Cu2+与烟草多酚氧化酶相互作用研究

本文通过酶活性测定，荧光光谱和紫外光谱研究了外加Cu²⁺与烟草多酚氧化酶(简称PPO)的相互作用。结果表明，微量铜的加入能增加酶的活性，[Cu²⁺]/[PPO]为0.20左右时酶活性最大，[Cu²⁺]/[PPO]为0.91时，Cu²⁺开始表现出对PPO活性的抑制;Cu²⁺对PPO内源荧光的猝灭机制属于形成络合物所引起的静态猝灭，猝灭常数K_sv为8.0375×10³L·mol^-1;Cu²⁺的加入使PPO蛋白质分子构象发生变化，α-螺旋含量增加，多肽链及Trp和Tyr残基的芳杂环进一步向分子内收缩，疏水基团之间的疏水作用增强。     

Surface-enhanced Raman scattering studies on the adsorption of p-nitrobenzoic acid at Au electrode under different potential with ultraviolet excitation

The potential-dependent surface-enhanced Raman spectrum of adsorbed p-nitrobenzoic acid (PNBA) on the roughened Au electrode has been obtained by using ultraviolet (UV) excitation at 325 nm. The surface-enhanced Raman spectra of PNBA intensely changed when the voltage was in the rang of negative value, and the electrode potential at which the resonance (potential of maximum intensity) occurs varied when the vibrational mode changes, indicating that the PNBA molecules were chemisorbed on the roughened Au surface. The charge transfer (CT) mechanism could probably explain the experiment results in the present work.     

Separation of inorganic anions by reversed-phase ion-pair chromatography with direct UV detection

In this paper, a separation method of the inorganic anions including I^–, NO ₂ ^– , NO ₃ ^– , IO ₃ ^– and SCN^– on the reversed-phase ion-pair chromatography with direct UV detection has been developed, and the limits of detection of these inorganic anions were determined. The effects of the organic modifier volume fraction and concentration of the ion-pair reagent on the retention of inorganic anions were discussed.     

Photocatalytic and antifouling properties of TiO2-based photocatalytic membranes

Photocatalysis has been extensively studied due to its potential ability to avoid the excessive use of chemical reagents and reduce the energy consumption by employing solar energy. Moreover, to alleviate the reduction in the membrane permeation selectivity, separation efficiency, and membrane service life caused by the emerging micro-pollutants and membrane fouling, membrane technology is often coupled with microbial, electrochemical, and catalytic processes. However, although physical/chemical cleaning and membrane module replacement can overcome the inherent limitations caused by membrane fouling and other membrane separation processes, high operating costs limit their practical applications. In this review, common preparation methods for TiO₂ photocatalytic membranes are described in detail, and the main approaches to enhancing their photocatalytic performance are discussed. More importantly, the mechanism of the TiO₂ photocatalytic membrane antifouling process is elucidated, and some applications of photocatalytic membranes in other areas are described. This review systematically outlines future research directions in the field of photocatalytic membrane modification, including metal and non-metal doping, fabrication of heterojunction structures, control over reaction conditions, increase in hydrophilicity, and increase in membrane porosity.     

Thermal stability of lysozyme and myoglobin in the presence of anionic surfactants

The interactions of lysozyme and myoglobin with anionic surfactants (hydrogenated and fluorinated), at surfactant concentrations below the critical micelle concentration, in aqueous solution were studied using spectroscopic techniques. The temperature conformational transition of globular proteins by anionic surfactants was analysed as a function of denaturant concentration through absorbance measurements at 280 nm. Changes in absorbance of protein-surfactant system with temperature were used to determine the unfolding thermodynamics parameters, melting temperature, T _m, enthalpy, ΔH _m, entropy, ΔS _m and the heat capacity change, ΔC _p, between the native and denatured states.     

UV curable epoxy acrylate-clay nanocomposites

UV curable epoxy acrylates were reinforced with two different organically modified montmorillonites (MMTs) and an unmodified MMT. Conversion and rate of polymerization was monitored by real time infrared spectroscopy (RTIR) and photo-DSC. Microstructures were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM) and optical clarity. Optical clarity of the films containing clay was quite good as only a slight decrease was observed. Physical properties of the reinforced films were examined by differential scanning calorimetry (DSC), dynamic mechanical thermal analysis (DMTA), hardness and tensile testing. Enhancements in glass transition temperature (T_g), thermal stability and mechanical properties were observed. The films reinforced with the unmodified MMT exhibit the most significant enhancements in properties.     

Preparation and characterization of theβ-cyclodextrin inclusion complex with sulfafurazole

The 1 : 1 inclusion complex involving sulfafurazole (SF) and-cyclodextrin (-CD) is prepared by the freeze-drying method and characterized on the basis of its chemical analysis, thermal behavior, infrared spectrum, X-ray powder pattern and¹³C NMR spectrum in DMSO-d₆ solution. The stability constant of the inclusion complex was determined by the solubility method. The effect of cyclodextrin on the UV absorption spectrum of sulfafurazole was also observed.     

Bestimmung von Melment in Zementmischungen durch UV-Spektralphotometrie

Ohne Zusammenfassung

---

Determination of melment in cement mixtures by UV-spectrophotometry

     

High-Resolution,Higher-Order UV/VIS Derivative Spectrophotometry

Derivative spectrophotometry has gained increasing importance in the past two years and is currently experiencing vigorous development. Following and introduction the present article provides a review of this extremely effective method. In particular, the advantages of higher-order derivative spectrophotometry (HODS method, n > 2) are discussed on the basis of practical examples from a wide range of analytical fields. The results are achieved with the aid of a newly developed analog computer unit, whereby for the first time readily reproducible, low-noise, on-line spectra can be obtained up to the 7th order and even, in favorable cases, up to the 9th order. In practice it has proved valuable to work with spectra of the 3rd to 5th order; but even higher derivations could be profitable for the separation of strongly superposed signals or for “fingerprinting”.     

The effect of nanosized titania-silica film composition on the photostability of adsorbed methylene blue dye

The effect of nanosized porous films (average density 10 g/m²) of TiO₂. TiO₂/SiO₂, and SiO₂ on the photostability of adsorbed methylene blue (MB) dye during UV irradiation in air was investigated by optical spectroscopy and laser-induced mass spectrometry. The effectiveness of the photodecomposition of MB decreases in the order TiO₂ > TiO₂/SiO₂ > SiO₂ with rate constants 1E-2, 0.6E-2, and 0.3E-2 min⁻¹ respectively. A mechanism including the participation of both excited states of the dye molecules and photoexcited titanium dioxide is proposed for the photodecolorization of MB adsorbed on the surface of the investigated films. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 43, No. 4, pp. 220–225, July–August, 2007.