Sample evaporation in conventional split/splitless GC injectors. Part 3: Retaining the liquid in the vaporizing chamber

As most sample liquids tend to pass through an empty injector insert at a speed which is too high to enable complete evaporation, movement of the liquid must be arrested before it reaches the column entrance. Stopping the liquid means deposition on to a surface; this, however, is possible only after the temperature of the surface has been cooled to (or below) the boiling point of the liquid (solvent). The performance of different means of stopping the liquid has been tested visually (by the method described in Part 2). Baffles on the wall of the injector insert had hardly any effect on evaporation: the band of liquid leaving the syringe needle performed a perfect slalorn around them. The inverted cup proved more efficient, but the best performance was obtained from a light plug of glass wool: owing to its low thermal mass, the first fibers to be met by the liquid are immediately cooled to the solvent boiling point, allowing the liquid to wet it. The sample liquid is sucked up by the glass wool, from where the sample evaporates relatively slowly, often over a period of several seconds.     

Characterization of gem-difluoropropargyl synthons through HF loss from protonated molecules in methane chemical ionization mass spectra

Electron impact and methane chemical ionization mass spectra were obtained following gas chromatography/mass spectrometry for several gem-difluoropropargyl compounds, which had been synthesized as potential intermediates for synthesis of gem-difluoromethylene-containing C-3 acetylenes. EI spectra were variable with respect to the presentation of molecular ions, depending on substituent functional groups present. Methane-CI spectra were characterized by loss of 19 mass units from molecular weight with all compounds examined. These [M − 19]⁺ ions often presented as base peaks of the CI spectra, and were more reliably present and abundant than [M + 1]⁺ ions for these compounds. These ions could have been formed by elimination of HF from the protonated molecules under conditions of methane chemical ionization.     

High-sensitivity analyses of metabolites in biological samples by capillary electrophoresis using dynamic pH junction-sweeping

Emerging fields of biochemical research, such as metabolomics, present challenges to current separation technologies because of the large number of metabolites present in a cell and their often low (submicromolar) concentration. Although capillary electrophoresis (CE) holds great promise as the method of choice for high-resolution separations of biological samples, it suffers from poor concentration sensitivity, especially with the use of UV detection. In CE, sweeping and dynamic pH junction represent two complementary on-line focusing techniques that have been used for sensitivity enhancement of hydrophobic and weakly acidic analytes, respectively. However, the application of either the sweeping or dynamic pH junction technique alone might, in some cases, be less effective for the analysis of certain sample mixtures. Recent work in the development of a hyphenated dynamic pH junction-sweeping technique is presented as an effective on-line method of preconcentration suitable for both hydrophilic (anionic) and hydrophobic (neutral) analytes. Sensitive analyses of flavin metabolites by CE with laser-induced fluorescence (LIF) detection is demonstrated in various biological matrixes, including cell extracts of Bacillus subtilis, pooled human plasma, as well as heat-deproteinized flavoenzymes. Enhanced analyte band narrowing and improved sensitivity is achieved for flavins using dynamic pH junction-sweeping compared to either sweeping or dynamic pH junction alone. This results in over a 1200-fold improvement in sensitivity relative to conventional injection methods, giving a limit of detection (LOD, defined as S/N = 3) of about 4.0 x 10(-12) M. Strategies for sensitive and more comprehensive analyses of other cell metabolites, including nucleotides, coenzymes, and steroids, are also discussed when using on-line focusing techniques in conjunction with multiplexed CE and UV detection.     

近红外(NIRS)技术分析小样品油菜籽芥酸和含油量的应用研究

以完整油菜籽为样品,采用旋转杯和安培瓶两种样品杯、每种样品分为4×2种不同样品量并通过不同光谱预处理来优化油菜籽芥酸和含油量的近红外分析模型。结果表明:油菜籽各小样品含油量模型的决定系数(R2)从93.93%到96.93%不等,均方差(RMSECV)从0.56到0.79不等;油菜籽各小样品芥酸模型的决定系数(R2)从96.91%到98.42%不等,均方差(RMSECV)从1.73到2.43不等。随着样品量的逐渐增加,油菜籽芥酸和含油量不同样品杯模型各参数逐渐有所优化;同一样品厚度时,油菜小样品芥酸和含油量的旋转样品杯模型各参数均略优于安培瓶样品模型;不同样品量的NIRS模型,W3和W4差异不大,依次优于W2和W1。最小样品量AW1为0.3g。优化油菜小样品模型时,应该选择全部的预处理方法,根据优化结果选择最佳模型。外部检验结果表明:不同重量小样品(W1/0.3g、W2/1.0g、W3/2.0g和W4/4.0g)模型之间及其与标准化学值之间在0.01水平上差异不显著,说明W1和W2小样品模型同样可应用于油菜品质育种材料的分析选择。     

Ethanol production from steam-explosion pretreated wheat straw

Bioconversion of cereal straw to bioethanol is becoming an attractive alternative to conventional fuel ethanol production from grains. In this work, the best operational conditions for steam-explosion pretreatment of wheat straw for ethanol production by a simultaneous saccharification and fermentation process were studied, using diluted acid [H₂SO₄ 0.9% (w/w)] and water as preimpregnation agents. Acid-or water-impregnated biomass was steam-exploded at different temperatures (160–200°C) and residence times (5, 10, and 20 min). Composition of solid and filtrate obtained after pretreatment, enzymatic digestibility and ethanol production of pretreated wheat straw at different experimental conditions was analyzed. The best pretreatment conditions to obtain high conversion yield to ethanol (approx 80% of theoretical) of cellulose-rich residue after steam-explosion were 190°C and 10 min or 200°C and 5 min, in acid-impregnated straw. However, 180°C for 10 min in acid-impregnated biomass provided the highest ethanol yield referred to raw material (140 L/t wheat straw), and sugars recovery yield in the filtrate (300 g/kg wheat straw).     

Practical capillary gas chromatography—a systematic approach

Capillary gc is now rapidly expanding. Naturally, initiation is most often attempted on the basis of the experience acquired with packed columns. However, such an extrapolation is successful only if a number of essential peculiarities of capillary gc are considered. Based on practical examples this paper discusses six essential details: 1) design and maintenance of the gas flow paths, 2) the greatly increased importance of sampling technique, which should not be confined just to stream splitting, 3) the problems in quantitative analysis arising from small sample size, 4) specific sources of trouble related to small amounts of liquid phase, 5) specific arguments for the choice of the carrier gas, clearly pointing to hydrogen as the ideal carrier and, 6) the different way to approach column production. Figures for all selected examples are given.     

XRF分析铁矿粉的标准选择判据研究和应用

本文对ＸＲＦ法分析铁矿的基体校正元素进行了研究，并建立了标准选择判据，编制的计算软件可以自动地从大量标样中选择适合该样品分析的标准。该法可用于粉末压片制样的分析，方法快速，准确度和精密度均符合生产要求。     

MEASUREMENTS OF CHAIN INTERPENETRATION OF POLYMER GLASSES

The concept of entanglement provides the basis of our current understanding of the flow behavior of polymer melts, Current techniques developed to investigate the degree of interpenetration of polymer chains only provide indirectly the information of the degree of entanglement in a relatively large scale （several to tens of nanometer）. In this article, we report ^1H-NMR spectroscopy with dipolar filters under fast magic angle spinning for probing chain interpenetration of polymer glasses at the molecular level.     

Novel enrofloxacin imprinted polymer applied to the solid-phase extraction of fluorinated quinolones from urine and tissue samples

A new molecularly imprinted polymer, prepared following a non-covalent approach, was synthesised using enrofloxacin as a template molecule. The imprinting effect of the polymer was verified by chromatographic evaluation and, interestingly, this evaluation also revealed that the imprinted polymer showed a high degree of cross-reactivity for ciprofloxacin, the major metabolite of enrofloxacin. The molecularly imprinted polymer was then applied as a selective sorbent in a two-step solid-phase extraction method focussing upon complex biological matrices, specifically human urine and pig liver. This two-step solid-phase extraction protocol, in which a commercial Oasis HLB cartridge and a molecularly imprinted solid-phase extraction cartridge were combined, allowed enrofloxacin and ciprofloxacin to be determined by liquid chromatography coupled to a UV detector at levels below the maximum residue limits established by the European Union. The quantification and detection limits in tissue samples of enrofloxacin and ciprofloxacin were established at 50 μg kg⁻¹ and 30 μg kg⁻¹, respectively.     

固相萃取搅拌棒萃取-气相色谱分析海水中的多环芳烃

利用固相萃取搅拌棒（SBSE）萃取海水中的多环芳烃，然后用热解吸脱附-气相色谱分析。研究了萃取时间、添加NaCl浓度对萃取效率的影响。实验结果表明，SBSE方法对16种多环芳烃的萃取回收率分别在33．5％～122．4％之间；对标准样品的检出限为2．74-13．5ng／L；方法RSD为3．8％～13．1％。用此方法测定了大连海岸海水中的多环芳烃含量。