修饰聚合物液-固亲和萃取体系纯化大豆中的组氨酸

聚乙二醇(PEG)6000经亚氨基二乙酸(IDA)修饰后和CuSO4反应,形成PEG修饰聚合物PEG-(IDA-Cu)2 ,与吐温80、磷酸盐混合,构成液-固亲和萃取体系,直接从大豆蛋白匀浆中提取氨基酸.选定萃取条件为磷酸盐摩尔比n(K2HPO4)∶n(NaH2PO4)为4.8∶1,体系pH值 7.70,总盐浓度为1.60 mol·L-1;吐温80的体积分数为10.5%.结果表明该体系对大豆蛋白匀浆中氨基酸的二次萃取率为66.5%,用离子交换技术后继处理,得纯度较高的组氨酸.     

Hydrogel‐like elastic membrane consisting of semi‐interpenetrating polymer networks based on a phosphorylcholine polymer and a segmented polyurethane

To obtain a hydrogel‐like elastic membrane, we prepared semi‐interpenetrating polymer networks (IPNs) by the radical polymerization of methacrylates such as 2‐methacryloyloxyethyl phosphorylcholine (MPC), 2‐hydroxyethylmethacrylate, and triethyleneglycol dimethacrylate diffused into segmented polyurethane (SPU) membranes swollen with a monomer mixture. The values of Young's modulus for the hydrated semi‐IPN membranes were less than that for an SPU membrane because of higher hydration, but they were much higher than that for a hydrated MPC polymer gel (non‐SPU). According to a thermal analysis, the MPC polymer influenced the segment association of SPU. The diffusion coefficient of 8‐anilino‐1‐naphthalenesulfonic acid sodium salt from the semi‐IPN membrane could be controlled with different MPC unit concentrations in the membrane, and it was about 7 × 10² times higher than that of the SPU membrane. Fibroblast cell adhesion on the semi‐IPN membrane was effectively reduced by the MPC units. We concluded that semi‐IPNs composed of the MPC polymer and SPU may be novel polymer materials possessing attractive mechanical, diffusive‐release, and nonbiofouling properties. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 68–75, 2003     

Crystallographic report: Crystal structure of a one‐dimensional zinc(II) coordination polymer containing 4,4′‐biphenyldicarboxylate hemihydrate

A one‐dimensional zinc(II) coordination polymer has been constructed from zinc(II), 4,4′‐biphenyldicarboxylate and pyridine in which each zinc(II) atom is coordinated by two pyridine ligands and two monodentate 4,4′‐biphenyldicarboxylate ligands that define a distorted tetrahedral geometry. Copyright © 2003 John Wiley & Sons, Ltd.     

超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯复合材料的输运性质

采用热压法获得了具有不同混合比例的超导氧化物La1.85Sr0.15CuO4/超高分子量聚乙烯导电复合材料,并利用x射线衍射、扫描电子显微镜和标准四引线方法对复合材料的结构和低温电输运性质进行测量.实验结果显示,超导氧化物La1.85Sr0.15CuO4颗粒随机分布在聚合物本体中,相互间没有连接构成网络结构.在正常态下,复合材料的电阻-温度变化曲线给出类半导体行为.但对应于超导氧化物La1.85Sr0.15CuO4的超导转变温度Tc处,复合材料的电阻-温度变化曲线出现了极小值.室温下电阻率ρ随外加电场强度E的变化曲线测量结果表明,ρ-E曲线为一线形关系,随着电场强度E增加,电阻率ρ下降.文中对可能存在的导电机制进行分析,结果表明隧道贯穿模型可以很好地解释复合材料的导电机制.另外,外加电场强度E对复合材料的电输运特性有明显的影响.     

Photo-orientation at liquid crystal—polymer interfaces

It is suggested that liquid crystal—polymer interfaces are coupled systems, in which the components mutually influence the orientational state of each other. The photo-orientation process at liquid crystal-polymer interfaces provides a striking example of such a coupling. Experiments show that the anisotropic structure generated by polarised light at a polymer surface is strongly affected by the phase of the liquid crystal covering the polymer. Photo-orientation is significantly more efficient when the liquid crystal is in the isotropic phase than when it exhibits orientational order. The observations are interpreted by assuming that in the smectic and nematic phases the liquid crystal stabilises to a large extent polymer chain-segments aligned parallel to the director, while it blocks the photo-induced formation of chain-segments in the perpendicular direction. Other situations, in which the coupling between the liquid crystal and the polymer can be important, are also discussed briefly.     

TG of polytetrahydrofuran/ isophoronediisocyanate reaction products

TG, swelling, and viscometric studies are presented for the residues, PTHF/IPDI polymer networks, and the extracts, the linear polymers and unreacted IPDI, after Soxhlet extraction of PTHF/IPDI reaction products. The products are obtained by reacting PTHF with 650, 1400, (2×650+1×2900), or 2900 of molecular mass with IPDI at various concentrations in bulk. The results on the swelling and the viscosity experiments suggest that the PTHF/IPDI reaction products have a usual expectable structure. All the TG curves are a double stage curve. The initial stage and the last stage seem to reflect decomposition of PTHF chains and vaporization of the remainder, IPDI, respectively. These are analyzed by a trial-and-error construction, supposing double event behavior. The values of ratio of mass loss associated with the initial event, W0₁, to the mass loss associated with the last event, W0₂, are smaller than the expectable those. This suggests that Event 2 involves vaporization of the decomposition products of PTHF moieties bonded to IPDI in addition to vaporization of IPDI. This revised version was published online in July 2006 with corrections to the Cover Date.     

Reagent concentration effects in the REM resin solid phase synthesis of tertiary amines

The use of reagent concentration has resulted in increased rates for all stages of the REM resin synthesis of tertiary amines. These increases in rate translate into faster reaction times, higher yields and lower reagent consumption. Of the methods examined, the most successful was the use of perfluorous solvents, either alone or with a small amount of organic co-solvent.     

Synthesis and characterization of 6‐ and 12‐arm star polymers by nitroxide‐mediated radical polymerization of St and MA from dendritic TIPNO‐based hexafunctional and dodecafunctional macroinitiators

Dendritic multifunctional macroinitiators having six and 12 TIPNO‐based alkoxyamines, TIPNO‐6 and TIPNO‐12 , were synthesized and used in the living radical polymerization of styrene (St), methyl acrylate (MA), N,N‐dimethylacrylamide (DMAAm), and isoprene (IP). The polymerizations of St initiated with TIPNO‐6 gave 6‐arm star polymers with narrow polydispersities of 1.14–1.18. In the polymerizations of MA initiated with TIPNO‐6 and TIPNO‐12 , the influences of added TIPNO on the polydispersity indexes (PDIs) of the resulting star polymers were first investigated, and this led to the successful formation of poly(MA) star polymers with narrow polydispersities (1.10–1.18). Moreover, the polymerizations of DMAAm and IP from TIPNO‐6 in the presence or absence of TIPNO were briefly investigated. The benzyl ether bonds of the poly(St) and poly(MA) star polymers were cleaved by treating with Me₃SiI or Pd/C, and the resulting arm's parts were analyzed with SEC. The PDIs of the resulting arm parts were low (1.19–1.23), and the M_ns agreed with the M_n,theor, indicating that the poly(St) and poly(MA) star polymers had well‐controlled arms. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4364–4376, 2007     

Weak Attractive Ligand–Polymer and Related Interactions in Catalysis and Reactivity: Impact,Applications, and Modeling

The notion of weak attractive ligand–polymer interactions is introduced, and its potential application, importance, and conceptual links with “cooperative” ligand–substrate interactions are discussed. Synthetic models of weak attractive ligand–polymer interactions are described, in which intramolecular weak C? H???F? C interactions (the existence of which remains contentious) have been detected by NMR spectroscopy and neutron and X‐ray diffraction experiments. These C? H???F? C interactions carry important implications for the design of catalysts for olefin polymerization, because they provide support for the practical feasibility of ortho‐F???H_β ligand–polymer contacts proposed for living Group 4 fluorinated phenoxyimine catalysts. The notion of weak attractive noncovalent interactions between an “active” ligand and the growing polymer chain is a novel concept in polyolefin catalysis.     

A bicontinuous structure in some systems with cubic mesophases

A cubic structure of polymer colloid complexes is studied. The technique of the research includes i) an analysis of well-known literature SAXS data; on this basis, ii) constructing a simple model to estimate geometric structure parameters and to obtain a simulated scattering curve; and iii) comparing the model with the real structure obtained from the SAXS data, using the reconstruction of electron density distribution. A bicontinuous structure in cubic mesophases is formed. Dedicated to the memory of Alexander T. Dembo