Efficient, protection-free Suzuki-Miyaura synthesis of ortho-biphenyltetrazoles

We describe an efficient protocol for the Suzuki-Miyaura synthesis of ortho-biphenyltetrazoles from non-protected 2-bromophenyltetrazole and arylboronic acids. The optimised conditions were achieved using [1,1′-bis(diphenylphosphino)ferrocene]dichloropalladium(II) as catalyst and Na₂CO₃ as base. A panel of structurally diverse arylboronic acids was used to demonstrate the scope of the coupling procedure.     

Microwave-assisted Suzuki-Miyaura and Heck-Mizoroki cross-coupling reactions of aryl chlorides and bromides in water using stable benzothiazole-based palladium(II) precatalysts

The catalytic activity of benzothiazole-based Pd(II)-complexes was evaluated in Suzuki-Miyaura and Heck-Mizoroki C-C cross-coupling reactions of aryl chlorides and bromides with olefins and arylboronic acids both under thermal as well as microwave irradiation conditions in water. The factors affecting the optimization of such reactions as well as the reusability of the Pd-precatalysts are studied.     

Temperature-dependent dry etching characteristics of III–V semiconductors in HBr- and HI-based discharges

Microwave discharges of HBr/H₂/Ar and H/H₂/Ar with additional do biasing of the sample were used to etch InP, GaAs, and AlGaAs at temperatures between 50–250°C. The etch rates increase by factors of 3–50 and 5–9, respectively, for HBr-and HI-based discharges over this temperature range, but display non-Arrhenius behavior. The etched surfaces became very rough above 100°C for InP with either discharge chemistry due to preferential loss of P, while GaAs and AlGaAs are more tolerant of the elevated temperature etching. The near-surface electrical properties of InP are severely degraded by etch temperatures above 100°C, while extensive hydrogen in-diffusion occurs in GaAs and AlGaAs under these conditions, leading to dopant passivation which can be reversed by annealing at 400°C.     

Synthesis of 5-arylhistidines via a Suzuki-Miyaura cross-coupling

Microwave irradiation efficiently promoted the Suzuki-Miyaura reaction of a 5-bromohistidine with various arylboronic acids in the presence of a palladium catalyst. This methodology allowed the synthesis of histidines substituted at position 5 of the imidazole ring with a phenyl, a substituted phenyl, a pyridyl or a thienyl ring. The corresponding 5-arylhistidines were obtained in moderate to good yields.     

Low-temperature synthesis of allyl dimethylamine by selective heating under microwave irradiation used for water treatment

Low-temperature synthesis of allyl dimethylamine (ADA) by selective heating under microwave irradiation (MI) used for water treatment is investigated. The effect of MI, ultrasound irradiation (UI) and conventional heating on yield of ADA, reaction time and the flocculation efficiency of polydiallyl dimethylammunion chloride (PDADMAC) prepared form ADA were studied. The results show that by selective heating at low temperature, MI not only increases yield of ADA and reduces reaction time, but also greatly enhances the flocculation efficiency of PDADMAC.     

微波干法催化芳香醛与绕丹宁及N-苯基绕丹宁的缩合反应

利用微波辐射和固体碱性载体试剂催化绕丹宁及N-苯基绕丹宁和芳香醛的缩合反应合成了14个绕丹宁衍生物并研究了影响反应的因素。     

Developing an on-line derivatization of FAs by microwave irradiation coupled to HPLC separation with UV detection

The development of analytical methods for routine simultaneous identification and quantification of carboxylic fatty acids (CFAs) are required in different fields, such as, pharmaceutical cosmetics, food products and formulations of water–microemulsion–oil systems. Determination of CFAs has been developed mainly by gas chromatography (GC). As an alternative to GC, liquid chromatography (LC) has better sensitivity and selectivity. However, most CFAs show no useful absorption in ultraviolet–violet (UV–Vis) region, one of the more used detection technique in high-performance liquid chromatography (HPLC). In order to allow the use of UV–Vis detection, the use of pre-column derivatization has been reported to increase sensitivity and selectivity. Therefore, establishment of a simpler and faster on-line method with complete separation is needed for the screening of large numbers of samples. 2,4-Dinitrophenylhydrazine (2,4-DNPH.), benzoil chloride (BC), and phenylhydrazine (PH) were used for derivatization of different FAs by microwaves radiation (MW). After the on-line derivatization, products were separated and quantified by HPLC. Reactor coil was placed inside of microwaves oven at 450 W. Parameters as flow, amount of reagents, irradiation time, and chromatographic conditions were optimized. The continuous analysis using the MW–HPLC–UV system provided high sensitivity and reduced both the amount of reagent used and the analysis times. This proposed method can be used for the routine analysis of FAs contained in water–microemulsion–oil systems, to quantify the total acid fraction in each phase.     

微波辐照下无皂阳离子聚(St-MMA)高分子纳米粒子的制备和表征

讨论了微波辐照下 ,以丙酮 水为分散介质 ,利用阳离子型自由基引发剂偶氮二异丁基脒盐酸盐(AIBA)引发苯乙烯 (St)和甲基丙烯酸甲酯 (MMA)共聚 ,合成出表面带正电荷的P(St MMA)共聚物纳米粒子 ,考察了丙酮用量、单体和引发剂浓度对纳米粒子粒径、粒径分布和乳液稳定性的影响 .结果表明 ,丙酮 水的体积比由 0增加到 1 2 6∶1时 ,粒子的平均水化半径从 12 2 2 1nm降低到 2 4 6 8nm ,粒径分布变宽 ,乳液抗电解质稳定性逐渐增强 ;增加引发剂和共聚单体MMA的浓度 ,粒子的水化半径逐渐减小 ,粒径分散系数增大 .     

Thermal and microwave-assisted N-formylation using solid-supported reagents

A rapid and easy route to formamides by microwave assisted N-formylation of primary and secondary amines is described. Using an insoluble polymer or an inorganic solid-supported reagent as a formylating agent, microwave irradiation furnished the corresponding formamides in high yields, with reduced reaction time and solvent volume over the conventional approach.     

微波消化技术在生物微量元素测定中的应用

用微波消化技术消化了多种食物样品．与传统的干、湿消化法相比，微波消化更加简单、快速、节省、沾污少、损失少、环境污染少．用原子吸收测定样品中的Ｆｅ，Ｃ．Ｖ＜２％，加标回收率为９８％～１００％，测定美国生物标准物质牛肝中的Ｆｅ的相对误差为０．３％，结果令人满意．