Effects of aldehyde or dipyrromethane substituents on the reaction course leading to meso-substituted porphyrins

To better understand the effects of diverse substituents on reactions leading to porphyrins, pyrrole+aldehyde condensations and related reactions of dipyrromethanes were examined. The course of pyrrole+aldehyde condensations was investigated by monitoring the yield of porphyrin (by UV-Vis spectroscopy), reaction of aldehyde (by TLC), and changes in the composition of oligomers (by laser desorption mass spectrometry). Reaction reversibility was examined via exchange experiments. Reversibility of reactions leading to porphyrin was further probed with studies of dipyrromethanes. The reaction course was found to depend on the nature of the substituent and the acid catalyst. Alkyl or electron-donating substituents displayed levels of reversibility (exchange/scrambling) on par or greater than that of the phenyl substituent, whereas electron-withdrawing or sterically bulky substituents exhibited little to no reversibility. The results obtained provide insight into the electronic and steric effects of different substituents and should facilitate the design of synthetic plans for preparing porphyrinic macrocycles.     

On-line cysteine modification for protein analysis: new probes for electrochemical tagging nanospray mass spectrometry

A series of electrogenerated selective electrophiles based on substituted benzoquinones has been characterized as tags for l-cysteine and cysteine residues in proteins. The electrophiles are generated electrochemically from the corresponding hydroquinones. It is shown from mass spectrometry analysis that the electrogenerated benzoquinone can tag the biomolecules. The rate constants pertaining to the addition of l-cysteine onto the electrogenerated benzoquinones have been determined using electrochemical techniques. The substitution patterns have been unraveled leading to the assessment of site-specific rate constants. It is shown that the rate constants are primarily dependent on the electronic nature of the substituents as expressed by the Hammett substitution constant. The apparent tagging yields observed for l-cysteine in nanospray mass spectrometry experiments do not correspond to the yields expected from the electrochemical study, as the ionisation efficiencies are highly dependent on the tag. Finally, the on-line tagging has been tested using β-lactoglobulin A and myoglobin. Based on these results, it is concluded that the tagging reaction is selective towards cysteine when it takes place in the nanospray interface. The results show that the methodology presented can be used for a rapid characterization and identification of reactive sites in biomolecules.     

Cavitation mechanism in cyanobacterial growth inhibition by ultrasonic irradiation

To prevent cyanobacterial bloom in eutrophic water by ultrasonic method, ultrasonic irradiations with different parameters were tested to inhibit Spirulina platensis from growth. The experimental result based on cyanobacterial growth, chlorophyll a and photosynthetic activity showed that, the ultrasonic irradiation inhibited cyanobacterial proliferation effectively, furthermore the inhibition effectiveness increased in the order: 200 kHz>1.7 MHz>20 kHz and became saturated with the increased power. The inhibition mechanism can be mainly attributed to the mechanical damage to the cell structures caused by ultrasonic cavitation, which was confirmed by light microscopy and differential interference microscopy. The optimal frequency of 200 kHz in cavition and sonochemistry was also most effective in cyanobacterial growth inhibition. The higher frequency of 1.7 MHz is weaker than 20 kHz in cavitation, but has more effective inhibition because it is nearer to the resonance frequency of gas vesicle. The inhibition saturation with ultrasonic power was due to the ultrasonic attenuation induced by the acoustic shielding of bubbles enclosing the radiate surface of transducer.     

Optimization of Mass Transfer Processes in the Zone of the Air Electrode of a Fuel Cell with a Solid Polymer Electrolyte

A two-dimensional mathematical model for the transport of reactants in a fuel cell with a solid polymer electrolyte is developed. The model is used for analyzing spatial distributions of the concentration of reactants and current density over the cell. The effect of the catalytic-layer activity, reactant speed, bipolar-plate geometry, thickness and porosity of current collector and/or gas-diffusion sublayer, and the reaction mixture composition on the fuel cell efficiency is estimated theoretically and experimentally.     

Determination of residual monomers in acrylate dispersions by gas chromatography

The content of residual monomers is one of the most important characteristics of polymer dispersions. As a result of the similar physicochemical parameters of ethyl acrylate and methyl methacrylate, it is very difficult to determine the residual monomers in acrylate dispersions obtained by emulsion polymerization of both monomers. Gas chromatography with capillary columns, however, permits separation of these monomers and their quantitative determination in acrylate dispersions.     

Shell effects in the symmetric-modal fission of pre-actinide nuclei

Mass distributions of fragments in the low-energy fission of nuclei from ¹⁸⁷Ir to ²¹³At have been analysed. This analysis has shown that shell effects in symmetric-mode fragment mass yields from the fission of pre-actinide nuclei could be described if one assumes the existence of two strongly deformed neutron shells in the arising fragments with neutron numbers N₁ ≈ 52 and N₂ ≈ 68. A new method has been proposed for quantitatively describing the mass distributions of the symmetric fission mode for pre-actinides with A ≈ 180–220.     

A highly selective solid phase extraction sorbent for pre-concentration of sameridine made by molecular imprinting

Summary A novel approach to solid phase extraction, based on the use of a highly selective molecularly imprinted polymer, is presented. The versatility of this type of sorbent for solid phase extraction was demonstrated in a model batch-wise pre-concentration of sameridine prior to gas chromatography. Problems associated with leakage of remaining imprint molecules during the desorption phase could be eliminated by the use of a close structural analogue of sameridine as the imprint species. It was found that a major benefit of the imprinted polymer was its specificity, which lead to distinctly cleaner chromatographic traces and ability to improve sensitivity by extracting sameridine from larger sample volumes.     

Forced-air precooling of spherical foods in bulk: A parametric study

In this paper, a mathematical model for forced-air precooling of spherical food products in bulk is developed. The foods are arranged in horizontal layers stacked one above the other to form a rectangular parallelepiped with a vertical gap in between the product layers. The foods are cooled by chilled air blown along the height of the package. The governing equations for the conduction heat transfer in the foods, simultaneous heat and mass transfer at the food-air interface and in the air stream are solved numerically using finite-difference methods. A comprehensive numerical study is performed by varying the process parameters over a wide range. Typical results showing the variation of moist air properties along the height of the package and the effect of each parameter on the process time are presented. The ranges of parameters for advantageous operation of the precooling system are identified. Correlations are obtained for the process time based on the product center and mass-averaged temperatures in terms of process parameters.     

Temperature Dependence of InSb Reflectivity in the Far Infrared: Determination of the Electron Effective Mass

We measured the dependence of the reflectivity of InSb crystals upon temperature in the submillimeter region using monochromatic radiation from an optically pumped far infrared (FIR) laser. The measures allowed us to determine the value of the electron effective mass at low temperatures with radiations of different frequencies. Our measurements extend the results obtained recently on pure crystals with magneto-optical methods to the low temperatures region where only old measures were available.