采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。     

示差半微分循环伏安法研究琥珀酰胆碱在水/硝基苯界面的传递行为

研究了油/水界面电解的示差半微分循环伏安行为。在0.01mol/L LiCl(w)-0.01mol/L TBATCIPB(nb)体系“电位窗”比TBATPB(nb)向正方向扩展约50mV,残余电流基本消除,使“电位窗”内的平台向左右拓宽约50mV。算得界面电容约为16μF/cm~2。考察了琥珀酰胆碱离子在w/nb界面的传递伏安特性,结果与一般半微分循环伏安法相似。但峰形改善,检测限降低一个数量级(1×10~(-6)mol/L),相对标准偏差在5％以内,可用于定量测定琥珀酰胆碱。     

Self-assembly of nanoparticles on the surface of ionic crystals: Structural properties

With a suitable combination of ligand-stabilised nanoparticle suspension and ionic salt solutions, it is possible to produce microcrystals that are coated with nanoparticles. The self-assembly process of coating microcrystals by gold nanoparticles (NP) is mediated by the crystal lattice. This is the so-called CLAMS process - a generic process for self-organisation of nanoparticles on the surface of crystals [M. Murugeshan, D. Cunningham, J.-L. Martnez-Albertos, R. Vrcelj, B.D. Moore, Chem. Commun. (2005) 2677]. We are exploring here the structural properties of these self-assembled structures by using different imaging techniques.     

Analysis of Experiments on Determining the Turbulent Mixing Constant on the Basis of Two-Dimensional Calculations

Based on numerical calculations, the experiments on mixing at the interface of gases are analyzed. Single-mode and random disturbances of the interface and superposition of random disturbances onto long-wave perturbations are considered. Possible reasons for the higher value of the mixing constant obtained in the experiments are discussed.     

Molecular weight dependence of diblock copolymer segregation at a polymer/polymer interface

Utilizing forward recoil spectrometry (FRES), we have determined the segregation isotherm which describes the interfacial excess z_i^* of diblock copolymers of poly (d₈-styrene-b-2-vinylpyridine) (dPS-PVP) at the interface between the homopolymers PS and PVP as a function of ?_∞, the volume fraction of diblock copolymer remaining in the host homopolymer. All the samples were analyzed after annealing at temperatures and times sufficient to achieve equilibrium segregation. The effect of the degree of polymerization of both the diblock copolymers and the host homopolymers on the segregation isotherm is investigated. When the degree of polymerization of the homopolymer is much larger than that of the diblock copolymer, the normalized interfacial excess (z_i^*/R_g), where R_g is the radius of gyration of an isolated block copolymer chain, is a universal function of that portion of the block copolymer chemical potential due to chain stretching. The existence of such a universal function is predicted by theory and its form is in good agreement with self-consistent mean field calculations. Using these results, one can predict important aspects of the block copolymer segregation (e.g., the saturation interfacial excess) without recourse to the time-consuming numerical calculations. © 1994 John Wiley & Sons, Inc.     

资产组合的CVaR风险的敏感度分析

基于CVaR风险计量技术，分别给出了正态和t分布情形下资产组合的CVaR值，对一般情形下风险资产组合的CVaR风险关于头寸的敏感度进行了分析，研究了其经济意义。     

等厚双层涂层材料受集中力作用的平面问题理论解

界面应力的正确评价是分析薄膜涂层材料力学特性的难题之一。利用镜像点法和Dirichlet等值性原理，本文推导了等厚双层薄膜涂层材料受表面集中力作用的平面问题理论解。该显式理论解是以固定在各镜像点上的局部坐标系下的Goursat应力函数的形式给出的。对应于高阶镜像点的应力函数，可通过递推的方法，从对应于低阶镜像点的应力函数求得，而且也易于计算机编程。随着镜像点阶数的增大，它与界面的距离也越来越大，因而相对应的应力函数对界面应力的影响越来越小。最后的算例表明，只需考虑前面有限个镜像点，便可获得足够精度的解。该理论解可作为格林函数，以求解复杂问题的理论解，也可用作边界元法的基本解，提高数值计算的精度和效率。     

陈化温度和Fe/Zr配比对SO42-/Fe2O3-ZrO2固体超强酸结构与性能的影响

用低温陈化法制备了SO42 -/Fe2 O3 ZrO2 (简称SFZ)固体超强酸催化剂 ,用红外光谱 (IR)和X光衍射(XRD)对其结构进行了表征 ,并考察了它对合成癸二酸二正丁酯的催化性能 .IR谱显示 ,低温陈化的SFZ样品在10 70cm-1处吸收峰远强于常温陈化样品 .XRD分析则显示 ,在焙烧温度为 6 5 0℃、Fe/Zr为 2∶1时 ,低温陈化的样品出现了亚稳态的ZrO2 四方晶相 .该样品在催化酯化反应中使产率达 90 %以上 ,高于常温陈化样品的 30 % .研究结果表明 :在其他条件不变时 ,低温陈化所出现的亚稳态的ZrO2 四方晶相是表面酸性和催化活性增加的微观原因     

The Ends of Manifolds with Bounded Geometry, Linear Growth and Finite Filling Area

We prove that simply connected open manifolds of bounded geometry, linear growth and sublinear filling growth (e.g. finite filling area) are simply connected at infinity.     

Scanning probe microscopy characterization of gold-chemisorbed poplar plastocyanin mutants

Two poplar plastocyanin mutants adsorbed onto gold electrodes have been characterized at single molecule level by scanning probe microscopy. Immobilization of the two redox metalloprotein mutants on Au(1 1 1) surface was achieved by either a disulphide bridge (PCSS) or a single thiol (PCSH), both the anchoring groups having been introduced by site-directed mutagenesis. Scanning tunneling microscopy (STM) and atomic force microscopy (AFM) analysis gives evidence of a stable and robust binding of both mutants to gold. The lateral dimensions, as estimated by STM, and the height above the gold substrate, as evaluated by AFM, of the two mutants well agree with crystallographic sizes. A narrower height distribution is observed for PCSS compared to PCSH, corresponding to a more homogeneous orientation of the former mutant adsorbed onto gold. Major differences between the mutants are observed by electrochemical STM. In particular, the image contrast of adsorbed PCSS is affected by tuning the external electrochemical potential to the redox levels of the mutant, consistent with some involvement of copper active site in the tunneling process. On the contrary, no contrast variation is observed in electrochemical STM of adsorbed PCSH. Moreover, scanning tunneling spectroscopy experiments reveal asymmetric I–V characteristics for single PCSS proteins, reminiscent of a rectifying-like behaviour, whereas an almost symmetric I–V relation is observed for PCSH.