金属基上以YSZ为过渡层的YBCO薄膜的微观结构

采用透射电子显微术（ＴＥＭ），研究了用磁控溅射技术在柔性金属基体上制备的、钇稳定的ＺｒＯ２（ＹＳＺ）为过镀层的ＹＢａ２Ｃｕ３Ｏ７－ｙ（ＹＢＣＯ）薄膜的横断面结构。所得ＹＢＣＯ膜的超导临界转变温度Ｔｃ为９１Ｋ，临界电流密度Ｊｃ＝２×１０３Ａ／ｃｍ２（７７Ｋ，０Ｔ）。基体为Ｎｉ基合金（ＨａｓｔｅｌｏｙＣ）。ＹＳＺ层为致密、均匀的细晶组织，约１２μｍ厚，具有织构取向，并与基体紧密连接。ＹＢＣＯ层的厚度不均匀，约５００ｎｍ；ＹＢＣＯ／ＹＳＺ界面有时连接较差，在该界面上有杂质出现，杂质有可能引发裂纹。     

Evaluation of the sputtering rate variation in SIMS ultra‐shallow depth profiling using multiple short‐period delta layers

We have developed multiple short‐period delta layers as a reference material for SIMS ultra‐shallow depth profiling. Boron nitride delta layers and silicon spacer layers were sputter‐deposited alternately, with a silicon spacer thickness of 1–5 nm. These delta‐doped layers were used to measure the sputtering rate change in the initial stage of oxygen ion bombardment. A significant variation of sputtering rate was observed in the initial 3 nm or less. The sputtering rate in the initial 3 nm was estimated to be about four times larger than the steady‐state value for 1000 eV oxygen ions. Copyright © 2003 John Wiley & Sons, Ltd.     

Thin‐Layer Cyclic Voltammetric and Scanning Electrochemical Microscopic Study of Antioxidant Activity of Ascorbic Acid at Liquid/Liquid Interface

An electron transfer reaction between ascorbic acid (H₂A) in an aqueous solution and oxidizing agent in an organic solution immiscible with water has been studied by thin‐layer cyclic voltammetry (TLCV) for charge transfer at the interface between two immiscible electrolyte solutions (ITIES). As an antioxidant, H₂A provide electrons through the aqueous/organic interface to reduce Fc⁺ and the procedure has been proved to be a one electron process again. In this work, the first combination of TLCV and scanning electrochemical microscopy (SECM) was achieved and showed a reasonable agreement between the results from the two different approaches. Otherwise, lower concentration ratios Kr of aqueous to organic reactants was adopted, which is given as evidence to the proposed procedure of Barker.     

W／O／W乳液的渗透溶胀与夹带溶胀

研究了W/O/W乳液的溶胀,实验结果表明,渗透溶胀随内外相溶液间的渗透压差、表面活性剂及载体浓度的增大而增加,但随膜粘度的增加而降低,渗透压差较高时,水渗透的影响大于夹带的影响;膜相中含氧化合物对溶胀的影响大于含氮化合物,采用Span 80作乳化剂时,比采用E 644渗透溶胀约高6倍,夹带溶胀也较高;重复聚结再分散使夹带溶胀急剧增加,因而多级混合澄清槽对液膜操作似不适用。     

反相乳液聚合制备壳聚糖接枝共聚物及应用

以壳聚糖、丙烯酰胺、甲基丙烯酰氧乙基三甲基氯化铵为原料,硝酸铈铵为引发剂,Span-20为乳化剂,通过反相乳液聚合技术,合成壳聚糖阳离子接枝共聚物。分析讨论了乳化剂用量、引发剂浓度、油水体积比、单体配比、反应时间、反应温度对共聚物接枝率的影响,并采用正交试验方法对合成条件进行了优化。研究了其对重金属离子Cu2 、Cd2 、Zn2 的吸附性能。结果表明,在Cu2 、Cd2 、Zn2 的混合离子体系中,该共聚物对Cu2 、Zn2 有选择性吸附。     

Mass transfer to horizontal gas-generating electrodes

Mass transfer to a horizontal electrode during electrolytic evolution of oxygen and hydrogen at current densities of 100 to 10 000 A/m² is studied. The mass transfer intensity is evaluated from the diffusion layer thickness, which varies from 60 to 5 μm at such current densities. Calculations show that the decrease in the diffusion layer thickness is due to bubbles with a stationary interphase surface crossing the diffusion layer. During the hydrogen evolution, the diffusion layer thickness is nearly the same for vertical and horizontal electrodes. During the oxygen evolution, the diffusion layer is much thinner for a horizontal electrode. Additional decrease of the diffusion layer thickness during the evolution of oxygen is associated with the lesser solution density in the near-electrode layer and with its transport away by means of natural convection.     

一种纳米蜡乳液的制备及应用研究

研究了一种纳米蜡乳液的制备方法。通过测试证明该体系稳定,得到平均粒径为57.6nm大小的纳米蜡乳液,可代替各种行业中使用的普通蜡乳液,如皮革[1]、纺织[2]、造纸[3][4]等行业·     

微波辐照下无皂阳离子聚(St-MMA)高分子纳米粒子的制备和表征

讨论了微波辐照下 ,以丙酮 水为分散介质 ,利用阳离子型自由基引发剂偶氮二异丁基脒盐酸盐(AIBA)引发苯乙烯 (St)和甲基丙烯酸甲酯 (MMA)共聚 ,合成出表面带正电荷的P(St MMA)共聚物纳米粒子 ,考察了丙酮用量、单体和引发剂浓度对纳米粒子粒径、粒径分布和乳液稳定性的影响 .结果表明 ,丙酮 水的体积比由 0增加到 1 2 6∶1时 ,粒子的平均水化半径从 12 2 2 1nm降低到 2 4 6 8nm ,粒径分布变宽 ,乳液抗电解质稳定性逐渐增强 ;增加引发剂和共聚单体MMA的浓度 ,粒子的水化半径逐渐减小 ,粒径分散系数增大 .     

Multimonomer partitioning in latex systems with moderately water-soluble monomers

Simple equations describing monomer partitioning in latices during intervals 2 and 3 in emulsion polymerization with any number of low to moderately water soluble monomers were derived from the extended Morton equation by making various assumptions. It appears that it is mainly the combinatorial entropy of mixing that governs the partitioning behavior, and that other contributions to the free energy of the monomers in the polymer particles are marginal. Experimental results with styrene, methyl methacrylate, and methyl acrylate confirm the validity of the assumptions. In interval 3 of emulsion polymerization the sum of all contributions to the free energy of the monomers in the particles other than the combinatorial entropy of mixing can be taken as a constant that is dependent only on the monomer composition in the particles and independent of the degree of swelling of the particles. The only parameters one needs to know to calculate the monomer concentrations in all phases with help of the derived equations, are the saturation concentrations of each monomer in the polymer particles, and the saturation concentrations of each monomer in the aqueous phase. © 1994 John Wiley & Sons, Inc.