Mesoporous Titanium-containing Silicas. Synthesis and geometrical characteristics

Mesoporous titanium-containing silicas with TiO₂ contents from 1 up to 70 mol% were prepared. The obtained samples have been characterized by the powder X-ray diffraction data, the diffuse reflectance infrared Fourier transform method, and nitrogen adsorption at 77 K. Specific surface area, total pore volume, distribution pore volume on pore sizes were determined from nitrogen adsorption isotherm for synthesized titanosilicas. This revised version was published online in August 2006 with corrections to the Cover Date.     

Synthesis, Structure and Optical Properties of Cerium(Ⅲ) Triphosphate CeP3O9

The single crystal and crystallized powder of triphosphate CeP3O9 have been synthesized, and the space group of CeP3O9 has been determined to be C2221 with the cell parameters ofa = 8.6059, b = 11.2437, c = 7.3518 (A), V= 711.4(3) (A)3, Z= 4, Dc = 3.520 g/cm3, F(000) = 700,R = 0.0377 and wR = 0.0930. The absorption and emission spectra have been measured, for which the strongest absorption and emission peaks are located at 280 and 320 nm, respectively. The density of state (DOS) and dielectric function have been calculated by the DFT method. The crystal is transparent provided the wavelength is larger than 341 nm, and the observed ultraviolet cut-off edge is at about 350 nm for a polycrystalline power sample. It is possible that the triphosphate CeP3O9 will become an ultraviolet emission material.     

锐钛矿型纳米TiO2介孔粉体表面织构的研究

以硫酸钛和尿素为原料,聚乙二醇-1000为空间构造剂,104℃下经尿素水解均匀沉淀法研制颗粒分散均匀、粒径可控的高热稳定性锐钛矿型纳米TiO2介孔粉体,并对其晶相、颗粒大小、比表面积、形貌和孔道结构进行了表征.结果表明,未经任何热处理的TiO2粉体即为锐钛型晶相,颗粒为均匀分散的类球型颗粒,且颗粒间形成直通型的介孔孔道,其孔径在10～30nm之间.控制焙烧温度可以达到控制颗粒大小及形貌的目的,经850℃焙烧5h的样品仍保持锐钛矿型晶相,未出现向金红石型晶相转变的迹象.     

加味异功散对脾虚小白鼠全血Zn、Fe的影响

探讨加味异功能健脾补血的生化机理、对脾虚治疗组、脾虚组和对照组小白鼠全血Zn、Fe含量进行动态观测。结果显示，加味异功散明显提高脾虚治疗组小鼠全血Zn、Fe含量。     

钙黄绿素蓝荧光法测定食品中的微量锌（Ⅱ）

本文研究了在ＣＴＭＡＢ存在下，用钙黄绿素蓝荧光法测定食品中的微量锌（Ⅱ）的实验条件。在本实验条件下，Ｚｎ（Ⅱ）与钙黄绿素蓝生成１：１的配合物使钙黄绿素蓝的荧光增强，最大激发波长和最大发射波长分别为３５３ｎｍ和４４０ｎｍ。     

Synthesis and structural, spectroscopic and magnetic studies of two new polymorphs of Mn(SeO3)·H2O

Two new manganese(II) selenite polymorphs with formula Mn(SeO₃)·H₂O have been synthesized by slow evaporation from an aqueous solution. The crystal structure of both compounds (1) and (2) have been solved from X-ray diffraction data. The structure of (1) was determined from single-crystal X-ray diffraction techniques. The compound crystallizes in the Ama2 space group, with a=5.817(1), b=13.449(3), and Z=4. The structure of (2) has been solved from X-ray powder diffraction data. This phase crystallizes in the P2₁/n space group with unit-cell parameters of a=4.921(3), b=13.121(7), , β=90.03(2)° and Z=4. Both polymorphs exhibit a layered structure formed by isolated sheets of MnO₆ octahedra and (SeO₃)²⁻ trigonal pyramids in the (010) plane. These layers, which contain one manganese and selenium atom crystallographically independent, are formed by octahedra linked between them through the selenite oxoanions. The difference of both compounds consists in the stacking of the layers along the b-axis. The IR spectra show the characteristic bands of the selenite anion. Studies of luminescence performed at 6 K and diffuse reflectance spectroscopy have been carried out for both phases. The Dq and Racah (B and C) parameters, from luminescence and diffuse reflectance spectroscopy, are Dq=705, B=750, for (1) and Dq=720, B=745, for (2). The ESR spectra of both compounds are isotropic with g-values of 1.99(1). Magnetic measurements indicate the presence of antiferromagnetic couplings in both phases. The J-exchange parameters have been estimated by fitting the experimental magnetic data to a model for square-planar lattice. The values obtained are J/k=-0.83, −0.91 K and J^′/k=-0.97, −1.20 K, for polymorphs (1) and (2), respectively.     

Visible Up-Conversion Luminescence in Ho3+: BaTiO3 Nano-Crystals Prepared by Sol Gel Technique

Visible up-conversion emissions at (435, 545, 580, 675 and 690 nm) and (437, 547 575 and 675 nm) have been observed from the sol-gel derived nano-crystalline Ho³⁺: BaTiO₃ powders and thin films respectively, under 808 nm laser diode excitation emissions. Combined with the energy level structure of Ho³⁺ ions and the kinetics of the visible emissions, the up-conversion mechanism has been analyzed and explained. The blue, green and red emissions of both samples has been attributed to the ground state-directed transition from (⁵F₁), (⁵S₂) and (⁵F₅), which are populated through excited state absorption (ESA) for 808 nm excitation. Nano-structure pure barium titanate and doped with different concentrations of Ho³⁺ ions in the from of powder and thin film have been prepared by sol-gel technique, using barium acetate (Ba(Ac)₂), and titanium butoxide (Ti(C₄H₉O)₄), as precursors. The thin films were prepared by sol-gel spin coating method. The as-grown thin films and powders were found to be amorphous, which crystallized to the tetragonal phase after heating at 750°C in air for 30 minutes. The crystallite sizes of the thin film and powder both doped with 4% Ho³⁺ ions was found to be equal to 11 and 16 nm, respectvely.     

Growth and Characterization of Crystal Nd_(0.06)Y_(0.94)Sr_6Sc(BO_3)_6

<正>The crystal of Nd0.06Y0.94Sr6Sc(BO3)6 with the dimensions up to 35 mm × 28 mm × 13 mm was grown by a top-seeded solution growth method from Li6B4O9 flux. The grown crystal was characterized by X-ray powder diffraction. The optical absorption of the crystal shows that it has a strong absorption band at 8070 A, and the absorption coefficient is 2.17cm-1 with a FWHM of 41 A, which can match with the wavelength of the diode-laser (LD) and is suitable for the LD pumping. Based on the Judd-Ofelt theory, the three parameters of line oscillator strength Ω(λ) (λ = 2, 4 and 6) of the Nd3+ion in the crystal were calculated as follows: Ω2= 1.194 × 10-20, Ω4= 4.186 × 10-20 and Ω6 = 3.351 × 10-20cm2, which are relatively larger. The results indicate that the crystal Nd0.06Y0.94Sr6Sc(BO3)6 may be a kind of high-efficient laser material for diode-pumped.     

Synthesis and characterization of metal polycarboxylates constructed from lanthanides(iii) and 1,2,4,5-benzenetetracarboxylic acid

The complexes of yttrium(III) and lanthanides(III) with 1,2,4,5-benzenetetracarboxylic acid were prepared as crystalline solids of the general formula Ln₄(C₁₀H₂O₈)₃⋅14H₂O. They are insoluble in water. On heating in air or inert gas atmosphere all compounds lose water molecules; next anhydrous compounds decompose to oxides. The yttrium complex and heavy lanthanide (from Ho to Lu) ones crystallize in monoclinic crystal system. The dehydration does not change the crystal structure of the compounds.     

醇盐法制备稀土化合物超微粉末

稀土元素具有广泛的用途,在大多数的应用中其效果都与原料的纯度、粒度、粒经分布范围等因素有关。由于超微粉末的比表面积大、化学活性高,因此可以预料,若将稀土化合物制成超微粉末,会使它的催化性能及在各种材料中的性能有明显的改变,也可使稀土有新的、更高的应用价值。