Electrochemical instability of bis(trifluoromethylsulfonyl)imide based ionic liquids as solvents in high voltage electrolytes for potassium ion batteries

1. Download : Download high-res image (153KB)
2. Download : Download full-size image

     

Synthesis and characterization of some carbazole-based imine polymers

Five imine polymers, all containing 3,6-disubstituted carbazole ring in the main polymer chain, were synthesized by solution polycondensation of 3,6-diformyl (N-hexyl) carbazole with hydrazine, 1,4-diaminobenzene, 4,4′-diaminobiphenyl, 1,5-diaminonaphthalene and 3,6-(N-hexyl) diaminocarbazole. The polymers were analyzed by spectroscopic methods and compared with two imine models.     

溶液成膜的温度对聚对苯二甲酸乙二酯结晶度的影响

<正> 用溶液成膜是制备聚合物薄膜的常用方法之一。但是溶液成膜的条件,如成膜温度,溶液浓度等对半结晶聚合物结晶度的影响研究报道较少。制备聚对苯二甲酸乙二酯(PET)非晶态薄膜通常使用熔融热压其后淬火的方法。由于PET在熔点附近易于降解,在薄膜中产生气泡,因而很难制备较大面积的均一厚度的薄膜,如在拉伸试验中所需     

甲烷二氧化碳介质阻挡放电转化产物分布研究

针对介质阻挡放电甲烷二氧化碳转化实验,分析了反应的产物分布,探讨了进料组成和反应器结构对反应的影响.反应产物包括:高H2/CO摩尔比的合成气、气态烃、高辛烷值的汽油组分、醇和酸等含氧有机物.对所述电极结构,产物的选择性随碳数增加而降低;高的甲烷进料浓度有利于烃的生成,对醇和酸的最佳甲烷进料体积分数范围在67.4％～75.1％;放电间隙越小,原料转化率和烃、酸的选择性越大,大的放电间隙对醇的生成有利.     

高铁酸盐在SnO2-Sb2O3/Ti电极上的选择性电化学合成

合成了SnO2-Sb2O3/Ti电极材料.实验结果证实,在14mol/LNaOH水溶液中和完全避免析氧反应的条件下,Fe(Ⅱ)物种在该电极上进行电化学氧化并生成FeO42-.结果表明,Fe(OH)3在浓NaOH溶液中发生酸式电离,形成可溶于水的FeO2-,该离子的浓度随着碱溶液浓度变化而发生明显变化,而且它还是发生化学氧化和电化学氧化的反应物.在SnO2-Sb2O3/Ti电极上,FeO42-的电化学还原起始电位为0.38V(vs.Hg/HgO,14mol/LNaOH),FeO2-电化学氧化起始电位为0.54V.结果还表明,用电化学方法氧化Fe(Ⅱ)物种生成FeO42-是个多步骤过程.     

Temperature-dependent dry etching characteristics of III–V semiconductors in HBr- and HI-based discharges

Microwave discharges of HBr/H₂/Ar and H/H₂/Ar with additional do biasing of the sample were used to etch InP, GaAs, and AlGaAs at temperatures between 50–250°C. The etch rates increase by factors of 3–50 and 5–9, respectively, for HBr-and HI-based discharges over this temperature range, but display non-Arrhenius behavior. The etched surfaces became very rough above 100°C for InP with either discharge chemistry due to preferential loss of P, while GaAs and AlGaAs are more tolerant of the elevated temperature etching. The near-surface electrical properties of InP are severely degraded by etch temperatures above 100°C, while extensive hydrogen in-diffusion occurs in GaAs and AlGaAs under these conditions, leading to dopant passivation which can be reversed by annealing at 400°C.     

牛血清白蛋白与甲基橙结合反应的研究

用分光光度法研究了牛血清白蛋白与甲基登在酸性溶液中的结合反应，认为两者通过非共价键结合，研究了溶液吸光 度与组分浓度的关系，对Ｓｃａｔｃｈａｒｄ模型用于自理蛋白质染色反应时存在的总是作了讨论，提出了表观结合常数的概念，推导了求算表观结合常数和最大结合数的线性回归公式。     

Structure and Electrochemical Behavior of Lithium-Manganese Spinels Doped with Chromium and Nickel

A series of compounds with the general formula LiMn_{2 - x - y} Cr _x Ni _y O₄, where x + y = 0.05, 0.5, or 1.0, is synthesized. It is shown that all these compounds are pure-phase spinels with parameter aequal to 0.8193-0.8236 nm. Doping a stoichiometric lithium-manganese spinel simultaneously with chromium and nickel makes the spinel structure stable. The initial specific capacity of a spinel depends on its doping degree. Doping LiMn₂O₄ with chromium and nickel simultaneously at an Mn : Cr : Ni ratio of 195 : 3 : 2 raises the spinel's specific capacity and reduces the cycling degradation. The change in the discharge capacity of LiMn_1.95Cr_0.03Ni_0.02O₄ electrodes cycled at 20, 0, and -14°C is determined.     

炼铝用碳阳极中碱金属氧化物作用机理的量子化学研究

本文应用CNDO/2法研究了炼铝用碳阳极中添加碱金属氧化物的吸附行为, 通过优化得到了吸附的最佳模型, 考察了吸附结合能随分子间距的变化, 进而给出了碱金属氧化物在碳阳极中作用的机理。量子化学计算结果表明: 碱金属氧化物添加到炼铝用碳阳极中起传输电子的电桥作用, 是碳阳极在空气中氧化反应以及铝电解时生成氧气的氧化反应的催化剂; 理论计算和实验结果二者吻合较好, 可以用来解释若干实验结果。     

掺杂PbO2/Ti阳极在硫酸铬电氧化过程的电极行为

PbO2/Ti 电极具有耐腐蚀性能好、导电性强、析氧过电位高等优点,已成功地应用在无机和有机化合物电解生产、环境污染控制、阴极保护以及电浮选等方面[1-3].