorption properties of these structures is presented. Comparisons between calculations and measurements are also made under two experimental conditions: plane waves at normal incidence (impedance tube) and free field (anechoic room).     

用区域分解算法结合蒙特卡罗法求坦克温度场和红外辐射出射度

本文将区域分解算法和蒙特卡罗法相结合，求坦克温度场和红外辐射出射度．采用蒙特卡罗法计算辐射传递系数，可以考虑界面的复杂辐射特性，如：镜反射、各向异性发射、各向异性反射等；可直接考虑界面的复杂几何特性，如:相互遮挡、太阳入射方向上的投影面积等．引入辐射传递系数，分离了计算的难点，使得在时间域（计算步骤）上能把整个问题分解为若干个子问题并行处理、在空间域（计算区域）上将坦克分解为若干个子区域，缩小计算规模，并可使用多个处理器并行计算；同时减轻了蒙特卡罗法编程的难度，缩短了计算时间．     

声流现象的研究及其应用

本文从声流产生的机理出发，综合了影响声流的诸因素，介绍了声流现象的检测方法及声流效应的应用。     

A fast atom bombardment mass spectrometric analysis of crown ether complexes [1]

Analyses of crown ether complexes of alkali metal ions and characterization of the complexes formed inm-nitrobenzyl alcohol have been carried out by fast atom bombardment (FAB) mass spectrometry. By using m-nitrobenzyl alcohol as a matrix for measurements, the stoichiometry of the complexes was assessed on the basis of the observed FAB peaks. In addition, the formation of crown ether-alkali metal complexes at a 2 : 1 molar ratio was enhanced by increasing the ionic radius of the metal ion in agreement with previous observations. On these grounds, FAB mass spectrometry may provide a rapid means for investigation of the complexation behavior of crown ethers and the stoichiometry of the complexes.     

双轴晶体Nd^3＋：KGd（WO4）2的非偏振吸收光谱研究

报道了用三个方向相互垂直的非偏振吸收光谱测量计算Ｊｕｄｄ－Ｏｆｅｌｔ参数从而算出双轴晶体Ｎｄ３＋ＫＧｄ（ＷＯ４）２的荧光寿命、荧光分支比和发射截面的方法。得到的荧光寿命为１１９μｓ，平均发射截面为２．３×１０－１９ｃｍ２。     

3D molecular imaging SIMS

Thin monolayer and bilayer films of spin cast poly(methyl methacrylate) (PMMA), poly(2-hydroxyethyl methacrylate) (PHEMA), poly(lactic) acid (PLA) and PLA doped with several pharmaceuticals have been analyzed by dynamic SIMS using SF₅⁺ polyatomic primary ion bombardment. Each of these systems exhibited minimal primary beam-induced degradation under cluster ion bombardment allowing molecular depth profiles to be obtained through the film. By combing secondary ion imaging with depth profiling, three-dimensional molecular image depth profiles have been obtained from these systems. In another approach, bevel cross-sections are cut in the samples with the SF₅⁺ primary ion beam to produce a laterally magnified cross-section of the sample that does not contain the beam-induced damage that would be induced by conventional focussed ion beam (FIB) cross-sectioning. The bevel surface can then be examined using cluster SIMS imaging or other appropriate microanalysis technique.