Brønsted Acidity and Aluminum Substitution Characteristics of Si(nAi) Sites in Zeolites: A Theoretical MNDO Calculation

The Brønsted acidity of the various Si(nAl) sites present in zeolites is evaluated from proton binding energy and LUMO energy calculated by the semiempirical MNDO quantum chemical method. The two calculated energy values both exhibit a linear correlation with the existing ²⁹Si NMR chemical shift and the IR hydroxyl stretching frequency data. The inter-convertibility between different Si(nAl) sites during an alumination or dealumination process is also evaluated based on the calculated substitution energy. The results indicate that alumination processes are less favorable to occur in zeolites than dealumination processes and the latter is more likely to occur for Si(nAl) clusters that contain the maximum number of aluminum nearest neighbors.     

Preparation and characterization of sulfated zirconia (SO4/ZrO2)/Nafion composite membranes for PEMFC operation at high temperature/low humidity

Fine particle superacidic sulfated zirconia (SO₄²⁻/ZrO₂, S-ZrO₂) was synthesized by ameliorated method, and composite membranes with different S-ZrO₂ contents were prepared by a recasting procedure from a suspension of S-ZrO₂ powder and Nafion solution. The physico-chemical properties of the membranes were studied by ion exchange capacity (IEC) and liquid water uptake measurements, scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis, thermogravimetry–mass spectrometry (TG–MS) and Fourier transform infrared (FT-IR) spectroscopy. The results showed that the IEC of composite membrane increased with the content of S-ZrO₂, S-ZrO₂ was compatible with the Nafion matrix, the incorporation of the S-ZrO₂ could increase the crystallinity and also improve the initial degradation temperature of the composite membrane. The performance of single cell was the best when the S-ZrO₂ content was 15 wt.%, and achieved 1.35 W/cm² at 80 °C and 0.99 W/cm² at 120 °C based on H₂/O₂ and at a pressure of 2 atm, the performance of the single cell with optimized S-ZrO₂ was far more than that of the Nafion at the same condition (e.g. 1.28 W/cm² at 80 °C, 0.75 W/cm² at 120 °C). The 15 wt.% S-ZrO₂/Nafion composite membrane showed lower fuel cell internal resistance than Nafion membranes at high temperature and low relative humidity (RH).     

Influence of pretreatment conditions on low-temperature CO oxidation over Au/MOx/Al2O3 catalysts

Composite oxide MO_x/Al₂O₃ supported gold catalysts for low-temperature CO oxidation were prepared and investigated. The presence of transition metal oxide was proved to be beneficial to the improvement of catalytic performance of Au/Al₂O₃ catalysts for low-temperature CO oxidation. Furthermore, the influence of various pretreatment conditions on Au/MO_x/Al₂O₃ catalysts was studied carefully. The image of TEM showed that gold catalyst with small gold particles only in the form of a fine dispersion exhibited highly catalytic activity. The XPS, Fourier transform infrared (FTIR) spectroscopy characterization results of Au/FeO_x/Al₂O₃ catalyst showed that gold catalysts having partially oxidized gold species have the best catalytic performance. One possible pathway for CO oxidation on Au/FeO_x/Al₂O₃ catalyst is that the CO adsorbed on gold particles reacts with adsorbed oxygen, which is possible to occur on oxygen vacancies on the support or at the metal–support interface.     

聚苯乙烯/蒙脱土熔融插层复合的研究

用熔融法制备了聚苯乙烯／蒙脱土插层复合材料，用Ｘ 射线衍射、ＤＳＣ等手段研究了复合材料的结构与性能．聚苯乙烯熔体不能插层于钠基蒙脱土中，但能插层于经有机化合物处理过的蒙脱土中．     

Electrochemical Reduction of Monochlorinated Hydrocarbons at a Hydrophobic Zn/PTFE Composite‐Electroplated Zn Electrode in a Water‐Acetonitrile Mixture

Composite‐electroplating of zinc particles with polytetrafluoroethylene at a zinc substrate resulted in a working electrode which could be used at high negative potentials (to ?2.5 V vs. Ag/AgCl) without significant hydrogen evolution. The electrodes were characterized by SEM and CV and were used to detect organochloride compounds in a water‐acetonitrile mixture, by potential step methods.     

Mechanical properties of fiber reinforced styrene-butadiene rubbers using surface-modified UHMWPE fibers under EB irradiation

Aiming to develop a high performance fiber reinforced rubber of SBR, a special technique using electron beam (EB) irradiation-induced graft-polymerization was applied to ultra-high molecular-weight polyethylene (UHMWPE) fibers. Although UHMWPE is chemically inert, N-vinyl formamide (NVF) could be graft-polymerized onto the UHMWPE fiber surface with this special technique. A maximum grafting percentage of 23.6% was achieved. The composite of SBR and grafted UHMWPE fibers with maximum grafting indicated a linear increase in the initial modulus and strength with the fiber content. At the fiber content of 10%, the initial modulus was improved about five times with respect to that of the pure SBR, while the strength was done about twice. At this moment, only a small reduction could be observed in the strain compared with that of pure SBR. The fiber reinforced rubber with a good performance was obtained in the system of SBR and grafted UHMWPE fibers.     

Eco-friendly synthesis of high silica zeolite Y with choline as green and innocent structure-directing agent

Zeolite synthesis in contemporary chemical industries is predominantly conducted using organic structure-directing agents (OSDAs), which are chronically hazardous to humans and the environment. It is a growing trend to develop an eco-friendly and nuisanceless OSDA for zeolite synthesis. Herein, choline is employed as a non-toxic and green OSDA to synthesize high silica Y zeolite with SiO₂/Al₂O₃ ratios of 6.5–6.8. The prepared Y zeolite samples exhibited outstanding (hydro)thermal stability at ultrahigh temperature owing to the higher SiO₂/Al₂O₃ ratio. The XRF, SEM, ²⁹Si-NMR and ¹³Na+ results suggested that choline plays a structure-directing role in the synthesis of Y zeolite, while the feed molar fraction of Na⁺ is a crucial determinant for the framework SiO₂/Al₂O₃ ratio and the crystal morphology.     

Creeping motion of an assemblage of composite spheres relative to a fluid

The sedimentation of a homogeneous distribution of spherical composite particles and the fluid flow through a bed of these particles are investigated theoretically. Each composite particle is composed of a spherical solid core and a surrounding porous shell. In the fluid-permeable porous shell, idealized hydrodynamic frictional segments are assumed to distribute uniformly. The effect of interactions among the particles is taken into explicit account by employing a fundamental cell-model representation which is known to provide good predictions for the motion of a swarm of nonporous spheres within a fluid. In the limit of a small Reynolds number, the Stokes and Brinkman equations are solved for the flow field in a unit cell, and the drag force exerted by the fluid on the particle is obtained in a closed form. For a distribution of composite spheres, the normalized mobility of the particles decreases or the particle interactions increase monotonically with a decrease in the permeability of their porous shells. The effect of particle interactions on the creeping motion of composite spheres relative to a fluid can be quite significant in some situations. In the limiting cases, the analytical solutions describing the drag force or mobility for a suspension of composite spheres reduce to those for suspensions of solid spheres and of porous spheres. The hydrodynamic behavior for composite spheres may be approximated by that for permeable spheres when the porous layer is sufficiently thick, depending on the permeability.     

Synthesis and characterization of styrene grafted carbon nanotube and its polystyrene nanocomposite

Effective side wall functionalization of single-walled carbon nanotube (SWCNT) with 4-vinylaniline was carried out through solvent free functionalization. The functionalized SWCNT was characterized through FT-IR and NMR. Typical peaks to identify the functionalization were observed. Thermal analysis shows around 48% weight loss in functionalized SWCNT in comparison to the pure SWCNT. The ratio of disordered to order transition (I_D/I_G) in FT-Raman, indicated the generation of some surface defects due to functionalization. Near infrared spectrum of functionalized SWCNT also confirmed the functionalization of SWCNT. The polystyrene nanocomposite materials were prepared with functionalized SWCNT as fillers by solution casting from tetrahydrofuran. The functionalized SWCNT nanocomposite showed significant improvement in mechanical properties and electrical properties. The dispersibility of the carbon nanotube in the composite was investigated by using scanning electron microscopy.     

An IR Study on Adsorption of CO and NO on Copper Ion-exchanged Zeolite Beta

Thee adsorption of CO and NO on copper ion-exchanged zeolite Beta was investigated using IR method.It was found that the thermalvacuum pretreatment procedure could result in the reduction of Cu2 ions in zeolite Beta.The adsorption of CO on Cu sites in zeolite Beta closely follows Langmuir isotherm.Another Cu species may form during the reaction between water and CO.The catalytic decomposition of NO on the zeolite was observed at room temperature,indicating that the decomposition reaction may occur between two coordinated NO ligands of the same dinitrosyhc complex.Furthermore,the appearance of two series of NO adsorption bands reveals that copper ions existing at different cation sites may have different effect on the adsorption and decomposition of NO molecules.