测接触角法确定偶联剂的最佳用量

偶联剂是一类能在无机填料和聚合物基材之间形成“分子桥”、改善两者之间相容性或提高两者之间相互作用能力的化合物。将经偶联剂改性的无机填料填充到聚合物中可以制得成本低、性能好的复合材料。由于偶联剂用量多少将对复合材料的性能产生较大影响,因此建立一种准确、简便地确定偶联剂最佳用量的方法有着十分重要的理论和实际应用意义。     

Photobioelectronic studies with thylakoid membranes

The research described in this paper presents a method for chemically modifying the surface of plant photosynthetic membranes in such a way that electrical contact can be made. Colloidal platinum was prepared, precipitated directly onto thylakoid membranes from aqueous solution, and entrapped on fiberglass filter paper. This composition of matter was capable of sustained simultaneous photoevolution of hydrogen and oxygen when irradiated at any wavelength (400–700 nm) in the chlorophyll absorption spectrum. Experimental data support the interpretation that part of the platinum metal catalyst is precipitated adjacent to the photosystem-I reduction site of photosynthesis and that electron transfer occurs across the interface between photosystem I and the catalyst. When contacted with metal electrodes, the thylakoid-platinum combination was capable of generating a sustained flow of current through an external load resistor. Procedures for preparing this material and experimental data on its catalytic and electronic properties are presented. Also presented is an analysis of the flow of photocurrent in terms of the interfacial electron transfer reactions that occur at the interfaces of the components of the assembly.     

Fermi and Coulomb correlations in the 21 S state of the helium isoelectronic sequence

The Fermi and Coulomb holes of the 2¹ S state of the helium isoelectronic sequence are investigated. Several interesting differences between the results obtained and those which might be expected on the basis of the corresponding 2³ S state are pointed out and discussed.     

B108中温变换催化剂宏观动力学的研究

常压下以内循环无梯度反应器研究了B108铁基中温变换催化剂上水煤气变换反应宏观动力学。测定了反应速率,并用马夸特非线性参数估值法获得了幂函数宏观动力学模型r_s=37.67exp(-43982/RT)y_(CO)~(0.7552)y_(H_2O)~(-0.0367)Y_(CO_2)~(-0.4874)y_(H_2)(1-β)根据方差分析和残差分析,证实模型是高度显著的。由实验数据计算出相应反应条件下的效率因子。内扩散对原粒度B108催化剂上的反应具有严重影响。模型用于工业变换炉催化剂的用量核算,模型值与实际值符合良好。     

Electrokinetic and contact angle measurements of grafted carbon fibers

 The grafting method that has successfully been applied to methacrylic acid and liquid crystalline monomers was expanded to prepare amphoteric carbon fiber surfaces using 2-(N,N-dimethylamino)ethyl methacrylate as monomer. The obtained carbon fiber surfaces were characterized by contact angle and ζ-potential measurements. The expected basic behavior was not observed, instead an amphoteric character of the modified carbon fiber surface was found. The fiber surfaces display a basic character in the acidic pH-range, while they are acidic in the alkaline part of the pH-scale. An important influence is derived from the amount of initiator used to graft the monomers onto the fibers. The smaller the initiator concen-tration used during polymerization, the larger the amount of amino functionalities introduced to the carbon fiber surface. The wetting behavior versus water depends on the overall conformation of the immobilized polymer. During immersion into water the polymer acts hydrophobic, while during emersion, a hydrophilic character is observed, probably derived from conformational changes and swelling during the contact angle measure-ments in water. Received: 9 June 1998 Accepted: 13 August 1998     

Manifestation of diamagnetic chemical shifts of proton NMR signals by an anisotropic shielding effect of nitrate anions

A remarkable upfield shift of the py_α protons of complexed 2,2′-bipyridine in [cis-Pd(bpy)(NO₃)₂] is observed which is considered to originate from the anisotropic influence of suitably positioned coordinated nitrate anions around the Pd(II) centre of the molecule. A typical complexation-induced downfield shift is observed for the NH₂ protons in [cis-Pd(en)(NO₃)₂] where ‘en’ stands for ethylenediamine.     

负载型无铬超细铁基变换催化剂的制备和催化性能

 以镁铝尖晶石为载体，以过渡金属氧化物为助剂，用吸附γ－Fe2O3胶体法制备了负载型无铬铁基变换催化剂．TEM，XRD，BET和活性测试结果表明，采用胶体负载法制备的变换催化剂，其活性组分Fe3O4以分立的超细微颗粒分布在镁铝尖晶石载体表面上，颗粒之间存在一定的间隔．过渡金属氧化物NiO或V2O5能够进入Fe3O4晶格形成固溶体，起到代替氧化铬的作用，提高催化活性．负载型催化剂FeNi／MgAl2O4（m（NiO）／m（Fe2O3）＝3％）在汽／气比为1和空速为2000h－1的反应条件下，CO转化率在400和350℃时分别为95％和80％；在高空速和低汽／气比条件下也具有很好的催化性能．稳定性实验结果表明，该催化剂 具有良好的热稳定性和一定的抗硫能力．与非负载型催化剂相比，负载型催化剂具有更为优越的催化性能．     

制备参数对Au／Fe2O3催化剂水煤气变换性能的影响

 采用共沉淀法制备了Au／Fe2O3催化剂，并系统地考察了制备参数对其催化WGS性能的影响．通过BET，XRD，XRF，H2－TPR和HRTEM等表征手段，初步考察了Au／Fe2O3催化剂具有高催化活性的原因．结果表明，金负载量、沉淀剂种类、沉淀方式、沉淀pH值、焙烧气氛和焙烧温度对Au／Fe2O3催化剂的催化性能均具有较大的影响．Au／Fe2O3催化剂的低温高活性是纳米Au与Fe3O4协同作用的结果；Au／Fe2O3催化剂的高温活性是由于活性相Fe3O4起主要作用的结果．纳米Au粒子的烧结会降低其催化活性．